Aircare MA1201 Manuel utilisateur

Read and save these instructions

CONSOLE

Everything you need to know about your

ALL MA1201 MODELS 1B73362

8/2020

a. Top (fan assembly)

b. Base

#830484

c. MAF1 Super Wick®

ALL MAF1 WICKS

d. Float

#829816

e. Float support and one screw (installed in base)

SUPPORT #830496 | SCREW #829815

f. Water bottle

#830537

g. Water ﬁll cap

#824690

h. Spring valve cap

#1B73170

i. Demineralization cartridge

#AU5003PK

j. Four casters

#829812

k. Owner’s manual

#1B73362

Remove the Console from its packaging.

You should have:

Prefer to see a video?

Watch the Console set-up at

aircareproducts.com/support.

SCAN THE CODE TO THE RIGHT

WITH YOUR PHONE’S CAMERA

If you are missing any parts, or need

replacement parts, call us at 800.547.3888 or

visit our website aircareproducts.com.

♥We hope you love your Mini-Console. 

LET’S GET YOU UP AND RUNNING

Turn the base upright and install your

wick. Wrap the wick through the base

guides in a circle so the wick’s ends meet. Put

the top on the base.

Put your Console in the most centrally-

located room of your home. It should

be on a level surface against an interior wall.

Make sure it’s at least two inches from the wall

so the humidistat (on the cord) can accurately

read your humidity.

Remove the top, water bottle, and all of

the loose items from the base. Turn the

base over and insert the casters snugly into the

bottom. Just use your hands! Using tools can

crack the cabinet.

More about positioning:

• To maximize humidity circulation, put your unit near a cold air

return.

• If you prefer to put your unit in the room where humidity is

most needed, you can! But the humidity won’t circulate as

well with this method.

• Don’t put your humidiﬁer under a window, as condensation may occur.

• Put the unit on the bottom ﬂoor of a multi-story home.

Unscrew the spring valve cap from the

water bottle. Take the demineralization

cartridge from the parts bag and screw it into

the the cap. Put the cap back on the bottle.

Remove the larger water bottle ﬁll cap.

Put the water bottle ﬂat on a counter

and slide the opening under a faucet. Fill the

water bottle, then put the cap back on. Tighten

the cap with your hands, making sure the cap

is correctly threaded.

Put the water bottle in the base and let

the bottle drain completely. Make sure

the plunger in the cap connects with the post in

the base.

Remove the bottle and reﬁll it. Put the bottle back

into the base. Filled twice like this, your Console

holds 3.6 gallons of water.

Wait 20 minutes for the wick to become

fully saturated, then proceed to step 9.

About water additives:

• Do not use essential oils in your Console.

• Do not use water softeners.

• We recommend our Essick Air Bacteriostat to help inhibit

mold growth.

Press the humidity control button to

set your humidity level from 25% to 65%.

The humidistat on your cord will read your home’s

humidity and turn your fan o when the set level

is reached. When set to 65%, your unit will run

continuously.

That’s it! Your Console is ready to use.

Plug in your unit and press the power

button .

Set your desired fan speed by pressing

the fan button . Your Console has

three fan speeds that are displayed by F1 (the

lowest speed) through F4 (the highest speed).

The additional AUTO setting (displayed by an A)

allows the fan speed to adjust automatically to

your humidity setting.

Note: On higher speeds, the Console puts out a tremendous

amount of humidity, so it’s louder on these levels. Most of our

customers liken it to the sound of a box fan. Rest assured there is

nothing wrong with your unit, it’s just working very hard to put out

much-needed humidity.

F– The F code means your unit is empty and needs to be FILLED with water.

CL – Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for ﬁve seconds, until

CL appears. Your Console will lock on the current fan and humidity settings. Release the lock by pressing the power button again for ﬁve

seconds until the display ﬂashes CL twice, letting you know the lock is o.

CF – The CF code triggers after 720 hours of use and means it’s time to CHECK YOUR FILTER (wick). Unplug your unit and check your

wick. If your wick is still in good shape, simply clear the code by plugging your humidiﬁer back in. If your wick needs replacing, install a new

MAF1 Super Wick®:

ABOUT THE CODES

Regular cleaning is important for preventing mold,

mildew, and other bacterial growth in your humidiﬁer.

It also keeps your Console working its best.

1. Let the unit run until it’s empty, then turn it o and

unplug it.

2. Remove the water bottle and the top from the base.

3. Throw your wick away if it is time to replace it.

Otherwise, remove it from the base and put the wick in

a sink while you ﬁnish cleaning your Console.

4. Pour out any remaining water from the base and bottle.

5. Clean the base and bottle by ﬁlling each half-full with

water. Add 1 cup of white vinegar to each. Let these sit

for 20 minutes. To disinfect, replace the vinegar with 1

teaspoon of bleach in each. Do not mix vinegar and

bleach.

6. After 20 minutes, empty the base and bottle.

7. Dampen a sponge with white vinegar and wipe down

the base. Rinse it thoroughly. To disinfect, replace the

vinegar with bleach.

8. Wipe everything dry. Replace your wick or install a new

one, then reassemble the unit.

When storing your Console, discard the used wick and disinfect

the unit using the directions above. Dry the unit thoroughly, and

store in a temperature-regulated area. Do not install a new wick

until you are ready to use your humidiﬁer again.

HOW TO CLEAN YOUR CONSOLE

Où se trouve mon numéro

de série?

Pourquoi mon unité ne

fonctionne-t-elle pas?

Pourquoi l’écran clignote-t-il en

achant « 20 »?

À quelle fréquence dois-je

remplacer ma mèche?

Puis-je commander des pièces

de rechange?

Pourquoi l’écran clignote-t-il en

achant « -- »?

Pourquoi mon taux d’humidité

n’augmente-t-il pas?

Votre numéro de série se trouve sur l’autocollant au dos de votre

ventilateur. Vous pouvez l’écrire ici pour référence future :

__________

Votre niveau d’humidité est inférieur à 20 %. Essayez d’augmenter

la vitesse de votre ventilateur et le niveau de sortie.

La teneur en minéraux de votre eau détermine la fréquence

à laquelle votre mèche doit être remplacée. Une eau plus

dure implique des changements plus fréquents. L’utilisation

de notre bactériostat (pièce #1970) peut vous aider à garder

votre appareil plus propre et à prolonger la durée de vie de

votre mèche. Changez toujours votre mèche au début de

chaque saison.

Oui! Les pièces de rechange Mini-Console et leurs

références sont indiquées à la page 10.

Votre niveau d’humidité est supérieur à 90 %. Essayez de

réduire la vitesse du ventilateur et le niveau de sortie.

Il faut parfois 2 à 3 jours pour que votre nouvel

humidiﬁcateur d’air fasse monter le taux d’humidité, surtout

s’il fait très sec dans votre maison.

Si votre mèche est vieille, remplacez-la par une nouvelle.

• Vériﬁez votre bouteille d’eau. (

VOIR ÉTAPE

• Votre unité a atteint le niveau d’humidité que vous avez ﬁxé.

info@essickair.com aircareproducts.com

800.547.3888

CONSOLE

TOUS LES MODÈLES MA1201

Tout ce que vous devez savoir sur votre

Lisez et conservez ces instructions

FOIRE AUX QUESTION

Pour toute autre problème, contactez nos experts en humidiﬁcation!

Ils sont prêts à vous aider par téléphone, courriel ou chat.

CONSOLE

TOUS LES MODÈLES MA1201 1B73362

8/2020

Tout ce que vous devez savoir sur votre

Lisez et conservez ces instructions

Autres manuels pour MA1201

Table des matières

Langues :

Autres manuels Aircare Humidificateur

Aircare

Aircare CM330A Manuel utilisateur

Aircare

Aircare AURORA Manuel utilisateur

Aircare

Aircare D46720 Manuel utilisateur

Aircare

Aircare EA1407 Manuel utilisateur

Aircare

Aircare 831000 Manuel utilisateur

Aircare

Aircare EP9(R) 800 Manuel utilisateur

Aircare

Aircare ESSENTIALS OZARK Manuel utilisateur

Aircare

Aircare EA1407 Manuel utilisateur

Aircare

Aircare 4DTS 900 Manuel utilisateur

Aircare

Aircare 7d6100 Manuel utilisateur

Aircare

Aircare EP9500 Manuel de l'opérateur

Aircare

Aircare EP9 Series Manuel utilisateur

Aircare

Aircare 7d6100 Manuel utilisateur

Aircare

Aircare E35000 Manuel utilisateur

Aircare

Aircare 447400HB Manuel utilisateur

Aircare

Aircare MA1201 Manuel utilisateur

Aircare

Aircare 4DTS 900 Manuel utilisateur

Aircare

Aircare CM330AWHT Manuel utilisateur

Aircare

Aircare TABLE-TOP Manuel utilisateur

Aircare

Aircare DUET Manuel utilisateur

Aircare

Aircare 5D6700 Manuel utilisateur

Aircare

Aircare EXECUTIVE Manuel utilisateur

Aircare

Aircare ESSENTIALS OZARK Manuel utilisateur

Aircare

Aircare SS390DWHT Manuel utilisateur

Manuels Humidificateur populaires d'autres marques

Boneco

Boneco H300 Manuel utilisateur

Bionaire

Bionaire CM1 Manuel

Air-O-Swiss

Air-O-Swiss AOS 7131 Manuel

KING

KING K 5002 Rainbow Manuel utilisateur

Crane

Crane EE-6902 Manuel utilisateur

Glaziar

Glaziar Ness Manuel utilisateur

Philips

Philips DreamStation Go Dimensions

Honeywell

Honeywell MISTMATE HUL520BC Manuel utilisateur

Stadler Form

Stadler Form Hera Manuel utilisateur

Hunter

Hunter 31206 Manuel utilisateur

TaoTronics

TaoTronics TT-AH004 Manuel utilisateur

adorini

adorini Cigar Heaven Manuel utilisateur

Lanaform

Lanaform Aroma Manuel utilisateur

Aprilaire

Aprilaire 800 Series Manuel utilisateur

Pyle

Pyle SereneLife PHUMDIF8 Manuel utilisateur

Trotec

Trotec B 200 Manuel utilisateur

Pure Humidifier

Pure Humidifier EC Series Manuel utilisateur

Crane

Crane EE-864 Manuel utilisateur