3
Mesures de sécurité / Safety Precautions / Maintenance advices
AISI 316L,
2001/95/EC .
, .
pH (6,7 / 7,6).
The bike is made of anodized aluminium and marine quality AISI 316L stainless steel conforming to standard
2001/95/EC on the general safety of products. Its anti-corrosion treatment makes it suitable for chlorinated
water, seawater and thermal waters. It does not require any special care in pH-controlled water (6.7 / 7.6).
1. , ’ .
Remove the bike after every use, rinse it with soft water, and wipe it.
2. pH ( pH 7,2).
Regularly check the pH of your swimming pool (pH 7.2 advisable)
3. .
, , (
).
Remove the bike during manual dosages of chemical products or impact treatments. Keep the bike away to
avoid any splashes that can stain or any deposits (due to the concentration of chemical products).
4. , , , .
Deposits of powder, salt, corrosive products that encourage the corrosion process.
5. ( ),
,
.
When rst cleaning the surfaces of the swimming pool (before lling it) as well as subsequent maintenance
cleaning, it is advised that you remove the bike from the pool so as to avoid any risk of stains or deposits.
6. , ’
, , ,
.
When you are not using the bike, it must be rinsed thoroughly with soft water, then dried and stored in a location
away from chemical products, as well as equipment used for dosing chemical products for pool maintenance.
7. ,
’ . .
If there are lime-scale deposits or stains, these can be removed with a cleaner for anodized aluminum and a
non-abrasive soft cloth. Then wash with clean water and dry it completely.
8. , ,
.
When you put the bike on the water, hold back the bike for prevent impact and damage to your pool or your
bike.
. 6,7 7,6.
- , pH, .
( , )
WARNING
Check the pH of the water on each utilisations. The pH water should be between 6.7 and 7.6.
Any damages caused by a wrong pH balance cancel the warranty.
(For anodized aluminum, inox parts, and silicone parts)
