Webasto Thermo Top E Manuel

Dear Webasto customer!

We presume that the principle and mode of operation of your new heater has been explained

to your complete satisfaction by the workshop / service centre which installed the heater. This

manual summarizes the main points of importance for using the heaters Thermo Top E, C

and P.

The water heaters Thermo Top E, C and P have been type-tested and approved in accordance

with Directives 2001/56/EC (heaters) and 72/245/EEC (EMC) within the territory governed by

European Directive 70/156/EEC.

The units must be installed in accordance with the enclosed installation instructions.

The heater must not be operated :

• In filling stations and tank farms.

• At locations at which highly flammable gases or dusts can

form, and at locations at which highly flammable liquids or

solid materials are stored (e.g. near fuel, coal and wood

dust, grain warehouses, dry grass and leaves, cardboard ,

paper, etc.)

• In enclosed rooms (e.g. garages), not even via the timer or

Telestart.

The heater must not:

• be exposed to temperatures of more than 120 °C (storage

temperature), otherwise the electronics may suffer

permanent damage.

• be operated without at least 20% brandname anti-freeze in

the water of the heating circuit.

General information

Maintenance and safety instructions

Danger of explosion

and suffocation!

Operating and maintenance

instructions

Thermo Top E

Thermo Top C

Thermo Top P

The heater must:

• be operated with the fuel specified on the rating plate and

at the nominal voltage specified on the rating plate.

• be taken out of operation by removing the fuse if smoke

develops, if unusual burning noises are heard or if there is a

smell of fuel.

The heater must not be restarted until the unit has been

checked by personnel duly trained by Webasto.

• be operated for 10 minutes at least once per month, with

the engine cold and the fan set to the minimum setting.

The heater must be inspected by a specialist at the

beginning of the heating season or earlier.

Liability:

• Non-compliance with the installation instructions and the

warnings contained therein will lead to the exclusion of all

liability by Webasto. The same also applies if repairs are not

undertaken by professionals or without using genuine spare

parts. This invalidates the type approval for the heater and

its homologation / EC type permit.

The heater can be started via the timer or Telestart unit, depending on its configuration. If no

special instructions on adjusting the vehicle heating during auxiliary heater operation are

available, then the vehicle heating must be set to "warm" before switching on the heater.

The heater fan in the vehicle should be set to the 1st speed in the case of a 3-speed

fan and to the 2nd speed in the case of a 4-speed fan. Fans with infinitely variable

speed should be set to at least 1/3 of the fan performance.

NOTE:

We recommend that the heating time be set in accordance with the driving time.

Heating time = driving time

Example: For a journey lasting approx. 20 minutes (one way), the duty period should

not exceed 20 minutes.

If the optional summer / winter switch has been installed for the heater, it must be set in

accordance with the time of year. In this case, the heater will heat the interior of the vehicle

when set to the winter position and merely operate the vehicle fan to ventilate the

interior of the vehicle when set to the summer position .

Operation of the heater

If a fault occurs, check that the fuses and plug connections are in perfect condition and

secure.

When a fault occurs, the heater switches to the fault interlock; an error is not indicated on

the clock display.

Always try to cancel the fault interlock before calling a Webasto service centre.

The following faults can be remedied directly by the user:

Note:

The heater switches on again when the fuse is refitted.

Please contact a Webasto service centre if the fault cannot be remedied in this way.

Fault description Possible cause Remedy

Heater switches off

automatically (= fault lock-

out)

No combustion after

starting and restarting.

Flame goes out during

operation.

Switch off heater and switch

on again (not more than

twice).

Heater does not switch on. Heater is without electric

power.

Check power supply to heater

and ground connections.

Heater switches off during

operation (= fault lock-out).

Heater has overheated

due to lack of coolant.

Refill coolant as directed by

manufacturer.

Interrupt power

supply by removing

the 20 A fuse

(yellow) in the

heater cable

harness

Refit the fuse. Briefly press ON button

on transmitter on left or

press buttton on

timer

Interrupt power

supply by

removing the 20 A

fuse (yellow) in the

heater cable

harness

Refit the fuse.

The heater

switches on

again.

Action in the event of faults

To cancel the fault interlock

Wait

approx.

3 s

Wait

approx.

Wait

approx.

Webasto AG

Postfach 80

D - 82131 Stockdorf

Germany

Phone: (+44) 1302 322232

Fax: (+44) 1302 322231

www.webasto.com

Ident-No. 9000814D • 07/09 • Errors and omissions excepted • Printed in Germany • © Webasto AG, GCS 2009

Autres manuels pour Thermo Top E

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Webasto Chauffe-eau

Webasto

Webasto Thermo Top E Manuel de l'opérateur

Webasto

Webasto DBW 2010 Manuel du propriétaire

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto thermotop E Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto Thermo 230 Manuel utilisateur

Webasto

Webasto thermo top evo Manuel de l'opérateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto thermo top evo Manuel de l'opérateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto Thermo Top C Manuel utilisateur

Webasto

Webasto GBW 300 Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto BBW 46 Manuel utilisateur

Webasto

Webasto Thermo 90 ST Manuel utilisateur

Webasto

Webasto Thermo 90 S Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto Thermo Top Z Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel utilisateur

Webasto

Webasto Thermo 90 Manuel utilisateur

Webasto

Webasto Thermo Top Pro 120 Manuel utilisateur

Webasto

Webasto Thermo Top E Manuel de l'opérateur

Webasto

Webasto Thermo Top C Manuel utilisateur

Manuels Chauffe-eau populaires d'autres marques

Kenmore

Kenmore 153.582400 Manuel utilisateur

Applimo

Applimo Edel AIR Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manuel utilisateur

clage

clage E-Mini Series Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-180 Manuel utilisateur

Bradford White

Bradford White EF Series Manuel utilisateur

Eccotemp

Eccotemp 40-H Manuel utilisateur

Dimplex

Dimplex ECSd125-580 Mode d’emploi

Dux

Dux 32FCR6N Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guide de dépannage

Noritz

Noritz N-132M Manuel d'instructions

TESY

TESY GCV7/4S 10047 Fiche technique

A.O. Smith

A.O. Smith Gphe 50 Manuel utilisateur

Koryo

Koryo KWHZF15Y Manuel utilisateur

Pentair

Pentair PSC-14-4-02 Manuel utilisateur

GE 40M06AAG Instructions de montage

Thermor

Thermor AEROMAX SPLIT 2 Manuel utilisateur

American Hometec

American Hometec AHQ-B03X Manuel utilisateur