Wine cabinet Installation:
When you receive the cabinet, please unpack the unit and
make sure there is no flaws in its external appearance (from
shocks, deformation, ect.)
Open the door and check all interior fittings and supplied
items if are all complete (shelves, instruction, control panel,
etc.) Please install it according to the following points if the
shelves or shelf brackets fall off during transit.
After checking, if no problem, then, pls carry to the final
place, which should be care as follows:
Leaving space of minimum 5cm between your wine cabinet
and left & right wall; at least 8cm between back of cabinet and
the wall. (Freestanding only)
Position the wine cabinet on a flat level surface, if not,
adjust the feet of wine cabinet to keep level.
Away from sources of heat and high humidity areas
(laundry room and bathroom, etc).
Do not tilt it at an angle of more than 45° when move the
cabinet. Allow a minimum 10 minutes interval between transit
and re-starting.
Make sure the ventilation is free if you wish to install your
cabinet into a worktable, otherwise, it will reduce the effect of
usage.
Wine Cellar Features and Use Initial Setup
Before connecting the wine cellar to the power source, let it
stand upright for approximately 24 hours. This will reduce the
possibility of a malfunction in the cooling system from handling
during transportation.
Once you have plugged the unit into an electrical outlet, let
the unit run for at least 4 hours to acclimate before making any
adjustments.
４
