Whispbar K057W Manuel utilisateur

K057W

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 1 x 4

Revision No: 5C 1

Fitting Kit K057W

MAX kgs (lbs)

W/P WHD

Peugeot

405 , 4dr Sedan Feb 89-Aug 96 AU 50 kgs (110 lbs) 50 kgs (110 lbs)

405 , 4dr Sedan Jul 87-Feb 93 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)

405 , 5dr Wagon Oct 87-Jun 93 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)

Fitting Kit EN

K057W

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K057W

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K057W

●Remove locking screw.

●Cut protective strip in four equal lengths.

●Apply protective strip as shown.

Trim if required.

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

Fitting Kit EN

K057W

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

●Fit rubber pad (supplied with crossbar) to

foot.

●Make sure the pad fits into the holes

underneath the foot.

Fitting Kit EN

K057W

Fitment

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Clamps under rubber door frame

mouldings

●Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

●Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight.

Fitting Kit EN

K057W

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

●Use keys to fit and lock covers

Fitting Kit EN

K057W

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Fitting Kit EN

K057W

Maintenance

●Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

●Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

●Set crossbars a minimum distance of

700mm (27 1/2") apart where no other

distance is specified in the fitting

instructions. This is especially important

when carrying long loads.

●Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

●Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

●Do not modify this product.

●Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the

fitting instructions.

●Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

●Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

●Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

●Remove all loose or removable objects

from the load prior to loading.

●Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

●A loaded roof rack system can alter the

performance of your vehicle. Be especially

aware of the effects of side winds,

changing of direction, and braking

performance. Avoid rapid acceleration and

deceleration. Drive carefully.

●Note that the total height of the vehicle

increases when upright loads are carried.

●Products should be locked during transport

if they have locks fitted.

Table des matières

Autres manuels Whispbar Accessoires automobiles

Whispbar

Whispbar K182W Manuel utilisateur

Whispbar

Whispbar K490W Manuel utilisateur

Whispbar

Whispbar K501W Manuel utilisateur

Whispbar

Whispbar K500W Manuel utilisateur

Whispbar

Whispbar K484W Manuel utilisateur

Whispbar

Whispbar K062W Manuel utilisateur

Whispbar

Whispbar K748W Manuel utilisateur

Whispbar

Whispbar K396W Manuel utilisateur

Whispbar

Whispbar K538W Manuel utilisateur

Whispbar

Whispbar K618W Manuel utilisateur

Whispbar

Whispbar K838W Manuel utilisateur

Whispbar

Whispbar K375W Manuel utilisateur

Whispbar

Whispbar K371W Manuel utilisateur

Whispbar

Whispbar K827W Manuel utilisateur

Whispbar

Whispbar S52W Manuel utilisateur

Whispbar

Whispbar K719W Manuel utilisateur

Whispbar

Whispbar K600W Manuel utilisateur

Whispbar

Whispbar K909W Manuel d'utilisation et d'installation

Whispbar

Whispbar K581W Manuel d'utilisation et d'installation

Whispbar

Whispbar K377W Manuel d'utilisation et d'installation

Whispbar

Whispbar K501W Manuel utilisateur

Whispbar

Whispbar K382W Manuel utilisateur

Whispbar

Whispbar K127W Manuel utilisateur

Whispbar

Whispbar K510W Manuel d'utilisation et d'installation

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur

Prorack

Prorack K1163 Manuel utilisateur