Worx MAKERX WX747 Manuel utilisateur
20V Cordless Mini Blower WX747
WX747.X
Original instructions
Originalbetriebsanleitung
Notice originale
Istruzioni originali
Manual original
Manual original
Oorspronkelijke gebruiksaanwijzing
Original brugsanvisning
Opprinnelige Instruksjonene
Bruksanvisning i original
Instrukcja oryginalna
Ω ΔΩ
Eredeti használati utasítás
Instrucţiuni originale
Původní návod k používání
Pôvodný návod na použitie
Izvirna navodila
P06
P19
P34
P48
P62
P77
P91
P105
P117
P130
P142
P157
P174
P189
P203
P216
P230
EN
D
F
I
ES
PT
NL
DK
NOR
SV
PL
GR
HU
RO
CZ
SK
SL
EN
D
F
I
ES
PT
NL
DK
NOR
SV
PL
GR
HU
RO
CZ
SK
SL
1
3
4
5678
2
A3 A4
B C
ED
A2A1
A3 A4
BC
ED
A2A1
6
EN
ORIGINAL INSTRUCTION
PRODUCT SAFETY
GENERAL POWER TOOL SAFETY
WARNINGS
WARNING Read all safety
warnings and instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instruc-
tions for future reference.
The appliance is only to be used
with the power supply unit pro-
vided with the appliance.
IMPORTANT
READ CAREFULLY BEFORE
USE.
KEEP FOR FUTURE
REFERENCE.
Safe operating practices
1) Training
a) Read the instructions
carefully. Be familiar with
the controls and the correct
use of the machine.
b) Never allow children,
persons with reduced
physical, sensory or mental
capabilities or lack of
experience and knowledge
or people unfamiliar with
these instructions to
use the machine, local
regulations may restrict the
7
EN
age of the operator.
c) Never operate the machine
while people, especially
children, or pets are nearby.
d) Keep in mind that the
operator or user is
responsible for accidents or
hazards occurring to other
people or their property.
2)Preparation
a) While operating the
machine, always wear
substantial footwear and
long trousers. Do not
operate the machine when
barefoot or wearing open
sandals. Avoid wearing
clothing that is loose fitting
or that has hanging cords or
ties.
b) Do not wear loose clothing
or jewellery that can be
drawn into the air inlet. Keep
long hair away from the air
inlets.
c)
Obtain ear protection and
safety glasses. Wear them at
all times while operating the
machine.
d) Operate the machine in a
recommended position and
only on a firm, level surface.
e) Do not operate the machine
on a paved or gravel surface
where ejected material
8
EN
could cause injury.
f) Before using, always visually
inspect to see, that the
fasteners are secure, the
housing is undamaged and
that guards and screens
are in place. Replace worn
or damaged components
in sets to preserve balance.
Replace damaged or
unreadable labels.
3)Operation
a) Keep your face and body
away from the feed intake
opening.
b) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute,
or near any moving part.
c) Keep proper balance and
footing at all times. Do not
overreach.
d) Always stand clear of the
discharge zone when
operating this machine.
e) If the machine should start
making any unusual noise or
vibration, immediately shut
off the power source and
allow the machine to stop.
Remove the battery pack
from the machine and take
the following steps before
restarting and operating the
9
EN
machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii) check for and tighten any
loose parts.
f) If the machine becomes
clogged, shut-off the
power source and remove
the battery pack from the
machine before cleaning
debris.
g) Never operate the machine
with defective guards or
shields, or without safety
devices.
h) Keep the power source
clean of debris and other
accumulations to prevent
damage to the power
source or possible fire.
i) Do not transport this
machine while the power
source is running.
j) Always disconnect the
machine from the power
supply (e.g. remove the
battery pack from the
machine)
- whenever you leave the
machine,
- before clearing blockages
or unclogging chute,
- before checking, cleaning
or working on the machine.
k) Avoid using the machine
10
EN
in bad weather conditions
especially when there is a
risk of lightning.
4)Maintenance and storage
a) keep all nuts, bolts and
screws tight to be sure the
appliance is in safe working
condition.
b) Replace worn or damaged
parts.
c) Use only genuine
replacement parts and
accessories.
d) Store the machine in a dry
place out of the reach of
children.
e) When the machine is
stopped for servicing,
inspection, or storage, or
to change an accessory,
shut off the power source,
disconnect the machine
from the supply and make
sure that all moving parts
are come to a complete
stop. Allow the machine
to cool before making any
inspections, adjustments,
etc. Maintain the machine
with care and keep it clean.
f) Store the machine in a dry
place out of the reach of
children.
g) Always allow the machine to
cool before storing.
Autres manuels pour MAKERX WX747
1
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels Worx Ventilateur
Worx
Worx WG506 Manuel utilisateur
Worx
Worx WG500E Manuel utilisateur
Worx
Worx WG505E Manuel utilisateur
Worx
Worx WG502E Manuel d'installation
Worx
Worx WX093L Manuel utilisateur
Worx
Worx WG500 Manuel utilisateur
Worx
Worx WG505E Manuel utilisateur
Worx
Worx WG510 Manuel utilisateur
Worx
Worx WX094 Manuel utilisateur
Worx
Worx WG517E Manuel d'installation
Worx
Worx WX094.9 Manuel d'installation
Worx
Worx WG500E Manuel utilisateur
Worx
Worx WG507 Manuel utilisateur
Worx
Worx WG545 Manuel utilisateur
Worx
Worx WG509 Manuel utilisateur
Worx
Worx WG546E Manuel utilisateur
Worx
Worx WG583E Manuel utilisateur
Worx
Worx WG568E Manuel utilisateur
Worx
Worx WG504E Manuel d'installation
Worx
Worx WG513 Manuel utilisateur
