ZVE 160
8
Operation Precautions
Please read the safety instructions thoroughly before operation, choose a proper working area to reduce
the risk of accidents.
The probe is flexible, which helps you to get to hard-to-reach areas. Please don’t insert or bend the
camera probe by force. Please do not over bend the probe (normally, the bending radius should more
than 5cm), so as not to cause permanent damage to the probe.
The hand-held LCD display is not waterproof. The camera head and its cover are waterproof, but not
acid-proof or fireproof. Touch with these materials will damage the camera head’s protective plastic.
Do not immerge the camera head into corrosive, oily places or contact high-temperature objects.
Don’t place the inspection into anything or anywhere that may contain a live electrical charge. Please
check following methods to avoid injury.
For walls: For inspecting inside the walls, make sure the electricity of the whole house is shut
down before using the tool.
For pipes: If you suspect a metal pipe could contain an electrical charge, have a qualified electrician to check the pipe before using. Ground
circuit, in some cases, can bereturned to the cast aluminum pipes and cause them to be charged.
For automobiles: Make sure the automobile is not running during inspection. Metal and liquid under the hood may be hot. Don’t get oil or gas
on the camera head.systems, vehicles, circuits, boats and aviation. Under limited conditions, accessories can be used to pick up small objects
such as rings and screws.
OPERATION NOTES
Don’t turn on and off the device continuously. Please allow more than 2 seconds between each On and Off for the unit to properly boot
up or shut down. If there is unusual image, please turn off the unit and try again.
The indicator of battery will appear, when the battery is low.
Don’t immerse the handheld display unit into water, which will result in electric shock and damage.
•
•
•
•
•
•
•
•
•
•
•
•
•
