AG Neovo F-17C Manuel utilisateur
2
Table of Contents
Precautions...................................................................................................................................................3
About this manual 3
Important Operating Instructions 4
Getting Started............................................................................................................................................5
Quick Setup 5
Unpacking 6
Attaching the Base 7
Adjusting the Monitor’s Tilting Angle 8
Security Slot 8
Making Connections 9
Removing the Rear-connector Cover 9
Connectors Close up 10
Replacing the Rear-connector Cover 11
Customizing your Monitor ...................................................................................................................... 12
Volume Adjust 12
Adjusting the Monitor’s Display 12
Selecting OSD Features 12
OSD Menus 14
Troubleshooting ........................................................................................................................................18
Troubleshooting Procedures 18
Warning Messages 18
Troubleshooting 19
LCD Panel Display Technical Features and Specifications 20
Regulations................................................................................................................................................. 21
FCC compliance 21
TCO’99 22
3
P
RECAUTIONS
About this manual
This manual is designed to assist you in setting up and using the LCD monitor. Information
in this document has been carefully checked for accuracy; however, no guarantee is given to
the correctness of the contents. The information in this document is subject to change with-
out notice. This document contains proprietary information protected by copyright. All
rights are reserved. No part of this manual may be reproduced by any mechanical, electronic
or other means, in any form, without prior written permission of the manufacturer.
4
Important Operating Instructions
1. Please read the following instructions carefully. This manual should be retained for
future use.
2. To clean the LCD monitor screen, first, make sure the monitor is in the power off
mode. Unplug the monitor from its power source before cleaning it. Do not spray
liquid cleaners directly onto the unit. Without applying excessive pressure, clean
the screen with a slightly dampened rag.
3. Do not cover or obstruct the ventilation openings on the rear of the monitor.
4. Do not place your LCD monitor near a heat source or open window, or in a location
exposed to direct sunlight, dust, or mechanical vibration.
5. Do not place anything on top of the monitor-to-PC signal cord. Make sure the cord is
placed in an area where it will not be stepped on.
6. Do not apply pressure to the LCD screen. Excessive pressure may cause permanent
damage to the display.
7. Do not remove the cover or attempt to service this unit by yourself. You may void
the warranty.
8. Safe storage of the LCD monitor is in a range of minus 20 to plus 60 degrees Celsius.
9. Unplug the monitor if not in use for an extended period.
10. Use the original carton and packing materials when transporting the monitor.
11. Immediately unplug your monitor and call an authorized technician when:
The power or monitor-to-PC signal cord is frayed or damaged.
Liquid has been spilled into the monitor, or it has been exposed to rain.
The monitor has been dropped or the case has been damaged.
A distinct change in performance is noticed.
5
G
ETTING
S
TARTED
Your LCD monitor is versatile, ergonomic, and above all easy to use. The LCD monitor is ca-
pable of displaying most standards, from 640 x 480 VGA to 1280 by 1024 SXGA. Built-in ste-
reo speakers provide excellent stereo sound while saving desktop space. Finally, the front-
panel controls allow you to easily adjust the monitor’s display parameters to suit your hab-
its.
Quick Setup
Follow these directions to correctly set up your monitor.
1. Remove all packing materials and wrapping from the monitor (page 6).
2. Attach the base (page 7).
3. Place the monitor in its desired location. Ensure that there is space around the
monitor, especially the rear area near the vents.
4. Connect your video source and AC adapter (page 9).
5. Turn on the video source.
6. Press the power button on the monitor. The display should appear. If no display ap-
pears, check Warning Messages and Troubleshooting (page 18).
7. Ensure that your computer display is set at 1280X1024 pixels and 60Hz. Press the
AUTO button . The monitor optimizes the display automatically.
Note! The monitor is compliant with VESA FPMPMI standards and can be wall- or arm-
mounted. Before wall-mounting or arm-mounting, disassemble the monitor stand.
6
Unpacking
After you unpack the monitor, make sure the following items are included in the box and
are in good condition:
• LCD monitor 17-inch monitor without base
• Base assembly Includes base and screws
• Power adapter
• Power cord
• D-sub 15-pin VGA cable
• Audio cable
• Floppy/CD-ROM (containing
Windows information file and user’s
manual)
• Phillips screwdriver
If you find that any of these items are missing or appear damaged, contact your dealer im-
mediately. Do not throw away the packing material or shipping carton in case you need to
ship or store the LCD monitor in the future.
7
Attaching the Base
Before using the monitor, you must attach the base. You will need a Phillips screwdriver and
a blanket or foam sheet to lay the monitor on. The procedure is described below.
1. Cover a table with foam or a soft blanket to protect the monitor screen. Carefully
place the monitor with the screen facing down on the table.
2. Attach the base with the three screws.
3. Stand the monitor upright.
8
Adjusting the Monitor’s Tilting Angle
Your LCD monitor’s vertical tilting angle can be adjusted between 0º ~ 20º for comfortable
viewing.
To adjust the tilting angle, grasp the
top corners of the monitor with both
hands and tilt to the desired angle.
020
Warning! Forcing the monitor past its maximum extension can result in damage to the
monitor.
Security Slot
Your LCD monitor has a security slot built in to the rear of the monitor.
If you have any doubts on the
security of your LCD monitor,
secure it to a permanent
object in the room by means of
the security slot shown here:
K
Note! Consult your local dealer for information on purchasing a security slot cable.
9
Making Connections
Removing the Rear-connector Cover
Before making connections, you must remove the rear-connector cover. Refer to the follow-
ing:
1. Tilt the monitor to its 0º vertical position. (See Adjusting the Monitor’s Tilting Angle
on page 8.)
2. Remove the cover by gripping at the top and pulling in the direction of the arrow as
shown here:
10
Connectors Close up
The following illustration shows the connectors on the rear of the monitor. (Unplug the
power source when making connections. The final step in the following procedures should
be connecting the power adapter to a wall socket.)
Connector Cable Procedure
1 DC power
jack
Power cord and
adapter
Plug the adapter power connector into this DC
power jack. Plug the female end of the power
cable into the AC-adapter and the male end of
the power cord into a wall socket.
2 Audio-in
jack
Audio cable To avail of the monitor’s built-in stereo speakers,
plug the audio cable into this jack. Attach the
other end to your audio source.
3 Audio-out
jack
Headphone cable (not
included)
You can attach your headphones to this jack.
4 VGA
port
D-sub 15-pin VGA cable Connect one end of the cable to the VGA port.
Connect the other end to the PC’s VGA port.
Tighten the securing screws on both connectors.
3
2
1 4
Autres manuels pour F-17C
1
Table des matières
Autres manuels AG Neovo Moniteur
AG Neovo
AG Neovo H-W22 Manuel utilisateur
AG Neovo
AG Neovo SC-17 Manuel utilisateur
AG Neovo
AG Neovo SX-Series Manuel utilisateur
AG Neovo
AG Neovo MX-22 Manuel utilisateur
AG Neovo
AG Neovo SX-17P Plus Manuel utilisateur
AG Neovo
AG Neovo VW-55H2 Manuel utilisateur
AG Neovo
AG Neovo X-Series Manuel utilisateur
AG Neovo
AG Neovo PM-48 Manuel utilisateur
AG Neovo
AG Neovo TX-42P Manuel utilisateur
AG Neovo
AG Neovo X-150 Manuel utilisateur
AG Neovo
AG Neovo RX-Series Manuel utilisateur
AG Neovo
AG Neovo TX-2401 Manuel utilisateur
AG Neovo
AG Neovo RX-W19 Manuel utilisateur
AG Neovo
AG Neovo P-17 Manuel utilisateur
AG Neovo
AG Neovo QM-43 Manuel utilisateur
AG Neovo
AG Neovo DR-17G Manuel utilisateur
AG Neovo
AG Neovo X-22 Manuel utilisateur
AG Neovo
AG Neovo PM-65P Manuel utilisateur
AG Neovo
AG Neovo PS Series Manuel utilisateur
AG Neovo
AG Neovo M-17 Manuel utilisateur
