Wharfedale Pro WF-300 Manuel utilisateur
1 - Press the “SET” key for 3-5 seconds. When the frequency point flashes on the LCD, press the up
or down keys to select the frequency point.
2 - After selecting the frequency point (channel), press the “SET” button. The LCD will display F——.
Place the microphone you wish to synchronise with near to the IR sensor on the front of the WF-300
rack. The LCD of the microphone should face the rack.
3 - Now check the LCD display of the microphone. The channel shown on the mic should now be the
same as the channel shown on the receiver. Now it is ready to use.
5 - On - Off switch: Press and hold for 2 seconds
to turn the mic ON & OFF.
6 - EQ Selection Button: Unscrew the tail pipe of
the microphone and press the button to cycle
through the 5 EQ curves.
Note - The microphone features a gyroscope which
senses movement. This means the microphone will
mute itself after being left for 5 seconds and then
will unmute automatically when picked up.
When the mic is automuted the display will show
" - - - - -"
To turn this feature ON or OFF hold the EQ selection
button for 2 seconds until it says ("AG ON" or "AG OFF”)
Autres manuels pour WF-300
1
Autres manuels Wharfedale Pro Microphone
Wharfedale Pro
Wharfedale Pro USX 800 Manuel utilisateur
Wharfedale Pro
Wharfedale Pro USX 800 Manuel utilisateur
Wharfedale Pro
Wharfedale Pro KM Series Mode d’emploi
Wharfedale Pro
Wharfedale Pro DM 3.0 Manuel utilisateur
Wharfedale Pro
Wharfedale Pro DM-6.0 Manuel utilisateur
Wharfedale Pro
Wharfedale Pro DM 2.0 Manuel utilisateur
Wharfedale Pro
Wharfedale Pro KM-1 Mode d’emploi
Wharfedale Pro
Wharfedale Pro DM4.0 Manuel utilisateur
