Wahl MINI PRO Manuel utilisateur
1
MINI PRO
TRIMMER
2
Wahl salon innovations
Where the world goes to look good.
Please read this instruction manual carefully and
familiarise yourself with your new WAHL Mini Pro
before using for the rst time.
READ ALL INSTRUCTIONS BEFORE USING.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety
precautions should always be followed, including the
following:-
1. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of
the appliance by a person responsible for their
safety. Children should always be supervised to
ensure they do not play with the appliance.
2. Use this trimmer only for its intended use, as
described in this manual. Do not use attachments
not recommended by the manufacturer.
3. Do not use this trimmer with a damaged or broken
blade as injury may occur.
4. When discarding an old battery, do not throw it into
re where heat could cause it to rupture or explode.
Also do not attempt to recharge alkaline, heavy
duty or regular batteries in a battery charger.
OPERATING INSTRUCTIONS
BATTERY INSTALLATION
1. Remove battery cover from trimmer by pushing in
and back on the battery cover in the direction of the
arrow.
2. Important: Be sure to insert the negative (-) end of
each battery rst, so that it depresses the spring
at the top of the battery compartment. Then slide
the positive (+) end into position. Do not allow the
negative terminal clips to bend and cut the casing
of the batteries.
3
Use alkaline batteries with your Wahl product. Alkaline
batteries will provide the longest operating time before
battery replacement is needed.
3. Replace the battery cover to its original position.
4. Move switch to ‘ON’ position.
5. To maximize battery life, trimmer should be shut off
immediately after using.
TROUBLESHOOTING
If your product fails to operate when switched ‘ON’
check your batteries to see if they are properly
installed. Positive end should be located as shown in
battery housing. Make sure switch is in the ‘ON’
position and check to be sure blades are free to move.
If baldes become clogged, manually pushing the
blades back and fourth few times while unit is turned
‘OFF’ may help free the blades and allow the trimmer
to operate. If it still does not operate, your batteries
have probably exceeded their useful life.
BEFORE CUTTING HAIR
1. Your product should be clean, oiled and in perfect
working condition.
2. Position the person whose hair is to be cut on a
stool or chair so that the top of the head is about
even with your eyes.
3. After combing the hair to remove all tangles, hold
the product in relaxed, comfortable grip, with the
nameplate under the palm near your index nger.
This grip will help you maintain comfortable,
accurate cutting control.
ATTACHING GUIDE COMBS
Align comb onto to blade then press tab until it clicks
into position.
Wahl salon innovations
Where the world goes to look good.
4
Wahl salon innovations
Where the world goes to look good.
CUTTING HAIR
For Medium to Long Cuts
The rst time you cut the hair, cut only a small amount
until you become accustomed to how long each guide
comb leaves the hair. Always start by placing the
largest guide comb on the clipper, then use shorter
combs if a shorter length is desired.
Remember between professional haircuts, the hair
grows evenly all over the head and a light trimming at
the lower neck and sides may be all that is needed to
bring back that neat, well groomed look.
1. Start by combing the hair so it falls into its natural
direction.
2. Place the largest comb onto your product and start
by trimming the sides from the bottom upwards.
Hold the product lightly against the hair, with the
teeth of the guide comb pointing up but at against
the head. Slowly lift the trimmer up and outward
through the hair, cutting only a small amount at a
time.
Repeat around sides and back of head.
If you desire shorter hair, either change to a shorter
guide comb, or apply more pressure and less lift away
from head with the present attachment.
The entire procedure requires practice, and it is always
better to leave to much hair the rst few haircuts.
For the top of the head, you will give a fairly short cut
if you use the No.1 guide comb. With the teeth at
against the head, slowly start trimming from the front to
the back. Again, it is better to leave the hair longer the
rst few haircuts.
For Longer Hair on Top:
By not using a guide comb, a longer cut can be
achieved. Use either a barber comb or a regular comb
and lift the hair on top of the head, cutting over the
comb, or grasp the hair between the ngers and cut to
desired length.
5
Wahl salon innovations
Where the world goes to look good.
Continue this procedure from the front to the back of
the head, gradually cutting the hair shorter by reducing
space between the comb or ngers and the head.
Comb frequently to remove trimmed hair and check for
uneven strands.
Tapering Around Ears:
Using left and Right Ear Guide Combs:
The left and right ear guide combs have a built in taper
ranging from 1/8” to ½”. By following the outline of the
ear with the appropriate comb you achieve a gradual
taper and blending without having to use multiple
combs.
To Taper the Area Bordering the Left Ear:
Attach the left ear taper comb to your trimmer and
stand facing the left ear. While holding the clipper at a
slight angle against the head, position the guide comb
just back of the left ear at the hairline. Then move the
trimmer in a small half circle pattern around the left ear
toward the front of the head. Depending on the length
of the hair you are working with you may need to take
several small strokes as you proceed around the ear.
When doing so, slowly move the product upward and
outward being mindful of the ear. This will allow you to
guide hair into the comb towards the blades.
NOTE: You may also achieve a tapering of sideburns
by including the sideburn area as you begin to move
the product around the ear.
To Taper the Area Bordering the Right Ear:
Attach the right ear guide comb to your product. Stand
facing the right ear and repeat the process described
above for the left ear.
Finish by outlining the area around the ear as
described in the following section.
6
Wahl salon innovations
Where the world goes to look good.
OUTLINING
No attachments are needed. Comb hair into a desired
style. Starting between the ear and the sideburns,
hold the product with the corner edge of blade against
hairline. Slowly follow the desired outline of the
hair over, around and behind the ears. For dening
sideburns and the back of the neck, hold the product
upside down, against the skin at the desired length
and move down.
Comb hair and check that sides are even. Check for
uneven spots throughout the haircut.
SHORT CUTS
Starting with the longest guide comb, cut from the back
of the neck to the crown. Hold the guide comb at
against the head and slowly move the product through
the hair.
Use the same procedure from the lower side to the
upper side of the head. Then cut the hair against the
direction in which it grows, from the front to the crown
and even up the cut with the sides.
To give a attop look, the hair on top of the head must
be cut over the top of a at comb, rather than using the
guide comb.
Use closer cutting guide combs to taper the hair down
the neckline, as desired. Comb hair and check for
uneven spots. Outline sideburns and necklines as
previously described.
CLEANING AND MAINTENANCE
OIL
The blades of your new product should be oiled before
and after every use. Place a few drops of Wahl Clipper
oil on the teeth of the blades. Use only Wahl Clipper
Oil included in the pack. Do not use hair oil, grease or
any oil mixed with kerosene or any solvent.
7
GUARANTEE
This product is guaranteed against defects in material
and workmanship for a period of 3 Years from the date
of original purchase or receipt as a gift.
The guarantee becomes invalid in the case of misuse
or repair by unauthorised persons.
Should this product become defective during the
warranty period, return it to the store of purchase
together with your proof of purchase for repair or
replacement without any charges to you.
This guarantee in no way affects your rights under
statutory law in the United Kingdom.
PRODUCT REGISTRATION
Wahl are constantly developing and launching new
products in the UK. We would like to understand
your product needs and expectations and we value
any comments you may have. As part of Wahl
Customer Care, we are offering you the chance to
be kept up to date with the latest product launches,
innovations and special offers.
Please take a minute to register your product online
at www.wahl.co.uk
WASTE ELECTRICAL & ELECTRONIC EQUIPMENT
DIRECTIVE 2002/96/EC (WEEE)
At the end of this products life it should not be
disposed of with general household waste.
Care should be taken to dispose of it in a suitable
manner in accordance with your Local Authority
regulation.
Wahl salon innovations
Where the world goes to look good.
8
MINI PRO
TRIMMER
WAHL (UK) LIMITED
HERNE BAY TRADE PARK, SEA STREET
HERNE BAY, KENT, CT6 8JZ.
TECHNICAL SUPPORT TEL: 01227 744331
CUSTOMER CARE TEL: 01227 740066
www.wahl.co.uk
Form No. 58939
Rev0-05/10
Table des matières
Autres manuels Wahl Tondeuse
Wahl
Wahl 8171L Manuel utilisateur
Wahl
Wahl 73509 Manuel utilisateur
Wahl
Wahl Lithium Ion Triple Play 9880 Manuel utilisateur
Wahl
Wahl 9870 Manuel utilisateur
Wahl
Wahl Manscaper Manuel utilisateur
Wahl
Wahl Deluxe Pocket Pro Manuel utilisateur
Wahl
Wahl 05640-100 Manuel utilisateur
Wahl
Wahl Pocket Pro Manuel utilisateur
Wahl
Wahl Ear, Nose & Brow Manuel utilisateur
Wahl
Wahl 9870 Manuel utilisateur
Wahl
Wahl MINI ARCO Instructions d'installation
Wahl
Wahl Blitz Manuel utilisateur
Wahl
Wahl 1080.1010 Manuel utilisateur
Wahl
Wahl 2200 Manuel utilisateur
Wahl
Wahl Lithium-Ion 9860L Manuel utilisateur
Wahl
Wahl Trimmer Manuel utilisateur
Wahl
Wahl COLOR PRO 9891 Manuel utilisateur
Wahl
Wahl ZB031 Manuel utilisateur
Wahl
Wahl GROOMSMAN Manuel utilisateur
Wahl
Wahl 9966 Manuel utilisateur
