VonHaus 3500114 Manuel utilisateur
HOUSEHOLD
SAFE 18L
3500114 - Instruction Manual
Safety Instructions 1
Tools Required, Securing the Safe 2
Specification 3
Before Use 4
Opening the door/Automatic Lock 5
Setting User Code/Setting Master Code 6
Troubleshooting 7
Warranty 8
CONTENTS
This manual contains important information
regarding the operation and maintenance
of the Safe. Please ensure you read and
understand all instructions regarding the
correct operation of the product before
securing items in the Safe.
INTENDED USE.
This Safe is designed and intended for
domestic indoor use only. Do not use for
commercial purposes.
This Safe is not a toy. Keep away from
children. Children should be supervised to
ensure they do not play with the Safe.
ADVICE AND GUIDANCE FOR USE.
NEVER store the override keys (or the
manual) in the Safe. Once the batteries have
been exhausted, you will require the keys to
override and open the Safe.
IMPORTANT: Store the override keys in a
safe place for use in the event of the batteries
becoming exhausted, or should the unlock
code require resetting.
Periodically check the batteries for charge
(every 3 months or as appropriate). If
the batteries are of low charge, replace
immediately. Refer to the ‘Battery Safety’
section for guidance on battery use.
NOTE: This Safe is NOT fireproof or cash
rated. Contact your insurance provider for
guidance before storing any valuables in the
Safe.
For security purposes, it is recommended that
you secure the Safe to both a suitable wall
and floor surface using appropriate fixings.
Contact your local hardware store or qualified
person for advice and guidance on the most
appropriate fixings to use for your wall/
surface. The Safe should be located out of
sight for extra security.
Fixings supplied are intended for use with
some masonry wall surfaces. If you are unsure
about assembly or the suitability of your wall
or the fixings, do not proceed. Contact a
qualified person for advice and guidance.
NOTE: These important safeguards and
instructions cannot cover all possible
conditions and situations that may occur. It
must be understood that common sense and
caution are factors which cannot be built into
any product and are the responsibility of the
user.
The Safe contains no user-serviceable parts
with the exception of battery replacement.
Repairs should only be carried out by a
qualified person. Improper repairs may
compromise the integrity or function of the
Safe.
BATTERY SAFETY.
This product requires 4 x 1.5V LR6 “AA” Bat-
teries (not included).
Batteries are to be inserted according to the
correct polarity as indicated on the Safe.
Always recharge a full set of batteries at the
same time. Do not mix old and new batteries.
Only use batteries of the same or equivalent
type (e.g. Alkaline, Lithium-ion etc.)
Do not attempt to recharge non-rechargeable
batteries. Rechargeable batteries should be
removed from the Safe before recharging.
Do not attempt to short-circuit the supply
terminals or batteries for any reason.
Do not dispose of batteries in a fire. Do not
attempt to crush, puncture or in any way dis-
mantle the batteries for any reason.
Do not dispose of batteries in your household
waste. Batteries contain chemicals which are
damaging to the environment. Recycle bat-
teries where appropriate. Contact your local
government offices for advice and guidance
on the correct disposal of batteries or local
recycling centres.
WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
SECURING THE SAFE
TOOLS REQUIRED *NOT INCLUDED
Power Drill Suitable Drill Bit Suitable Screwdriver Wrench Pencil
For security reasons, it is recommended that you secure the Safe against a secure
masonry wall and floor surface.
1. Drill holes for expansion bolts in the desired location.
2. Turn the expansion bolts anti-clockwise to separate.
3. Use the expansion bolts to secure the case to the wall.
4. Make sure the case is mounted in place as required and then tighten all screws.
CAUTION Always use an expansion bolt when there is a concrete or wooden wall
surface.
2
SPECIFICATION
AA 18
4 x 1.5V LR6 NoneNone
L
BATTERY
POWER
CASH
RATING
FIRE
PROOFING
INTERNAL
VOLUME
1. Concrete Anchors (x4)
2. Override Keys
3. Screws (x4)
4. Electronic Keypad
5. Lock Cover
6. Locking Handle
7. LED Indication
8. Battery Cover
9. Reset Button
10. Locking Bolts
1 2 3
8
9
67
5
10
4
FIRST TIME OPENING
Remove the Locker cover (5) then insert the key and rotate counter clockwise to unlock.
Rotate Locking Handle (6) clockwise to open.
INSTALLING BATTERIES
Remove the Battery Cover (8) located on the back of the Safe door. Push in the catch
and carefully remove the cover.
Insert 4 x 1.5V LR6 “AA” Batteries (not included) according to the correct polarity as
indicated on the inside of the battery compartment. Replace the Battery Cover (8) to
secure.
LOW POWER
If both the RED and GREEN lights are illuminated at the same time, this means the
voltage is low and you should insert new batteries.
BEFORE FIRST USE
4
OPENING THE DOOR
OPENING / CLOSING THE DOOR
Input your users code (3-8 digits).
NOTE Each press results in one buzzer beep and a flashing to yellow to confirm.
Press * or # to confirm code. The green light will illuminate to open the safe.
Rotate the Locking Handle (6) clockwise to open.
CAUTION The user preset code ‘159’. Please input the user code if the yellow light
flashes with three buzzer beeps.
Rotate the Locking Handle (6) anti clockwise to close the door.
AUTOMATIC LOCK
3 continuously wrong entries will activate the warning beep for 20 seconds.
Another 3 continuously wrong entries will activate the warning beep for 5 minutes.
CAUTION The key pad would be disabled during the beeping. You can only stop the
beeps by opening the safe with emergency key.
SETTING THE USER CODE
With the door open, press the Reset Button (9) and wait for the yellow light to
illuminate.
Input your desired code (3-8 digits) and press * or # button to confirm. Two buzzer beeps
will confirm acceptance of the new code.
If the yellow light flashes with 3 buzzer beeps, you will need to repeat the process again.
NOTE Ensure you press the keys firmly to avoid mistakes.
SETTING THE MASTER CODE
Open the safe, input ‘0’ twice and press reset button. Begin setting the code when the
yellow light illuminates.
Input the new master code (3-8 Digits), then press * or # button to confirm.
This will confirm with 2 beeps and the yellow light will illuminate 2 times. This will indicate
the setting of the master code is successful.
NOTE If the yellow light flashes 3 times, it means the new code is invalid and you should
repeat the process to set.
6
NOTE: Should you require a replacement key, please contact our customer services
TROUBLESHOOTING
PROBLEM SOLUTION
LOST OVERRIDE KEYS AND
PIN NUMBER FORGOTTEN AND
BATTERIES HAVE EXHAUSTED
KEYPAD IS NOT RESPONDING
SAFE WILL NOT OPEN WHEN
CORRECT UNLOCK CODE IS
ENTERED
LOCK IS STIFF
CODE HAS RESET AND
BATTERIES HAVE EXHAUSTED
DOOR WILL NOT OPEN WITH
OVERRIDE KEYS
Open the Safe using the Override Keys
and replace the batteries.
Unlock the Safe using the Override
Keys and replace the batteries. Reset
the unlock code.
Lubricate the lock using a suitable
non-water-based lubricant and try again.
Open the Safe using the Override Keys
and reset the unlock code.
Ensure the Override Keys are turned
anticlockwise and held whilst the
Locking Handle is turned clockwise
and pulled to open the door.
8
DISPOSAL INFORMATION
COPYRIGHT
WARRANTY
Please recycle where facilities exist. Check with your local authority for recycling
advice.
All material in this instruction manual are copyrighted by DOMU Brands Ltd.
Any unauthorised use may violate worldwide copyright, trademark, and other laws.
To register your product and find out if you qualify for a free extended warranty please
go to
www.Vonhaus.com/warranty.
Please retain a proof of purchase receipt or statement as proof of the purchase date.
The warranty only applies if the product is used solely in the manner indicated in the
Warnings page of this manual, and all other instructions have been followed accurately.
Any abuse of the product or the manner in which it is used will invalidate the warranty.
Returned goods will not be accepted unless re-packaged in its original packaging and
accompanied by a relevant and completed returns form. This does not affect your
statutory rights.
No rights are given under this warranty to a person acquiring the appliance second-
hand or for commercial or communal use.
CUSTOMER SERVICE
If you are having difficulty using this product and require support, please contact
Table des matières
Langues :
Autres manuels VonHaus Sûr
Manuels Sûr populaires d'autres marques
Honeywell
Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manuel utilisateur
Hornady
Hornady SnapSafe Trunk Safe II Manuel utilisateur
SPORTS AFIELD
SPORTS AFIELD SA-HD5-BIO Manuel utilisateur
Honeywell
Honeywell 5912 Manuel utilisateur
Phoenix
Phoenix FS1280F Manuel utilisateur
Phoenix
Phoenix SS0992K Fiche d'information produit
