XODO Smart Floodlight Pro-Cam E8 Manuel utilisateur
Smart Floodlight Pro-Cam E8
Quick Installation Guide
1
1.Packing List
Open the package, then make sure the Smart
Floodlight Pro-Cam (device) is intact, and with
all the below accessories.
Smart Floodlight Pro-Cam
Installation Manual
Please refer to the installation pictures
in the App, and read this manual and
keep it handy during installation.
Hook
Hang your Smart Floodlight
Pro-Cam while connecting the
wires.
2
Screws(4).
Use 2 of these to attach the
supplied bracket to the wall.
图片数量要正确
Plastic Screw Sleeves (4)
Knock the plastic screw sleeve into the hole.
Electrical Caps (3)
Use these to connect Smart Floodlight
Pro-Cam wires to your existing wires as
shown in the diagram.
Waterproof rubber cap(2)
Use the waterproof rubber cap on
the screw hole of thedevice.
WARNING
This manual is for information
purpose only. Working with electricity can be dangerous
unless proper safety precautions are taken.
If you are not comfortable or are inexperienced with the
processes and tools described in this manual, we
recommend that you hire a licensed electrician.
3
2.How it all fits together
4*28
Plastic
Screw Sleeves
Mounting
Bracket
Electrical
Caps
Bracket Screws
4
Light
Adjustment
Knob
Camera
Lock
Collar
Rubber
Caps
Motion
Detector
（for lights）
3.The proper installation height to optimize
the motion sensor performance
WARNING
In order to prolong service life of the equipment,
please try to install the equipment in a place
without rain and high temperature and humidity.
Parallel to groud
05 26 feet (8 Meters)
When mounted at 10 feet （3 meters) off the ground, with
the motion detector tilted at about a 30 degree angle
toward the ground. (Please refer to below diagram).
the Smart Floodlight Pro-Cam will detect human sized
objects at a distance of up to 25 feet (8 meters).
10 feet
(3 Meters)
06
7
OFF
Step 1 - Shut power off at the breaker box.
If you don’t know where your breaker box is or how to
turn off power to the circuit where you are installing
your Smart Floodlight Pro-Cam, Please consult with a
licensed electrician.
Please switch it from [ON] to [OFF]
WARNING: Risk of electrical shock
Disconnect power at the circuit breaker before installing.
Verify that the supply voltage is correct.
Connect fixture to a 110VAC ~ 240VAC 50/60 Hz power
source.
Properly ground fixture.
Always follow code standards when installing wired connections.
Installation and wiring must be performed by a licensed electrician.
CAUTION: Risk of fire
Do not install near any combustible or flammable surfaces or liquids.
NOTICE
Do not connect this light fixture to a dimmer switch or timer.
OFF
WARNING
8
Step 2 - Remove the mounting bracket
Use a screwdriver to unscrew the screws.
Remove the mounting bracket.
1
2
2
1
Table des matières
Autres manuels XODO Caméra de sécurité
