LC-CAST 600 en v5 4
2. SAFETY INSTRUCTIONS
ATTENTION!
The following instructions must be observed in order
to avoid personnel injury or equipment failure.
CAUTION!
BEFORE INSTALLING AND STARTING READ THIS
INSTRUCTION!
ONLY PERSONNEL WHO ARE FULLY
CONVERSANT WITH THIS MANUAL SHOULD
WORK WITH THE MACHINE.
The centrifuge and the HF generator can be
switched on only when the upper lid is closed.
When during melting the upper lid is open, the
high-frequency heating is interrupted.
The upper lid is locked and it cannot be open in
ROTATION mode.
The apparatus cannot be set to melting unless
there is water in the cooling system.
The inductor must be lifted to upper position for
melting only when the crucible is centred on it.
The centrifuging process can start only when the
inductor is in lower position.
The rod for lifting of the inductor can be raised
only if the power switch of the front panel is
pressed.
When the engine is started, the rod is locked in
lower position.
the device is not permitted to be run by an
operator, who is not entirely introduced to these
safety instructions;
before switching on the plug into the network
socket, you should check whether the electricity
grid voltage meets the prescribed working
voltage. In case of incompliance, seek the
assistance of a specialist;
it is not permitted in any case to modify the
device;
the notices and stickers must be kept in good
condition so that they are easily readable; they
should not be removed!
the machine must not function in case of being
damaged and in position to injure the staff or a
third person;
keep the power cable out of heat, oil and coarse
objects; do not catch the device by the cable
when you move it.
switch off the furnace and pull out the plug of
the feeder cable from the contact before each
cleaning or upkeep.
spare parts which are not specified by the
manufacturer cannot be used!
If the machine is used by such means not indicated by the
manufacturer, the provided protection can get worse!
