Akura PDAB3600 Manuel utilisateur
DAB MP3 PLAYER
PLEASE READ BEFORE USE.
PDAB3600
OWNER S MANUAL
,
CONTENTS
1.SAFETY INFORMATION 1-3
2.PRECAUTIONS 4
3.INTRODUCTION 5-6
6.INTERFACE AND OPERATION
9- 27
4.CONNECT TO COMPUTER 7
5.OUT OF BOX BEHAVIOUR 8
6.1 Display
6.2 Keys
6.3 Default settings
9
9
12
6.4 General operation
12
6.5 DAB Mode
6.6 Audio Player Mode
6.7 FM Radio
17
21
23
6.8 MIC Record
25
6.9 Trouble Shooting
27
SAFETY INRORMATION
1
Before using the unit,be sure to read all
operating instruction carefully.Please note
that these are general precautions and may
not pertain to your unit.
1.Read instrucion
All the safety and operating instrcions
should be read before the product is
operated.
2.Retain instructions
The safety and operating instructions
should be retained for future reference.
3.Heed warnings
All warnings on the product and in the
operating instructions should be adhered to.
4.Follow instructions
All operating and use instructions should
be followed.
5.Cleaning
Unplug this product from the wall outlet
before cleaning.Do not use liquid cleaners
or aerosol cleaners.Use a dry cloth for
cleaning.
6.Attachments
Do not use attachments not recommended
by the product s manufacturer as they may
cause hazards.
,
7.Water and moisture
Do not use this product near water-for
example: near a bathtub, washbowl, kithen
sink or laundry tub; in a wet basement; or
near a swimming poll.
8.Accessories
Do not place this product on an unstable
cart, stand, tripod, bracket or table. The
product may fall, causing
serious injuryand serious
damage to the product.
Useonly with a cart, stand,
tripod, bracket or table
recommended by the
manufacturer or sold with
the product. Any mounting of the product
should follow the manufacturer s
instructions, and should use a mounting
accessory recommended by the
manufacturer.
,
8A.An appliance and cart combination
should be moved with care. Quick stops,
excessive force and uneven surfaces
may cause the appliance and cart
combination to overturn.
9.Ventilation
Slots and openings in the cabinet and
in the back or bottom are provided for
ventilation, to ensure reliable operation
of the product and to protect it from
overheating. These openings must not
be blocked or covered. The openings
should never be blocked by placing the
product on a bed, sofa, rug or other
similar surface. This product should
never be placed near or over a radiator
or heat source.This product should not
be placed in a built-in installation such
as a bookcase or rack unless proper
ventilation is provided or the
manufacturer s instructions have been
adhered to.
10.Power sources
This product should be operated only from
the type of power source indicated on the
SAFETY INRORMATION
2
Marking label. If you are not sure the type
of power supply to your home, consult
your appliance dealer or local power
company. For products intended to operate
from battery power, or other sources,
refer to the operating instructions.
12.Power-cord protection
Power-supply cords should be routed so
that they are not likely to be walked on or
pinched by items placed upon or against
them, paying particular attention to cords
at plugs, convenience receptacles, and
the point where they exit from the appliance.
13.Lightning
To protect your product from a lightning
storm, or when it is left unattended and
unused for long periods of time, unplug
it from the wall outlet and disconnect the
antenna of cable system. This will prevent
damage to the product due to lightning
and power-line surges.
14.Power lines
An outside antenna system should not be
Located in the vicinity of overhead power
lines or other electric light or power
11.Grounding or polarization
This product is equipped with a polarized
alternating-current line plug (a plug having
one blade wider than the other). This plug
will fit into the power outlet only one way.
This is a safety feature. If you are unable
to insert the plug fully into the outlet, try
reversing the plug. If the plug should still
fail to fit, contact your electrician to replace
you obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
15.Overloading
Do not overload wall outlets and extension
cords as this can result in a risk of fire or
electric shock.
16.Object and liquid entry
Never push objects of any kind into this
product through openings sa they may
touch dangerous voltage points or short
out parts that could result in fire or electric
shock. Never spill or spray any type of
liquid on the product.
17. Outdoor antenna grounding
If an outside antenna is connected to the
product, be sure the antenna system is
grounded so as to provide some protection
against voltage surges and built-up static
circuits,or where it can fall into such power
lines or circuits.When installing an outside
antenna system,extreme care should be
taken to keep from touching such power
lines or circuits ax contact with them might
be fatal.
GROUND
CLAMP
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250,PARTH)
ELECTRIC
SERVICE
EQUIPMENT
NEC-NATIONAL ELECTRICAL CODE
S2898A
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
SAFETY INRORMATION
3
22.Damage requiring service
when the power-supply cord or plug is
damaged.
If liquid has been spilled or objects have
fallen into the product.
If the product has been exposed to rain or
water.
If the product does not operate normally by
following the operating instructions. Adjust
a.
b.
c.
d.
only those controls that are covered by the
operating instructions, as an adjustment
other controls may result in damage and
will often require extensive work by a
qualified technician to restore the product
to its normal operation.
e. If the product has been dropped or the
cabinet has been damaged.
When the product exhibits a distinct
change in performance-this indicates a
need for service.
f.
23.Heat
The product should be situated away from
heat sources such as radiators, heat
registers, stoves or other products
(including amplifiers) that produce heat.
20.Safety check
Upon completion of any service or repairs
to this product, ask the service technician
to preform safety checks to determine that
the product is in proper operating condition.
18.Servicing
Do not attempt to service this product
yourself as opening or removing covers
may expose you to dangerous voltage or
other hazards. Refer all servicing to
qualified service personnel.
19.Replacement parts
When replacement parts are required, be
sure the service technician uses
replacement parts specified by the
manufacturer or those that have the same
characteristics sa the original part.
Unauthorized substitutions may result in
fire, electric shock or other hazards.
21.Wall or ceiling mounting
The product should be mounted to a wall
or ceiling only as recommended by the
manufacturer.
charges. Section 810 of the National
Electric code, ANSI/NFPA 70, provides
information with respect to proper grounding
of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge product, size of grounding
conductors, location of antenna discharge
product, connection to grounding electrodes
and requirements for grounding electrode.
24.Note to CATV system installer
This reminder is provided to call the CATV
system installer s attention to Article
820-40 of the NEC that provides guidelines
for proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable
entry as practical.
Unplug the product from the wall outlet and
refer servicing to qualified service
personnel under the following conditions:
PRECAUTIONS
COPYRIGHT
Distributing copies of MP3, WMA or WAV tracks without permission is of international copyright
laws.
SAFETY:
Vibration experienced during walking or exercising will not affect the player. However, dropping
the player or dropping a heavy object on the player may result in damage or sound distortion.
Avoid spilling any liquid onto or into the player.
Do not leave the player in a location near heat sources; in a location subject to direct sunlight,
excessive dust, sand, moisture, rain or mechanical shock; on an unlevel surface; or in a car
with the windows closed during periods of excessive heat.
ROAD SAFETY:
Do not use headphones while driving, cycling or operating any motorized vehicle. It may create a
traffic hazard and it is illegal in some areas. It can be potentially dangerous to play your headset
at a high volume while walking, especially at pedestrian crossings. You should exercise extreme
caution or discontinue use in potentially hazardous situations.
FCC WARNING:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between and receiver.
Connect the equipment into a outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
Modifications not authorized by the manufacturer may void users authority to operate this device.
4
INTRODUCTION
EARPHONE jack
USB jack
VOL+
VOL-
5
Hold
LCD display
OK
DAB menu
OK
Local scan
Full scan
save to presets
Local scan
AMUSEER
Mp3
2 Battries
Logosilk
Info button
REC button
PREV button
POWER
NEXT button
MENU button
Func button
EQ
Logosilk
Lable
PDHYSICAL ESCRIPTION
OK SELECT()
R
E
C
M
e
n
u
E
Q
M
p
3
/
D
A
B
I
n
f
o
P
R
E
S
E
T
F
u
n
c
-
s
e
l
Move save
USB 2.0 high speed digital transmission
WIN98 upwards system exempt drive
6
- Audio Player
- Mains adapter terminated in mini USB type B
- USB to mini USB cable for connection to PC
- Accessories
Contents
-
-
-
-
-
DAB Radio
Music player
FM Radio
MIC recording
Voice Playback
Features
GETTING STARTED
The headphones act as the antenna for both Dab and FM radio so in
order for these modes to function headphones must be fitted
-
- Use only the size and type of battery specified.
Be sure to follow the correct polarity when installing the battery as
indicated. Reversed batteries may cause damage to the device. If the
device is not to be used for a long period of time, remove the battery to
prevent damage or injury from possible battery leakage. Do not try to
recharge batteries not intended to be recharged; they can overheat and
rupture.(Follow battery manufacturer s directions.)
INTRODUCTION
CONNECT TO COMPUTER
TRANSFERRING FILES
You can download MP3 files from the internet or use encoding software to
convent music that you have on an audio CD into MP3 format. Once these
files are stored on your computer you can easily copy them to your player.
Connect the computer to your player using the supplied USB cable or just
remove the USB Flash Cover and insert the USB Flash Drive plug into
the USB port on the computer. The unit will turn on automatically.
7
Computer
USB jack
USB cable
When connect PC, the MP3 is ON state already ,not need to press any button.
READY
2)When MP3 player connect to PC, it can t play. If you want to listen
songs, must disconnection the USB connect line first.
3)After unfix the USB, the Mp3 will auto turn on , it is normal.
4)If the PC can not find the hardware, please check the connect
method whether right.
,
NOTE:
1)Please turn off the MP3 before connect PC.
8
Out of Box Behaviour
Press and hold the POWER key for 2 seconds to turn on the unit.
When the unit is first powered on, a welcome screen will appear for 2 seconds,
this will be followed by a brief message creating new playlist .The unit will then go
straight into DAB mode where it will show now tuning and start scanning for the stations
available as shown below. In the scanning screen the frequency being scanned, the number
of station found and a progress scanning bar will be displayed
AMUSSER
DAB
Scanning ... 225.648MHz
If no stations are found the unit will return to Station not available
DAB
Station not availble
If a service list can be found it will tune to the first station in the list.
The next time the unit is powered on, it will return to the last mode left in before it is powered
off. For example if the user turned off the unit when he listened to MP3 music. The unit
automatically returns to Audio Player mode when it is powered on next time.
Table des matières
Autres manuels Akura Lecteur MP3
Manuels Lecteur MP3 populaires d'autres marques
Blaupunkt
Blaupunkt Compact Drive MP3 Manuel utilisateur
Memorex
Memorex MMP9008 - 8GB USB 2.0 Manuel utilisateur
Meizu Electronic Technology
Meizu Electronic Technology E5 Manuel utilisateur
Naxa
Naxa NMV-173NX Manuel utilisateur
Philips
Philips PSA250 Manuel utilisateur
Zipy
Zipy go! Waving Manuel utilisateur
