Zip HydroTap Manuel utilisateur

Your Zip HydroTap will notify you when the filter replacement is due. The change filter light will flash white once per

minute until the filter has been replaced, and the filter percentage will show 0% on the Home screen.

Step 1:

Grab an empty bucket or container to collect the water which will be flushed through the system and an old towel to

mop up any spills.

Step 2:

Open the filter access door on the front of the HydroTap Command Centre. You will see the filter cartridge in front of

you.

Step 3:

Reach to the rear right hand side of the cartridge and you’ll find a flush line (looks like a hose) which is around 60cm

long which will be sealed with a stop cock located in the centre of the hose. Place the free end of the flush

line into the empty bucket or container. Turn the stop cock quickly on then off to relieve system pressure.

Step 4:

Gently hold the filter cartridge then press the red lever at the top right of the unit and rotate the cartridge a quarter

turn to the left. The unit should detach and you should be able to pull it free in a downwards motion. Some water

may drip from the cartridge at this point. Be sure to keep the cartridge level to avoid spills

Step 5:

Place spent cartridge in the sink or other suitable container.

Step 6:

Unpack your replacement cartridge and remove the sanitary cap. Write today’s date where shown on the label.

Ensure you avoid touching the O-rings or filter opening as this can cause bacterial contamination of the cartridge.

Step 7:

Slightly moisten the O-rings with regular tap water and line up the front cartridge label to the left.

Step 8:

Gently but firmly push the cartridge up into the filter head and turn a quarter-turn to the right –as far as it will go

without forcing it. The cartridge should now be locked in position with the front label facing forward.

Step 9:

Press the [MENU] button to bring up the main menu on the screen.

Step 10:

Press the [Install] button and turn the stop valve ON by rotating the lever clockwise until it is in line with the hose

Step 11:

Press the [Filter Flush] button then press [Start] to begin the process. Ensure you run at least 10-litres of water

through to flush the filter of excess black carbon particles.

Step 12:

When the filter flush is finished, turn the stock valve OFF by rotating the lever anti-clockwise until it

is perpendicular to the hose.

Step 13:

Press [Stop] to end the filter flush process.

Step 14:

Press the [Home] button to return to the home screen.

Note: If you are carrying out this flush after the HydroTap’s initial installation, the unit will go directly into calibration

mode after the Filter Flush Mode is turned off. With any subsequent filter changes the system will automatically revert to

the main menu.

Step 15:

Dispose of used cartridge and packaging thoughtfully.

Autres manuels pour HydroTap

Autres manuels Zip Système de filtration d'eau

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip FL104 Manuel utilisateur

Zip

Zip 82341 Manuel utilisateur

Zip

Zip HydroTap series Manuel utilisateur

Zip

Zip HydroTap G5 Touch-Free Wave Mode d’emploi

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip ZIP-B Manuel utilisateur

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip ChillTap Extra Manuel utilisateur

Zip

Zip ChillTap CT1/140 Manuel utilisateur

Zip

Zip HydroTap G4 Manuel utilisateur

Zip

Zip HydroTap G5 Touch-Free Wave Mode d’emploi

Zip

Zip Commercial HydroTap 86682 Manuel utilisateur

Zip

Zip 803828 Manuel

Zip

Zip HydroTap G5 Touch-Free Wave Mode d’emploi

Zip

Zip Elite HydroTap G4 range Manuel utilisateur

Manuels Système de filtration d'eau populaires d'autres marques

Wisy

Wisy LineAir 100 Manuel utilisateur

Schaffner

Schaffner Ecosine FN3446 Series Manuel d'utilisation

Pentair

Pentair FLECK 4600 SXT Guide de l'utilisateur

H2O International

H2O International H20-500 Manuel utilisateur

Renkforce

Renkforce 2306241 Manuel utilisateur

Neo-Pure

Neo-Pure TL3-A502 Manuel utilisateur

FLTR

FLTR OBF Manuel utilisateur

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Manuel utilisateur

Applied Membranes

Applied Membranes W-G844EM Manuel utilisateur

BEGA

BEGA 116 Manuel utilisateur

WATA

WATA Standard Manuel utilisateur

Price

Price FFU series Manuel

Gaggenau

Gaggenau BRITA INTENZA 467873 Manuel utilisateur

Brita

Brita SAFF-100 Manuel utilisateur

HEISSNER

HEISSNER FPU24000-00 Manuel utilisateur

BGS technic

BGS technic 1518 Manuel utilisateur

Reverse Osmosis

Reverse Osmosis RF Series Manuel utilisateur

ubbink

ubbink Filtramax Series Manuel utilisateur