W Box Technologies 0E-ICS8 Manuel utilisateur
IN-CEILING
8” SUBWOOFER
0E-ICS8
2
Introduction
Congratulations and thank you for purchasing W Box Technologies
0E-ICS8 In-Ceiling Subwoofer with Sonic Vortex.
Our patented Sonic Vortex Technology is based on Ported Transmission
Line design and incorporates a compact, integrated enclosure. Most
In-ceiling speakers do not utilize a back box, even fewer have an
enclosure, and only a Sonic Vortex speaker has an Integrated
Transmission Line Ported Enclosure. Without something behind the
speaker driver the music not only plays into the room, but also bleeds
into adjoining rooms such as the attic or an occupied room. The bleed
negatively affects performance, and sound consistency.
The Sonic Vortex enclosure directs all of the sound from the speaker
driver into the room it is intend to be in, so you get to enjoy your
speakers without disturbing the rest of the house. Great bass response,
stereo image, and big sound that you can’t get with any other in-ceiling
speaker.
The 0E-ICS8 subwoofer installs with ease using the ‘dog’ mounting
system and magnetic bezelless grills for fast, clean installations.
Please follow the instructions in this manual to assure proper
installation and to achieve the full performance and satisfaction you
would expect from W Box Technologies.
TECHNOLOGY
POWERED BY:
3
Speaker Placement
When installing in-ceiling speakers or subs, (or in-ceiling anything for
that matter) it is always a good idea to nd out what is in the ceiling
before cutting holes. Be aware of the location of plumbing, electrical
and structural elements that may affect speaker placement.
Stereo
It is also a good idea to locate stereo speakers so they are centered to
the main listening position in which the user/s will normally be located.
Whenever possible, try to position the left and right speakers at the
same distance from each other as they are from the main listening
position.
Subwoofer
Subwoofers are omni-directional so placement of in-ceiling subs is
somewhat less critical, but placement can be affected (good and bad)
by corners and walls, so try to nd a location that will be somewhat
unaffected by placement.
Surround
Locate surround speakers according to the recommendations in the
surround processor’s owner’s manual.
4
Installation
SPEAKER WIRE
Pull one run of 16AWG stranded speaker wire from the amplier
location to each speaker location. If in pre-wire, while the walls are
open and it’s easy, pull extra wire to any location that may be desirable
to add speakers at a later date. Leave extra length of wire on each end
to allow making connections and installing/removing speakers.
Use the chart below to determine the proper gauge of wire, based upon
wire length from the amp to the speakers. If using volume controls,
include the total length from the amp to the volume control and then to
the speakers.
SPEAKER WIRE GAUGE TABLE
SPEAKER WIRE LENGTH SPEAKER WIRE GAUGE
150’ (46m) 16AWG
400’ (122m) 14AWG
NEW CONSTRUCTION
W Box Technologies speaker installation can be simplied by using a W
Box Technologies new construction 0E-EZBRACKET, (sold separately).
This is installed prior to drywall installation and allows for precise
speaker placement and simplies the nal installation of the speaker.
EXISTING CONSTRUCTION
Speaker wire must be run from the equipment or volume control
location to each potential speaker location.
• Choose a location for each speaker that is free of obstructions
created by joists, HVAC duct-work, electrical wire runs, plumbing
or anything else that might not allow for the depth of the speaker or
create interference or noise.
5
Installation
• Once you have determined your locations, use a pencil to mark the
hole to cut out for the speaker using the supplied template. Don’t
forget to allow for the size of the speaker bezel if you are installing
the speaker near a sidewall or other item that could become an
obstacle.
• If you are unsure of potential obstacles, carefully cut your holes
using an angle to the inside of the cutout area. This will allow you
to “plug” the hole easily if needed. If the area is clear and is a good
location for the speaker, go ahead and cut the edges of the opening
at 90 degrees to accommodate the speaker diameter.
Cut hole at an angle in case patching is necessary
Save cutout for patching if necessary
Cut edge at 90°if area is clear of obstructions
6
• Strip the insulation on each conductor approximately 1/2” (12.7mm)
and insert to the speaker terminals. Ensure that there are no stray
strands of wire protruding from the connectors that can cause
shorts. Observe proper polarity (+ to + and – to – for each speaker
and at the amplier) and that surround channels are properly
positioned and connected, if used.
L- L+ R- R+
Amplifier Speaker Terminal
16AWG (min)
Stranded Speaker Wire
+ to +
- to -
+ to +
- to -
16AWG (min)
Stranded Speaker Wire
Installation
7
Installation
• With the ‘dogs’ ush to the side of the speaker, insert the speaker
into the ceiling and tighten each of the four screws for the
speakers’ dogs, enough to clamp the speaker to the drywall. Do not
overtighten.
Turn screws to extend dogs
as shown
Turn screws to extend dogs
as shown
• Attach the grill to the subwoofer. The grill attaches with magnets so
it will just snap into place.
PAINTING
The grill may be painted, but go as light as possible to not to clog the
ne holes with paint. Only paint grills when they have been removed
from the speakers and be sure to remove the cloth on the backside of
the grill before painting. If the cloth is not removed for painting, it will
absorb the paint and clog the grill, signicantly affecting the sound...and
not in a good way.
8
Troubleshooting
W Box Technologies speakers are designed to function trouble-free.
Most problems that occur are due to simple issues. If you have trouble,
please check the list of simple xes below.
SPEAKER TROUBLESHOOTING
PROBLEM SOLUTION
NO SOUND Verify that there is audio from the
source selected. Select another
source if necessary.
Ensure that the amplier is turned
on and connected properly.
Check any connections at oth-
er devices, such as a volume
control. Temporarily bypass the
control if needed.
Check wire connections at each
speaker not producing sound for
good contact to bare wire, not
wire insulation.
9
Specications
Frequency Response:.............................................................. 36-400Hz
Frequency/Crossover Setting:........................................ 80Hz and Below
RMS Power: ............................................................................ 100 Watts
Max Power:..............................................................................200 Watts
Speaker Driver:........................................................8” Silver IMPP Cone
Impedance:................................................................................... 8 Ohm
Grill Diameter:.................................................................................. 11.2”
Mounting Diameter: ......................................................................... 10.3”
Mounting Depth: ................................................................................8.6”
Mounting Style: ..............................................................4 Locking ‘Dogs’
Grill: ................................................................... Bezelless Magnetic Grill
10
Limited Warranty
1. Limited Warranty
a. General
Subject to the terms and conditions of this Limited Warranty, from the date of sale
through the period of time for product categories specied in Section 1(b), ADI
warrants its W Box Technologies products to be free from defects in materials and
workmanship under normal use and service, normal wear and tear excepted. Except
as required by law, this Limited Warranty is only made to Buyer and may not be
transferred to any third party.
ADI shall have no obligation under this Limited Warranty or otherwise if:
(i) The product is improperly installed, applied or maintained;
(ii) The product is installed outside of stated operating parameters, altered, or
improperly services or repaired;
(iii)Damage is caused by outside natural occurrences, such as lightning, power
surges, re, oods, acts of nature, or the like.
(iv) Defects resulting from unauthorized modication, misuse, vandalism, or other
causes
unrelated to defective materials or workmanship, or failures related to batteries of
any type used in connection with the products sold hereunder.
ADI only warrants those products branded as W Box Technologies products and sold
by ADI. Any other products branded by third parties are warranted by the third party
manufacturer for a period as dened by the third party manufacturer, and ADI assigns
to Buyer those warranties and only those warranties extended by such third party
manufacturers or vendors for non-ADI branded products. ADI does not itself warrant
any non-ADI branded product and sells only on an as is basis in accordance with
ADI’s terms and conditions of sale.
Table des matières
Langues :
Autres manuels W Box Technologies Subwoofer
