Whispbar K680W Manuel utilisateur
K680W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 8 x 8 x 4
x 4 x 4 x 1
Revision No: 2B 1
Fitting Kit K680W
MAX kgs (lbs)
W/P WHD
Nissan
Pathfinder R51, 5dr SUV 05-12 US 75 kgs (165 lbs)
Pathfinder R51, 5dr SUV 05-12 ZA 75 kgs (165 lbs)
Pathfinder R51, 5dr SUV 05-12 EU 75 kgs (165 lbs)
Pathfinder R51, 5dr SUV 05-Sep 13 AU 75 kgs (165 lbs)
Pathfinder R51, 5dr SUV 05-Sep 13 NZ 75 kgs (165 lbs)
2
Fitting Kit EN
K680W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●Remove plastic screws as shown.
●Place bracket over holes.
●Fit the M6 socket head screw and M6
washer.
●Use hex key to tighten.
●Repeat for all four positions.
3
Fitting Kit EN
K680W
●Ensure the roof rack face towards the front
of vehicle.
●Use keys to remove covers.
●While holding the key in the vertical
position, pull the cover towards you to
remove the cover.
●Repeat for all legs.
●Extend the leg out.
●Remove Hex Key by lifting and sliding out.
4
Fitting Kit EN
K680W
●Remove as shown.
●Remove clamp from leg.
●Store items away in a safe place.
Fitment
●Spacer 808A: Position as shown
●Repeat for all four positions.
5
Fitting Kit EN
K680W
●Crossbars should be parallel to each other
and sit perpendicular to the roof rails.
●Repeat on other crossbar.
●Place screw into position.
●Screw small end of M8 flange nut onto M8
screw approximately 3 turns.
●Repeat for all four positions.
●Once crossbars are in position, tighten
screw to 3 Nm (2.2 ft lb).
●Repeat for all legs.
6
Fitting Kit EN
K680W
●Slide Hex Key back into position into one of
the roof rack legs.
●Ensure the locks on the legs are in the
locked position (horizontal).
●Slide cover into the leg, You will hear a
'click' when the cover is securely locked.
●Repeat for all four positions.
●Check crossbar is securely attached to the
vehicle.
7
Fitting Kit EN
K680W
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
8
Fitting Kit EN
K680W
Maintenance
●Long loads should be secured with non-
elastic straps to the front and rear of the
vehicle.
●Objects with pointed ends (e.g. ski poles)
should be carried with the pointed ends to
the rear of the vehicle.
●Remove all loose or removable objects
from the load prior to loading.
●Make sure all loads are securely fastened
with non-elastic straps. Check regularly
during longer journeys.
●A loaded roof rack system can alter the
performance of your vehicle. Be especially
aware of the effects of side winds,
changing of direction, and braking
performance. Avoid rapid acceleration and
deceleration. Drive carefully.
●Note that the total height of the vehicle
increases when upright loads are carried.
●Products should be locked during transport
if they have locks fitted.
●Check and replace worn out or defective
parts.
●Keep the product clean and maintained.
●Never drive into a car wash with the roof
rack system fitted.
●Lubricate locks and adjusting screws at
regular intervals.
●Remove the products from the vehicle
when not in use. Make sure all loose parts
are stored safely.
●Clean the car roof and surfaces of the
product that will be in contact with the car
roof.
●Follow the fitting instructions for fitting the
product to your vehicle. Make sure all steps
are carried out in order.
●Set crossbars a minimum distance of
700mm (27 1/2") apart where no other
distance is specified in the fitting
instructions. This is especially important
when carrying long loads.
●Check unit is securely attached whenever
you refit it to the vehicle. If the unit feels
loose, refer to the fitting instructions and
readjust.
9
Fitting Kit EN
K680W
●Some glass/panoramic roofs and radio
antennae may not be able to be used when
the product is fitted.
●Do not modify this product.
●Refer to the maximum permitted load
capacity specified in the fitting instructions.
Do not exceed the vehicle manufacturers
roof load rating if it is lower than the
maximum load capacity specified in the
fitting instructions.
●Loads should not overhang the sides of the
product and be evenly distributed with the
lowest possible centre of gravity.
Accessories Available for this Product:
●Roof Box
●Ski, Snowboard Carrier
●Canoe, Kayak Carrier
●Bicycle Carrier
●For more accessories please see our
product catalogue.
●Yakima Australia Pty Ltd
17 Hinkler Court
Brendale QLD 4500
AUSTRALIA
www.whispbar.com
www.whispbar.com.au
www.whispbar.co.nz
www.whispbar.co.uk
www.whispbar.co.za
www.whispbar.eu
www.whispbar.ca
10
Table des matières
Autres manuels Whispbar Accessoires automobiles
Whispbar
Whispbar K603W Manuel utilisateur
Whispbar
Whispbar WB300 Manuel utilisateur
Whispbar
Whispbar K376W Manuel utilisateur
Whispbar
Whispbar K174W Manuel d'utilisation et d'installation
Whispbar
Whispbar K491W Manuel utilisateur
Whispbar
Whispbar K867W Manuel utilisateur
Whispbar
Whispbar K832W Manuel utilisateur
Whispbar
Whispbar K665 Manuel utilisateur
Whispbar
Whispbar K762W Manuel utilisateur
Whispbar
Whispbar K157W Manuel utilisateur
Whispbar
Whispbar K888W Manuel utilisateur
Whispbar
Whispbar K419W Manuel utilisateur
Whispbar
Whispbar K781W Manuel utilisateur
Whispbar
Whispbar K036W Manuel utilisateur
Whispbar
Whispbar K046W Manuel utilisateur
Whispbar
Whispbar K359W Manuel d'utilisation et d'installation
Whispbar
Whispbar K822 Manuel utilisateur
Whispbar
Whispbar K145W Manuel d'utilisation et d'installation
Whispbar
Whispbar K423W Manuel utilisateur
Whispbar
Whispbar K587W Manuel utilisateur
