cleaner. Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with
the aid of the green peg in the pack of accessories included with the appliance. After everything
is dry place appliance back into service.
Energy Saving tips
1. Do not place warm foods into the appliance. Allow warm foods to cool first. Do not install the
appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause
longer, more frequent operation of the compressor.
2. In order to make the cooling system work efficiently, please make sure the side plates and back
plate of the product are with some distance from the wall. It is strongly recommended that its back
is 75mm away from the wall, its sides at least have a space of 100mm separately and the
height from over its top is not less than 100mm.
3. When the product works, please do not open the door too often or leave the door open any
longer than necessary.
4. Do not set temperature any colder than necessary.
5. The direct cooling refrigerator (with a freezer) needs to be defrosted when necessary. This will
improve the cold transfer and reduce energy consumption.
6. The sketch map shows the right combination of the drawers, crisper and shelves which can
lead to the more energy efficiency. If users adjust the combination, it would result in the energy-
consuming.
7. Store food logically. Do not exceed the storage period specified.
Changing the light bulb
Warning!
If the light bulb is damaged ,it must be replaced by a qualified persons in order to avoid a hazard.
Contact your local Service
Force Center for help.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit
breaker.
off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Clean
the appliance and the interior accessories with a cloth and lukewarm water.Commercially available
dish washing detergents may also be used. After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption. For this reason carefully
clean the condenser at the back of the appliance once a year with a soft brush or a vacuum
9
off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Clean
the appliance and the interior accessories with a cloth and lukewarm water. Commercially available
dish washing detergents may also be used. After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption. For this reason carefully
clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner.
Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole.
3. When the unit is in operation, please do not open the door too often or leave the door open any
longer than necessary.
6. The sketch map shows the right combination of the drawers, crisper and shelves which can
lead to better energy efficiency. If users adjust the combination, it would result in more energy
consumption.
If the light bulb is damaged, it must be replaced by a qualified person in order to avoid a hazard.
Contact your local Service Centre for help.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit
breaker.
