1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Remove portable mounting plate (D) from backplate (E) by removing
screws (C).
3. Using portable mounting plate (D) as a guide, mark anchor positions.
4. Using a drill bit slightly smaller than the anchor, drill holes in the
marked positions. Install anchors (A) into the holes using hammer.
5. Install mounting plate (D) to wall anchors using wood screws (B).
Then secure fixture to mounting plate (D) using screws (E).
6. Thread cord covers (F ,M, & L) to the bottom of backplate (E).
7. Install harp (I) by squeezing together and inserting into the top of
saddle (H).
8. Remove finial (K) from harp (I).
9. Remove shade (J) from packaging and install to harp (I) using
finial (K).
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
10. Install light bulb into the socket.
11. Swing the arms (X) & (Y) to desired angle.
12. Remove protective cover (G) from plug.
13. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
Griffith Swing Arm
Item # SK 2109
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Pencil Hammer
Slotted Screwdriver Drill
NOTICE:
Scissors
Portable assembly
US
M
L
I
D
S
E
T
Bulb not included
G
ABD
C
E
F
I
H
J
K
L
M
XY
