Aleratec 1:1 HDD Cruiser Manuel utilisateur
®
USER GUIDE
Aleratec
1:1 HDD Cruiser™
Part No. 350103
www.aleratec.com
Copyright/Model Identification
The content of this manual is for informational purposes only and is subject to
change without notice.
This manual is copyright with all rights reserved. Under copyright laws, this manual
and the software described within may not be copied, except in the normal use of the
product(s) described within or to make a backup copy.
Copyright© 2010
Aleratec, Inc.
9851 Owensmouth Avenue
Chatsworth, CA 91311 U.S.A.
www.aleratec.com
Aleratec® is a registered trademark and 1:1 HDD Cruiser™ is a trademark of Aleratec, Inc.
Please record the following information to help expedite any warranty claim:
Model No. _________________________ Serial No.________________________
Date Purchased _______________________________________________________
Place of Purchase _____________________________________________________
www.aleratec.com
Radio/TV Interference Statement
The equipment described in this guide emits radio frequency energy. If it is
not installed in accordance with the manufacturer’s instructions, it may cause
interference with radio or television reception.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instruction manual, this equipment may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be veried
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an electrical outlet on a circuit that is different from
the circuit to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
This equipment has been certied to comply with the limits for a Class B computing
device, pursuant to FCC Rules. In order to maintain compliance with FCC
regulations, shielded cables must be used with this equipment. Operation with non-
approved equipment or unshielded cables is likely to result in interference to radio
and TV reception. The user is cautioned that changes and/or modications made to
this equipment, without the approval of manufacturer, could void the user’s authority
to operate this equipment.
www.aleratec.com
Safety Regulations
WARNING
To prevent re or shock hazard, do not expose the unit
to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to authorized personnel only.
www.aleratec.com
Table of Contents
Introduction ...................................................................................................1
Product Features ...................................................................................................1
Key Items .............................................................................................................2
1:1 HDD Cruiser Front Panel ..............................................................................3
1:1 HDD Cruiser Copy Controller Display Panel and Buttons ...........................4
Precautions ...................................................................................................5
Installation ............................................................................................................5
Choose a Good Location ......................................................................................5
Operation ..............................................................................................................5
Transportation ......................................................................................................5
Overview ........................................................................................................6
Power Up Sequence .............................................................................................6
Main Menu ...........................................................................................................7
Subfunctions ........................................................................................................8
Using the 1:1 HDD Cruiser ........................................................................10
Loading the Hard Drives ....................................................................................10
Removing Hard Drives ......................................................................................11
Main Menu .........................................................................................................12
Copy HDD .................................................................................................12
Compare HDD ...........................................................................................14
PreScan Source ..........................................................................................15
ReScan BUS...............................................................................................16
Source HDD Size .......................................................................................17
Secure Erase ...............................................................................................18
Overwrite ...................................................................................................20
Setup Menu ................................................................................................22
USB Mode .................................................................................................32
Advanced Setup Menu ...............................................................................34
Specifications ...............................................................................45
Troubleshooting ...........................................................................45
Technical Support ........................................................................46
Service and Support ...................................................................................47
Technical Support FAX Back Form ...........................................................50
www.aleratec.com
®
www.aleratec.com 1
Introduction
Thank you for purchasing the 1:1 HDD Cruiser. Please read this User Guide
thoroughly before using this product.
Product Features
The 1:1 HDD Cruiser is a Hard Disk Drive Duplicator and Hard Disk Drive Sanitizer.
• Sanitizes/Wipes drives clean with the choice of three Overwrite patterns:
▪ One Pass
▪ Three Pass with Verify
▪ Seven Pass per DoD 5220.22M
• Secure Erase
• Duplicates/Makes HDD copies
• Quick load drive bays
• Supports 3.5” SATA HDDs
Optional 2.5” SATA HDD Adapter available (Aleratec Part Number 350106)
Check out Aleratec Online!
• www.aleratec.com
• www.facebook.com/Aleratec
• www.twitter.com/Aleratec
• www.youtube.com/Aleratec
www.aleratec.com
2
Introduction
Key Items
Display Panel
(see page 4)
Power Switch
Controller
Drive Bays
(2)
Source Drive
Target Drive
www.aleratec.com 3
1
2
3
Introduction
1:1 HDD Cruiser Front Panel
1 Drive Bays
Drive bays with quick loading doors.
2 Drive Bay Door
The drive bay handle/tab is used to open the individual drive bays.
3 Drive LEDs
Each HDD bay has a blue power light that will be on when there is an HDD
properly inserted in the drive bay.
Each HDD bay has an orange drive activity light that will light when the HDD
is being used. Do not remove a drive when this light is on, otherwise you may
loose your data.
www.aleratec.com
4
Introduction
1:1 HDD Cruiser Copy Controller Display Panel and Buttons
(Actual display may vary from illustration)
1. LCD display shows all functions and messages
2. ENT button is used to execute a selected function, or enter a menu
3. ESC button is used to cancel a selected function, or exit a menu
4. UP arrow is used to scroll backward through functions or menus
5. DOWN arrow is used to scroll forward through functions or menus
ENT
HDD Cruiser
1-1 ver:
4
13
5
2
ESC
Autres manuels pour 1:1 HDD Cruiser
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Aleratec Stockage
Manuels Stockage populaires d'autres marques
Spectra Logic
Spectra Logic T-Series Spectra T50e Manuel utilisateur
Panasonic
Panasonic LKM-F931-1 Manuel utilisateur
Tabernus
Tabernus Enterprise Erase E2400 Manuel utilisateur
Rocstor
Rocstor COMMANDER 3F series Manuel utilisateur
HP
HP P9000 Manuel utilisateur
Western Digital
Western Digital Ultrastar Data60 Manuel utilisateur