Vitroceramic V6-04R Manuel utilisateur
110008Z9138
GB
GR
VITROCERAMIC HOB
Installation and Operating Instructions
ΥΑΛΟΚΕΡΑΜΙΚΗ ΕΣΤΙΑ
Οδηγίες εγκατάστασης και λειτουργίας
“ Η συσκευή είναι σχεδιασμένη αποκλειστικά για οικιακή – ιδιωτική
χρήση και για συγκεκριμένους σκοπούς. Δεν είναι σχεδιασμένη για
επαγγελματική ή και διαφημιστική χρήση.
Αφού αφαιρέσετε τη συσκευασία, ελέγξτε μήπως η συσκευή έχει κάποια
ζημιά. Αν έχετε οποιαδήποτε αμφιβολία, μην χρησιμοποιήσετε τη
συσκευή. Επικοινωνήστε με το πλησιέστερο κέντρο εξυπηρέτησης του
καταστήματος από το οποίο προμηθευτήκατε τη συσκευή. Μην αφήνετε
ποτέ τα στοιχεία της συσκευασίας, π.χ. πλαστικές σακούλες, αφρώδες
πολυστυρένιο, καρφιά κ.λπ.) σε μέρος προσιτό από τα παιδιά, καθώς
εγκυμονούν κινδύνους.
Η συσκευή πρέπει να εγκατασταθεί σύμφωνα με τις οδηγίες αυτές και
από εξειδικευμένο πρόσωπο. Ο κατασκευαστής δεν αναλαμβάνει καμία
ευθύνη για ακατάλληλη εγκατάσταση που ενδέχεται να προκαλέσει
βλάβες σε πρόσωπα και ζώα και ζημιές σε περιουσιακά στοιχεία.”
3
GB
DEAR CUSTOMER,
Thanks for purchasing our product. We hope you enjoy all the features
and benefits of the
product. Before using the product, please read the operating manual
carefully. Keep this
manual for future use. Make sure that everyone using the product are
familiar with the instructions.
TABLE OF CONTENTS
Important Warnings Before Operation
Usage Faults
Wiring Installation
Device Definition and Features
Installation and Start-up
Protection of the Environment
FOR THE EFFICIENCY AND SAFETY OF THE PRODUCT, WE
RECOMMEND YOU TO USE ONLY ORIGINAL PARTS AND TO
CALL ONLY OUR AUTHORIZED CUSTOMER SERVICES WHEN
YOU NEED!
“As this product contains electrical elements, first installation and start-
up procedures or, if necessary, installation after transfer should be
carried out by authorized service. Otherwise, our company shall not be
responsible for any problem.”The product that you have purchased are
designed just for use at home, it can be used just at
home and for specified purposes.It is not for commercial or collective
use. We want to note that as it is specified in TKHK (law on the
protection of the consumer), in the event that the customer uses the
product otherwise, manufacturer and seller shall not be responsible for
failures.
This device is in compliance with EEE regulation.
4
WARNING
1. Operating voltage is 220-240 volt - 50/60 Hz. Don’t operate the
device with less or higher voltage.
2. The fuse to be used should be at least 32 Ampere. Electrical and
installation connections of the device should be carried out by
authorized service staff.
3. Always use a fuse in power line.
4. Connect the device to a grounded plug.
5. Never remove or deform the device identification label
mounted or attached on the device body, containing device information.
6. As package may pose danger for children, keep the package away
from children.
7. Don’t connect the device to power supply unless you complete the
installation.
8. Touchable parts of the device will get hot during operation, pay
attention not to touch hot parts.
9. When the device is used close to children, observers should be
responsible. Unless there is a responsible person, people who are
physically or mentally disabled or who has lack of knowledge and
experience (including children and old people) should not be allowed to
use the device. This device can be use by children who are 8-year-old
or older and people who are mentally, physically disabled and who have
lack of knowledge and experience, provided that an observer is present,
or they understand the instructions for safe use of the device and
possible dangers.
10. The hob should be installed and started up by an authorized
technician. Manufacturer shall not be responsible for any damage that
may be caused by faulty placing and installation by non-authorized
persons.
11. The hob should be cleaned periodically, splashed oil and other
wastes should be wiped immediately. Otherwise, there might be fire
danger.
12. Keep flammable, exploding materials away from the hob.
13. If power cable is damaged, it should be replaced by manufacturer,
service agent or same-qualified persons.
Usage Faults
* This device is designed to be used built in a furniture at home.
5
* If you do not use the device for a long time, unplug it.
* Keep all the buttons turned off.
* During installation, make sure that power supply cable is not stuck.
* When operating other electrical tools around the device, make sure
that cables do not touch hot parts.
* Turn off the device before procedures like cleaning, maintenance.
* Do not keep flammable materials around the device while operating.
* Never use flammable materials such as gasoline to clean the device.
Do not use the device in kitchens where flammable gases are available.
* Do not place the saucepan on the hob quickly.
* To provide more efficiency, place proportional saucepans on
hob burners. Do not place a small saucepan on a large
dimensional burner, and a large saucepan on a small
dimensional burner.
* Do not place sharp object on the hob.
* Hold the saucepan carefully on the hob, pay attention not to
fall it.
* In case of a crack etc. on the hob, disconnect the device
from power supply and call authorized service.
PRODUCT IDENTIFICATION AND FEATURES
1-Vitroceramic single-zone heater
2- Installation Clamp
3- Lower housing area
4- Button Switchboard
5- Vitroceramic surface
4
5
1
2
3
1- 230 V 1800W
2- 230 V 1200W
3- 230 V 1200W
4- 230 V 1800W
12
3 4
6
1- Vitroceramic single-zone heater
2- Installation clamp
3- Lower housing area
4- Touch control switchboard
5- Vitroceramic surface
3
5
1
2
4
1- Vitroceramic single-zone heater
2- Vitroceramic double-zone elliptic heater
3- Vitroceramic double-zone heater
4- Touch control switchboard
5- Vitroceramic surface
6- Lower housing area
7- Installation clamp
6
3
74
25 1
1
o
2
1
43
5
6
o
2
1
43
5
6
o
2
1
43
5
6
o
2
1
43
5
6
+ + + +
1 2 3 4 5
o
2
4
3
5
6
7
8
91
o
2
4
3
5
6
7
8
91
o
2
4
3
5
6
7
8
91
o
2
4
3
5
6
7
8
91
1 2 3 4 5
Switchboards for Button Models ( V6-04R, V6-04RY )
1- Vitroceramic hub burner front Right
2- Vitroceramic hub burner front Left
3- Vitroceramic hub burner Rear Left
4- Vitroceramic hub burner Rear Right
Düğmeli Modeller için Kontrol Panelleri (V6-04P, V6-04PY )
7
1- Turn on - Turn off
2- Power level with cook zone selector button
3- 2-grade heater selector
4- Key for 2- and 3- grade element
5- Power level indicator
V6 - 4TZ
4
5
1
2
2
23
25
5
5
1- Vitroceramic hub burner front Right
2- Vitroceramic hub burner front Left
3- Vitroceramic hub burner rear Left
4- Vitroceramic hub burner rear Right
Switchboards for Front Touch Control Models ( V6-04T )
1- Vitroceramic hub selector button
2- Vitroceramic hub level decrease
3- Vitroceramic hub level increase
4- Turn on / Turn off
Switchboards for Front-Touch Control Models (V6 - 4TZ)
11
1
23
4
1
8
Touch Control Remote Buttons:
Your hub is operated with touch control remote buttons on the frontside.
Touch control remote buttons are operated with light sensor system.
When touch control switch board is activated, sensors detect the signal
coming from vitroceramic glass surface. So that, your device is
operated at intended place.
BEFORE CONNECTING YOUR DEVICE
- The hub should be placed close to power supply.
- Check that the device is not damaged after you remove packaging
and device accessories from the device. If you doubt that the device is
damaged, do not use the device and get in contact with Authorized
Service immediately.
- Place the hub after the eligible place on countertop is cut and
removed.
- Power is connected to the lower part of the hub with a dedicated
conduit box.
INSTALLATION INSTRUCTIONS: The device should be installed
correctly pursuant to effective legislation. Before carrying out any
operation on the device, power source should be disconnected.
Electrical Wiring of the Hub:
Pay attention following points while carrying out electrical connections.
- Make sure that current-carrying capacity of home mains and the plug,
to which the device is connected, is proper for the maximum power
used by the hub.
- Make sure that operating voltage stated on capacity label is the same
as mains voltage.
- Connect the device directly to plug. There should not be any
additional part like transformer etc.
- Always connect the device to grounded plug.
- Place the device so that mains cord can be easily accessed.
- A fuse, having 3mm opening between contacts which can disconnect
the power of all the poles on the device, should be used with the
device.
9
Placing the Device on Countertop
Device can be placed into any kind of countertop as long as it is heat-
resisting. (minimum temperature is 90°C).
Dimension of the hole and minimum distance between back and side
walls, and top of the device are showed in the pictures.
Remember: * If the device is installed without an oven below, a
separator panel should be placed with at least 10 mm distance
between base of the device and the housing below.
* If the device is installed on an oven, place a separator panel at least
with 15 mm distance and follow the manufacturer’s instruction by
applying proper ventilation as shown in the picture. For electricity and
easier removal, in any case, electricity connections of the devices
should be carried out separately. It is recommended to use an oven
equipped with internal cooling system.
Installation Dimensions of the Device
For such connections, usable cable type should be H05W-F,
and for single-phase connections is 3x2.5mm2.
- For insulation safety, cable should not be longer than 2m.
- When placing the device, do not stuck the power cable
under the body, and do not pass it close the hubs. Cable
insulation may be damaged.
- When power cable is damaged, contact to closest
Authorized Service and replace with new one.
- Our company shall not be responsible for the damage
caused by non-compliance with the above instructions.
* Always connect this device to grounded
plug.
* For such connections, H05W-F type
cable should be used.
3x2.5 mm² 220 V~
3x2.5 mm² 230 V~
3x2.5 mm² 240 V~
52,5 mm
10
Mounting bracket
1- Power ON / OFF Touch Control
Control unit gets ready within 1 second for use after it is connected to
main voltage. 1 second after the reset, all indicators and LEDs turn on.
After 1 second, all the indicators and LEDs turn off. Control unit can be
turned on by pressing ON / OFF button. Indicator shows a constant “0”.
When cooking zone is HOT, indicator turns “0” and “H” in turn (“0” 0,5
sec, “H” 0,5 sec).
Electronic section stays active for 20 sec. If cooking surface is not
selected within that time, electronic section automatically resets to
STAND-BY mode and beeps. If child-lock is identified as “active” when
power is ON, all cooking zones are shown with “L” which means
LOCKED. If cooking zones are “hot”, indicator shows “H” instead of “L”
(H - ON= 0.5 sec; L-ON = 1.5 sec). When touch control is activated, it
can be turned off by pressing ON / OFF button on the control unit. This
can be performed when child-lock is active. ON / OFF button always
has a priority with POWER OFF button.
2- Automatic Turn Off
Control unit turns from ON to OFF after 20 sec, within this time, none
of the cooking zones is activated and selector button cannot be
pressed.
In the event that a cooking zone is selected, Automatic Power OFF
To prevent liquid leak problems that may occur on countertop, a
dedicated sealing band will be provided with the hub. Attach the roll
sealing band so that it enframes all the hub as shown in the picture.
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels Vitroceramic Plaque
