Wacker Neuson Cub 200 Mode d'emploi

Repair Manual

Indirect-Fired Air Heater

Cub 200

Cub 300

0179422en 001 1009

0179422EN

notice

All rights, including copying and distribution rights, are reserved.

This publication may be photocopied by the original purchaser of the machine. Any

other type of reproduction is prohibited without express written permission from

Wacker Neuson Corporation.

Any type of reproduction or distribution not authorized by Wacker Neuson Corporation

represents an infringement of valid copyrights. Violators will be prosecuted.

Trademarks

All trademarks referenced in this manual are the property of their respective owners.

Manufacturer

Wacker Neuson Corporation

N92W15000 Anthony Avenue

Menomonee Falls, WI 53051 U.S.A.

Tel: (262) 255-0500 · Fax: (262) 255-0550 · Tel: (800) 770-0957

www.wackerneuson.com

Cub 200/300 Foreword

ghi_tx001204gb.fm 3

Foreword

Machines

covered by

this manual

Machine

documentation

Keep a copy of the Operator’s Manual with the machine at all times.

Use the separate Parts Book supplied with the machine to order replacement

parts.

If you are missing any of these documents, please contact Wacker Neuson

Corporation to order a replacement or visit www.wackerneuson.com.

When ordering parts or requesting service information, be prepared to provide

the machine model number, item number, revision number, and serial number.

Expectations

for

information in

this manual

This manual provides information and procedures to safely operate and

maintain the above Wacker Neuson model(s). For your own safety and to

reduce the risk of injury, carefully read, understand, and observe all instructions

described in this manual.

Wacker Neuson Corporation expressly reserves the right to make technical

modifications, even without notice, which improve the performance or safety

standards of its machines.

The information contained in this manual is based on machines manufactured

up until the time of publication. Wacker Neuson Corporation reserves the right to

change any portion of this information without notice.

Manufacturer’s

approval

This manual contains several references to approved parts, attachments, and mod-

ifications. The following definitions apply:

Approved parts or attachments are those either manufactured or provided by

Wacker Neuson.

Approved modifications are those performed by an authorized Wacker Neu-

son service center according to written instructions published by Wacker Neu-

son.

Unapproved parts, attachments, and modifications are those that do not

meet the approved criteria.

Unapproved parts, attachments, or modifications may have the following conse-

quences:

Serious injury hazards to the operator and persons in the work area

Permanent damage to the machine which will not be covered under warranty

Contact your Wacker Neuson dealer immediately if you have questions about

approved or unapproved parts, attachments, or modifications.

Machine Item Number Machine Item Number

Cub 200 0620204 Cub 300 0620233

Cub 200 0620262 — —

Foreword Cub 200/300

ghi_tx001204gb.fm 4

Cub 200/300 Table of Contents

1 Safety Information 7

1.1 Signal Words Found in this Manual ...................................................... 7

1.2 Safety Guidelines for Operating the Machine ....................................... 8

1.3 Safety Guidelines for Lifting the Machine ............................................. 9

1.4 Safety Guidelines While Using Combustion Burners ......................... 10

1.5 Safety Guidelines for Maintaining the Machine .................................. 11

2 Operation 12

2.1 Controls and Components .................................................................. 12

2.2 Control Panel ...................................................................................... 13

2.3 Starting/Stopping the Machine ........................................................... 14

3 Burner Setup 16

3.1 Control Board Sequence of Operation ............................................... 16

3.2 Setting Up the Burner ......................................................................... 18

3.3 Removing and Installing the Burner Assembly ................................... 21

3.4 Checking and Adjusting the Burner Electrodes .................................. 22

3.5 Checking and Replacing the Burner Nozzle ....................................... 23

3.6 Setting the Air Band ........................................................................... 24

3.7 Checking and Adjusting the Fuel Pressure ........................................ 25

4 Troubleshooting Basics 27

5 Troubleshooting the Blower 28

5.1 Checking the Fuse ............................................................................. 29

5.2 Checking Power to/from the Control Board ........................................ 31

5.3 Checking the ON-OFF Switch ............................................................ 33

5.4 Checking the Capacitor ...................................................................... 35

Table of Contents Cub 200/300

ghi_br0179422en_001TOC.fm 6

6 Troubleshooting the Burner 37

6.1 Checking the Ignition Transformer ......................................................39

6.2 Checking the Cad Cell .........................................................................42

6.3 Checking the Fuel Filter Heater ...........................................................44

6.4 Checking Output Voltage from the Control Board ...............................46

6.5 Checking the Air Pressure Switch .......................................................48

6.6 Checking the Fuel Solenoid ................................................................51

6.7 Checking the Flame Head ...................................................................54

6.8 Checking the Fuel Flow from the Nozzle .............................................55

6.9 Checking the Fuel Lines ......................................................................57

6.10 Checking the Fuel Pump Adapter .......................................................58

7 Schematic 59

7.1 Cub 200/Cub 300 Schematic ..............................................................59

Cub 200/300 Safety Information

ghi_si000343gb.fm 7

1 Safety Information

1.1 Signal Words Found in this Manual

NOTICE: Used without the safety alert symbol, NOTICE indicates a situation

which, if not avoided, could result in property damage.

Note: A Note contains additional information important to a procedure.

This is the safety alert symbol. It is used to alert you to potential personal hazards.

fObey all safety messages that follow this symbol.

DANGER

DANGER indicates a hazardous situation which, if not avoided, will result in death

or serious injury.

fTo avoid death or serious injury from this type of hazard, obey all safety mes-

sages that follow this signal word.

WARNING

WARNING indicates a hazardous situation which, if not avoided, could result in

death or serious injury.

fTo avoid possible death or serious injury from this type of hazard, obey all safety

messages that follow this signal word.

CAUTION

CAUTION indicates a hazardous situation which, if not avoided, could result in

minor or moderate injury.

fTo avoid possible minor or moderate injury from this type of hazard, obey all

safety messages that follow this signal word.

Safety Information Cub 200/300

8 ghi_si000343gb.fm

1.2 Safety Guidelines for Operating the Machine

Operator

training

Before operating the machine:

Read and understand the operating instructions contained in all manuals

delivered with the machine.

Familiarize yourself with the location and proper use of all controls and safety

devices.

Contact Wacker Neuson Corporation for additional training if necessary.

When operating this machine:

Do not allow improperly trained people to operate the machine. People

operating the machine must be familiar with the potential risks and hazards

associated with it.

Machine

condition

Only operate the machine when:

All safety devices and guards are in place and in working order.

All controls operate correctly.

The machine is set up correctly according to the instructions in the Operator’s

Manual.

The machine is clean.

The machine’s labels are legible.

When operating the machine:

Do not modify or defeat the safety devices.

Do not use worn electrical cords.

Do not use faulty fuel supplies.

Guidelines for

operator

When operating the machine:

Remain aware of the machine’s moving parts. Keep hands, feet, and loose

clothing away from the machine’s moving parts.

Wear protective clothing appropriate to the job site when operating the machine.

Wear safety glasses.

When operating the machine:

Do not operate a machine in need of repair.

Do not smoke near the machine.

Work space

When operating the machine:

Position the machine on a firm, noncombustible, level surface.

Keep the area immediately surrounding and underneath the machine clean,

neat, and free of debris and combustible materials.

Keep the area above the machine clear of debris that could fall on the machine.

Store the machine properly when it is not being used.

Keep unauthorized personnel, children, and pets away from the machine.

Cub 200/300 Safety Information

ghi_si000343gb.fm 9

When operating the machine:

Do not connect ductwork between the exhaust outlet port and the supply air inlet

port.

Never operate the machine in areas that contain flammable objects, fuels, or

products that produce flammable vapors.

Do not position the electrical cords under the machine or over the top of the

machine.

1.3 Safety Guidelines for Lifting the Machine

Lifting/

transporting

the machine

When lifting/transporting the machine:

Make sure all lifting devices are attached securely and have enough weight-

bearing capacity to lift or hold the machine safely.

Remain aware of the location of other people when lifting the machine.

Only use the lifting points and tie-downs described in the Operator’s Manual.

Only use suitable transport vehicles with sufficient load-carrying capacity.

When lifting the machine:

Never walk or stand under a suspended machine.

Never climb, sit, or stand on the machine while lifting it or transporting it.

Safety Information Cub 200/300

10 ghi_si000343gb.fm

1.4 Safety Guidelines While Using Combustion Burners

When using the machine:

Clean up any spilled fuel immediately.

Replace the fuel tank cap after refueling the machine.

Refill the fuel tank in a well-ventilated area.

Shut down the generator, if equipped, when refueling.

When using the machine:

Do not fill or drain the fuel tank near an open flame or while the machine is

running.

Do not smoke when refueling the machine.

DANGER

Exhaust gas from the burner contains carbon monoxide, a deadly poison. Exposure

to carbon monoxide can kill you in minutes.

fNever run the machine indoors or in an enclosed area unless the machine is

vented properly.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Wacker Neuson Chauffage

Wacker Neuson

Wacker Neuson E1100 Manuel utilisateur

Wacker Neuson

Wacker Neuson HI 400 HD D Manuel utilisateur

Wacker Neuson

Wacker Neuson E3000 Manuel utilisateur

Wacker Neuson

Wacker Neuson E 2200 Manuel utilisateur

Wacker Neuson

Wacker Neuson Cub 300 HD Manuel utilisateur

Wacker Neuson

Wacker Neuson HDR155 Manuel utilisateur

Wacker Neuson

Wacker Neuson HI 770XHD Manuel utilisateur

Wacker Neuson

Wacker Neuson HI 110HD D Manuel utilisateur

Wacker Neuson

Wacker Neuson HI400HD D Manuel utilisateur

Wacker Neuson

Wacker Neuson HDR115 Manuel utilisateur

Wacker Neuson

Wacker Neuson HI750 Series Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur