14. DO NOT switch on if water leaks from the main enclosure. Isolate the
electrical supply to the INSTA-80 Supreme immediately.
15. DO NOT switch on if there is a possibility that the water in the INSTA-80
Supreme is frozen.
16. The INSTA-80 Supreme can deliver scalding temperatures if not operated,
installed or maintained in accordance with the instructions, warnings and
cautions contained in this guide.
17. Rapid or excessive operation of the INSTA-80 Supreme controls may result
in high or unstable outlet water temperatures. Operate controls gradually
and allow 5-10 seconds for water to heat.
18. The INSTA-80 Supreme is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning the use of the INSTA-80 Supreme by a person
responsible for their safety.
19. Children should be supervised to ensure that they do not play with the
INSTA-80 Supreme.
20. Always switch off the INSTA-80 Supreme at the electrical isolating switch
when not in use for long periods.
21. If the INSTA-80 Supreme is not to be used for a long period, the water
supply to the INSTA-80 Supreme must be isolated. If the INSTA-80 or pipe-
work is at risk of freezing during this period, they should also be drained of
water.
22. The INSTA-80 Supreme is suitable for use with most point of use water
outlets including, Kitchen Taps, Push taps, Sensor Taps, Low Flow
Showerheads.
23. If any of the following conditions occur, isolate the electricity and water
supplies and refer to “To contact us”, on the back page of this guide.
If the INSTA-80 Supreme is damaged
If water leaks from the INSTA-80 Supreme
If the MCB trips continuously
If the INSTA-80 Supreme begins to make an odd noise, smell or
smoke
If the INSTA-80 Supreme shows signs of a distinct change in
performance indicating a need for maintenance
If the INSTA-80 Supreme is frozen
24. The INSTA-80 Supreme water heater complies with all the relevant
directives for CE Marking.
