Wasserstein Smart Floodlight Manuel utilisateur

Smart Floodlight

User Manual

Page 1

In the Box

1 x smart ﬂoodlight

1 x ring and nut set

2 x machine screws

(M4 * 25mm)

3 x wire nuts

1 x crossbar

1 x EVA gasket

• As the temperature changes, the detection distance will be

affected.

• Do not mount the near a heat source like an air conditioner,

vent, furnace, exhaust, or in a direction facing any reﬂective

object / other nearby light source.

• Shut off power at the circuit breaker or fuse panel before

removing the old ﬁxture or installing the new one.

• LEDs can be damaged by electric static. Before installing,

discharge any static from your body by touching a grounded

bare metal surface.

• To avoid damage, do not remove the clear lens over the LED

module.

Page 2

• Please read this entire manual before attempting to

assemble, operate, or install the product.

• Floodlight MUST be installed by a qualiﬁed electrician.

• Turn power OFF before installing.

• Do NOT touch or install ﬁxture near water or if the

surrounding area is wet.

• Do NOT remove the protective LED lens.

• Do NOT look directly at lit LEDs for any length of time.

• Do NOT leave bare wires exposed.

• Electrical requirements: 120V, 60 Hz

• Do NOT allow the sensor head to touch the LED head

housing. Maintain at least 1 inch of space between the LED

heads and the sensor head.

• For proper operation and protection against water damage,

the motion sensor adjustment controls MUST be facing

downward.

• Do NOT mount below 5 ft.

Safety Instructions

Warnings

Page 3

2. Remove the protective layer from the EVA gasket and stick it

ﬁrmly on the back of the ﬂoodlight (make sure the long screw

at the crossbar goes through the center hole and the wires go

through the gasket opening).

Caution:

The ﬂoodlight must be installed by a qualiﬁed electrician. Your

main circuit breaker MUST be turned off before installing.

How to Install

1. Attach the crossbar to the junction box using the two machine

screws provided.

Page 4

3. Connect the yellow/green (ground) wire from the ﬂoodlight to

the junction box using the ground screw (painted green).

Connect the white wires (neutral) with a wire nut. Connect the

black wires (hot) with a wire nut.

4. Carefully place wires into the junction box. Place ﬂoodight

over the crossbar. Mount the ﬂoodlight onto the crossbar and

secure it with the nut and ring provided.

Note:

For further weatherprooﬁng, ﬁll all gaps with a sealing compound

or silicon glue.

Page 5

Minimum requirements:

• Smartphone or tablet running iOS 9.0 or later / Android

5.0 or later.

• 2.4 GHz WiFi Network (not compatible with 5 GHz

connections).

• Upload speed of at least 2 Mbps.

1. Download the App by scanning the QR code or by searching

"Wasserstein App" in Google Play or the App Store.

2. Sign up for a new account or log in to an existing account.

3. Click "Add Device" or "+" in the top right corner. You can add

your device by selecting "Add Manually" or "Auto Scan".

App Setup

Page 6

Figure 1

Flash Dim Flash Dim

1. Select "Lighting" - "PIR Light（BLE+WiFi)".

2. Reset the ﬂoodlight by turning it on and off in the following

sequence: on-off-on-off-on (steps also displayed in your App).

Then, your ﬂoodlight will ﬂash in intervals (Figure 1).

Add Manually

selection

If the light is flashing already,

please skip the reset steps.

Resetting the device:

1. Power on the device.

2. Turn on-off-on-off-on.

3. Make sure the light is flashing.

Note: Please complete the network

selection within 3 minutes after

resetting the device.

Confirm that the light is flashing.

Page 7

3. Enter your WiFi details, and click "Conﬁrm".

4. Wait until your device has been added successfully.

Wasserstein Smart Floodlight

WiFi Login

WiFi Password

Page 8

1. Reset the ﬂoodlight to enable pairing mode. Turn on and off

in the following sequence: on-off-on-off-on. Your ﬂoodlight

will then ﬂash in intervals.

2. Wait until your ﬂoodlight has been automatically detected.

Auto Scan

Note: Display and interface are subject to change.

Sensor

Manual

On/Off

Light intensity

Floodlight color

Turn on/off timer

Schedule

Sensor

On/Off

Motion detection range

Floodlight light sensitivity

Duration of light ﬂash

Event records

1. Settings

App Functions

Page 9

Table des matières

Autres manuels Wasserstein Projecteur

Wasserstein

Wasserstein Floodlight with Charger Manuel utilisateur

Wasserstein

Wasserstein 3-in-1 Smart Plug-in Floodlight for Blink... Manuel utilisateur

Wasserstein

Wasserstein Solar Floodlight & Charger with Micro USB... Manuel utilisateur

Wasserstein

Wasserstein Floodlight For Google Nest Cam Manuel utilisateur

Wasserstein

Wasserstein 3-in-1 Smart Floodlight, Charger & Mount for Blink Outdoor & Blink XT... Manuel utilisateur

Wasserstein

Wasserstein 3-in-1 Smart Plug-in Floodlight for Arlo Pro 3/Pro 4 and Arlo Ultra/Ultra... Manuel utilisateur

Wasserstein

Wasserstein 3-in-1 Wired Floodlight, Charger and Mount for Blink Outdoor /... Manuel utilisateur

Wasserstein

Wasserstein 2 in 1 - Solar Charger & Security Light Manuel utilisateur

Wasserstein

Wasserstein 3-in-1 Smart Floodlight, Charger & Mount for Wyze Cam... Manuel utilisateur

Wasserstein

Wasserstein Noorio Spotlight Cam B210 Manuel utilisateur

Manuels Projecteur populaires d'autres marques

VIZULO

VIZULO Micro Martin Guide de l'utilisateur

EuroLite

EuroLite LED IP FL-100 SMD Manuel utilisateur

Cooper Wheelock

Cooper Wheelock XB12 Manuel utilisateur

Allen + Roth

Allen + Roth 17624-000 Manuel utilisateur

ADJ

ADJ 4 STAGE PAK Manuel utilisateur

Cooper Lighting

Cooper Lighting EGL91SW233 Manuel utilisateur

Max

Max 37496 Manuel utilisateur

BEGA

BEGA 85 143 Manuel utilisateur

Beamz

Beamz 151.226 Manuel utilisateur

EuroLite

EuroLite LED IP FL-8 Manuel utilisateur

Ledj

Ledj PERFORMER 36 RGB Manuel utilisateur

Perel

Perel ELS3 Manuel utilisateur

Perel

Perel ELS3WD Manuel utilisateur

LumX

LumX LM 36130 Manuel utilisateur

Xtricity

Xtricity 4-80053 Manuel utilisateur

Stahl

Stahl 6521/4 Series Manuel utilisateur

Ecosense

Ecosense EcoSpec Manuel utilisateur

Ayrton

Ayrton minipanel FX Manuel utilisateur