6
Installation Instructions
Instructions provided below relate to the diagram on page 5.
This vertical planter kit is modular and can be installed in many
formations.
1. Check the vertical surface is sturdy.
Attach bottom battens 2A & 2B:
1. Measure and mark up surface location for bottom
battens 2A & 2B.
2. Drill screw holes through battens 2A & 2B using a drill and
8mm drill bit.
3. Mark up rawl plug locations 3A & 3B, drill a hole to depth
of approx. 4cm and insert rawl plugs.
4. Using a spirit level, attach bottom battens 2A & 2B using
a screwdriver and batten screws x4.
Attach bottom planter sets 1A & 1B:
1. Attach bottom planter sets 1A & 1B to bottom battens
2A & 2B using planter screws x6.
2. Stack six planter sets on top of each other (in 3 rows of 2).
Attach middle battens 2C & 2D:
1. Using middle planter sets 1C & 1D mark location for
middle battens 2C & 2D. This should be 35cm above
bottom battens 2A & 2B and offset 7cm to the left.
2. Remove middle planter sets 1C & 1D then drill screw holes
through battens 2C & 2D using a drill and 8mm drill bit.
3. Mark up rawl plug locations 3C & 3D, drill holes to depth
of approx. 4cm and insert rawl plugs.
4. Using a spirit level, attach middle battens 2C & 2D using
a screwdriver and batten screws x4.
