Acard ARS-2160H Manuel utilisateur
Quick Installation Guide of ARS-2160H/ARS-2320S v1.3
Section 1 Introduction
1.1 verview
ARS-2160H/ARS-2320S is a SCSI-to-SATA II bridge. Through its connection to a SCSI host SCA2
80- in connector the bridge can turn a 2.5'' hard drive into one with LVD SCSI efficiency. Thus,
you can enjoy the high erformance of SCSI.
1.2 Specification
Tem erature:
O eration:
Humidity: 15% to 90%
Size: 14.6 cm(L) x 10.1 cm (W) x 2.5 cm (H)
1.3 Connectors
CN6: SCA2 80- in connector
CN16: SATA II integrated connector
CN3 & CN4: reserved
J1: jum er
1
2
4
8
DELAY START
WRITE PROTECT
PARITY DISABLE
FORCE SINGLE ENDED
LED +5V
LED ─
Reserved Pin 1 GND
Pin 1
Pin 20
CN6
CN16
J1
CN3
CN4
Section 2 Jumper Setting
The jum er (J1) is used to set functions.
SCSI ID
0°C to 70°C / Storage: -40°C to 85°C
Section 3 Installation
Here we sim ly take ARS-2160H to demonstrate.
1. Remove the 4 screws of ARS-2160H and o en the u er case.
2. Slide the 2.5'' SATA hard drive along the sides of ARS-2160H till it connects CN16.
3. Fix the SATA hard drive to the two sides of ARS-2160H with the enclosed 4 screws.
5. Set the jum er, and connect CN6 of ARS-2160H to the host SCA2 80- in connector.
4. Return the u er cover of the bridge and fix with the 4 screws.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Acard Système d'E/S
