System Mode.
❍Press scroll until TYP is displayed.
❍Press increase and select HE.
❍Press scroll until GER is displayed.
❍Press increase and select A
❍To save either turn the radio off or press scroll and increase at the same time.
●Now we will set options in Function Mode.
❍Turn the radio on if it is not already on.
❍Press scroll and increase. You are now in function mode.
❍The servo reversing menu (REV.NORM) should be visible. If not press scroll until it is.
❍Once you reach the reversing menu, use the channel key to scroll through each channel and set
them to the following.
■AIL=REV
■ELE=NORM
■RUD=NORM
■GER=NORM
■PIT=NORM
■THR=NORM
❍Press scroll until TRV ADJ. is visible.
❍Press scroll and select the GER channel.
❍Place the Aileron DR switch to 0. Use the decrease button to set +45%.
❍Press scroll until HLD is visible.
❍Use decrease and set to -1%.
❍Press scroll until you reach the Pitch Curve Menu. Use the channel button to select PLN, P2N and
PHN and set the following values using increase and decrease.
■PLN=35%
■P2N=50%
■PHN=100%
❍Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLS, P2S and
PHS and set the following values using increase and decrease.
■PLS=0%
■P2S=50%
■PHS=100%
❍Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLH, P2H and
PHH and set the following values using increase and decrease.
■PLH=0%
■P2H=50%
■PHH=100%
❍Press scroll to advance to the Throttle Curve Menu. Use the channel button select TLN, T2N and
THN and set the following values using increase and decrease.
■TLN=0%
■T2N=65%
■THN=100%
❍Press scroll to advance to the Throttel Curve Menu. Use the channel button select TLS, T2S and
THS and set the following values using increase and decrease.
■TLS=100%
■T2S=80%
■THS=100%
❍Press scroll until your reach the CCPM Menu. "mix CCP OF" is displayed.
❍Press increase to enable CCPM. Display will change from CCP OF to CP2.
❍Use the channel button to select CP2, CP3 and CP6. All three should have a value of 60% by
default. Use increase and decrease to set the following values.
■CP2 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees left and right] )
■CP3 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees forward and aft] )
■CP6 = 60%
■CP2 and CP3 adjusts the cyclic travel of your swashplate (forward, back, left, right)
■CP6 adjust the total up and down travel of the swashplate (pitch of rotor blades)
