WAPRO WaBack DN110-200 Manuel utilisateur
INSTALLATION INSTRUCTIONS
& PRODUCT GUARANTEE
DN110-200 (NPS 4”-8”)
DN200-315 (NPS 8”-12”)
WaBack DN110-200 is CE approved according to the
European standard for flood protection for buildings
SS-EN13564-1:2002 Type 1 & Type 3*
Please note your product serial number:
WABACK AND WABACK ACCESS
EN
SV
NO
DK
PL
DE
2
PREPARATION
THANK YOU FOR PURCHASING A WAPRO PRODUCT.
FOR FURTHER PRODUCT INFORMATION PLEASE REFER TO
WAPRO.COM.
INDEX
PREPARATION..................................................................................................................................................................2
GENERAL INFORMATION ......................................................................................................................................3
OPTIONAL ACCESSORIES.......................................................................................................................................3
WABACK AND WABACK ACCESS SMALL INSTALLATION INSTRUCTIONS .............. 45
EMERGENCY CLOSURE DEVICE INSTALLATION ...........................................................................67
WABACK MAINTENANCE INSTRUCTIONS............................................................................................... 8
WABACK ACCESS SMALL MAINTENANCE INSTRUCTIONS ........................................................9
WABACK ACCESS LARGE INSTALLATION INSTRUCTION........................................................... 10
WABACK LARGE MAINTENANCE INSTRUCTIONS...................................................................... 1112
GUARANTEE ............................................................................................................................................................ 1315
SERIAL NUMBER:
3
INTRODUKTION
HANDLING
The product is delivered securely fastened on a pallet and must not be tipped off the pallet. When unloading the product,
use the lifting handles mounted on the chamber (Large) or alternatively, place slings around the chamber. The chamber
must be placed on a flat surface during storage.
INSTALLATION
The chamber must be installed at the same angle as the fall of the pipe placed in the sloping part of the pipe since the
product does not have built-in fall. Make sure that the flow direction of the chamber follows the flow direction of the pipe.
WaBack and WaBack Access should be installed as recommended according to the appropriate regulations in each
country. The bottom of the product should be placed at a frost-free depth or a frost guard or similar should be used so
that water does not freeze in the well.
EXTENDING THE HEIGHT OF THE CHAMBER
The height of the chamber is extended with the help of a Wavin riser DN425 or Wavin riser DN1000. Connect a Wavin
reducing cone to the DN1000 riser if a DN640 cover is required.
MANHOLE COVERS
There are different manhole covers available.
Load-bearing (cast iron manhole cover) or non-load-bearing manhole cover (plastic) in sizes DN425 or DN640.
GROUNDWATER PRESSURE
If there is a risk of groundwater pressure, the product must be firmly anchored to prevent floating. This applies to WaBack
Access Large. Use the handles on the product as anchoring points.
The maximum laying depth is 2.5 m from pipe invert to ground level.
RECYCLING
WaBack and WaBack Access Small/Large are made primarily of environmentally-friendly materials. Before disposing of the
product, separate the components for recycling. See the table for how the parts are recycled.
Stainless Steel** PE* EDPM* Polyurethane*
Fasteners Chamber Elbow Floatation arm
* Incinerate
** Metal recycling
OPTIONAL ACCESSORIES
ALARM
Wired and wireless water level alarms are available for purchase separately. The alarm ensures extra protection in the event
of raised water levels. The alarm senses when the water level is over the expected level and emits both a light and sound
signal. The alarm sensor should be mounted in the chamber and the receiver unit should be installed in a building, service
facility or similar. The connection for the wireless alarm between the sender and receiver must be tested before the alarm
is put into service to ensure the signal is not disturbed by any nearby building structure.
RISER
Wavin Tegra: WaBack Access Small DN425. WaBack DN600. WaBack Access Large DN1000
SHUT-OFF PLATE - ACCESS ONLY
The shut-off plate enables the product to function as a shut-off valve. This function enables the pipe to be closed off for
service and maintenance.
REDUCER
Tegra DN1000 Cone
MANHOLE COVER
Manhole cover: WaBack Access Small DN425, WaBack DN640, WaBack Access Large DN1000
4
WABACK AND WABACK ACCESS SMALL INSTALLATION INSTRUCTIONS
WABACK
34
1
CLASS 2, TABLE C1, MARK AMA
2
4
2
WABACK ACCESS SMALL
X = OPENING PRESSURE x 1.25
5
WABACK AND WABACK ACCESS SMALL INSTALLATION INSTRUCTIONS WABACK AND WABACK ACCESS SMALL INSTALLATION INSTRUCTIONS
6
78
5
6
WABACK EMERGENCY CLOSING *FOR TYPE 3 APPROVAL
1
3
5
2
4
Attach the eyelet bolt
150+/-5mm from the
bottom of the riser using
the washer and nut
included.
*WaBack Standard only
Attach the console
400mm +/-30mm from
the top of the riser using
the washers, bolts and
nuts included. One
washer on each side of
the riser.
7
WABACK EMERGENCY CLOSING *FOR TYPE 3 APPROVAL
6
WABACK EMERGENCY CLOSING
7
9
8
Attach the console 400mm +/-
30mm from the top of the riser
using the washers, bolts and nuts
included. One washer on each side
of the riser.
8
WABACK MAINTENANCE
34
1
6
2
5
2 X / YEAR OR AS REQUIRED
9
WABACK MAINTENANCE WABACK ACCESS SMALL MAINTENANCE
4
3
2
1
2 X / YEAR OR AS REQUIRED
10
WABACK ACCESS LARGE INSTALLATION INSTRUCTIONS
2
1
4
3
5
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels WAPRO Dispositif de protection
Manuels Dispositif de protection populaires d'autres marques
nxt
nxt BIA-nXt-DPC 1-22 Manuel utilisateur
TFortis
TFortis SG-Switch Manuel utilisateur
BERNINI DESIGN
BERNINI DESIGN Be172 Manuel utilisateur
Rayleigh Instruments
Rayleigh Instruments RI-ENERGYSET-3P-ESS-50-100 Manuel utilisateur
GE
GE Multilin 3 Series Manuel utilisateur
E.K.T.
E.K.T. ke-DP01 Manuel utilisateur
