ADDER RMK4D-R2 Manuel utilisateur

What’s in the box

RMK4D-R2 Rack Mount Kit

Quick Start

Inner and outer brackets plus

joiner and bolts

Part number: RMK4D-R2

1 Attach an outer and an inner bracket to each module.

Note the arrangement of each bracket type shown here:

Outer brackets x 2

Inner brackets x 2

Joiner x 1 Bolts x 12

Outer

Inner

Left

module

Outer

Inner

Right

module

Joiner

2 Introduce the joiner between the two modules.

continued overleaf

Assembly

3 Use the remaining four bolts to x the

inner brackets to the joiner.

Assembly (continued)

Part No. MAN-RMK4D-R2-ADDER_V1.0a

Web: www.adder.com

Contact: www.adder.com/contact-details

Support: www.adder.com/support

Warranty

Adder Technology Ltd warrants that this product shall be free from defects in workmanship and materials for a period of two years from the date

of original purchase. If the product should fail to operate correctly in normal use during the warranty period,Adder will replace or repair it free

of charge. No liability can be accepted for damage due to misuse or circumstances outside Adder’s control.Also Adder will not be responsible for

any loss, damage or injury arising directly or indirectly from the use of this product.Adder’s total liability under the terms of this warranty shall in

all circumstances be limited to the replacement value of this product. If any difculty is experienced in the installation or use of this product that

you are unable to resolve, please contact your supplier.

4 Mount the whole assembly into your 19” rack.

5 When using an Adder RED-PSU system, attach the

PSU-RPS-5V dongles to any of the bracket rear

slots.

PSU-RPS-5V

19” rack

mount

PSU-RPS-5V

Table des matières

Autres manuels ADDER Support et étagère