(1)
If the button of sweeping switch fails, replace the switch.
(2)
If the travel switch fails, adjust the main brush wire rope to make the
travel switch work;
if
the travel switch
is
damaged, replace
it
(3)
If
100A contactor
is
damaged, replace
it.
4.
No watering
Sprinklerfunction
is
mainlyrelated tocomponents, water tank, water
pump,
water
pipe, valve, nozzle, relay, switch and control circuit. Common problems are water tank
leakage, water pipe rupture, loose ligation, water nozzle blockage, water pump damage,
electrical circuit failure and so on. If any joint is found to have water leakage, loosen its
connecting section, and then wrap
it
with raw material belt and fix
it
tightly.
5.
No charging
Check whether the charger connector is connected normally, whether the charger
works normally, and whether the display on the charger panel is in accordance with the
instructions. If the connector is not inserted properly, just plug it in. If you find other
abnormalities, such as fuse blown, charger does not show, please contact after-sales
service personnel in time.
6. Ash leakage
The main causes of ash leakage are as follows
(1)
The air filter is not vibrated in time to cause blockage
(2)The sealant strip of the garbage can falls off or is partially damaged
(3)The fan is not working properly
(4)
The front fender
is
damaged
(5)
The main brush has filament ribbon winding or the installation direction is wrong
(6)The buckle of dustbin is loose or falling off
(7)The cleaning speed is too fast
If the above situation is found, please take corresponding measures according to each
7. The main brush and side brush cannot be lifted
Three push rods are used to control the lifting of mainbrush and variable brush. If
one or two of them do not work,
it is
judged that the push rod
is
damaged and can be
replaced; if three of them do not work at the same time. Check the circuit, it can be
judged that the button
is
damaged, and
it
can be replaced.
