Visionary Solutions PNA-D4 Manuel utilisateur
2060 Alameda Padre Serra, Suite 100∙ Santa Barbara, CA 93103
Tel: (805) 845-8900 ∙ Fax: (805) 845-8889 www.vsicam.com
Visionary Solutions, Inc.
PNA-D4
Quick Start Guide
PNA-D4
©2015 Visionary Solutions, Inc. All rights reserved.
PNA-D4 Quick Start Guide
2060 Alameda Padre Serra, Suite 100∙ Santa Barbara, CA 93103
Tel: (805) 845-8900 ∙ Fax: (805) 845-8889 www.vsicam.com
2
Introduction
This document is intended to assist users in setup and use of their PNA-D4 POE+ Dante™ PacketAV®
Amplifier.
Equipment Required
1. PNA-D4
2. POE+ Ethernet Switch
3. DHCP server to assign address to PNA-D4
4. Ethernet cable
5. Dante™ Controller Software (Windows or Mac)
https://www.audinate.com/products/software/dante-controller
6. A source creating a Dante™ audio flow.
PC or Mac with Dante™ Virtual Soundcard
DSP with Dante™ output
Mixing board with Dante™ output
7. Loudspeaker(s) to accept amplifier output
Step 1: Connect Hardware
1. Plug RJ-45 cable into the PNA-D4 and the network switch
2. Connect the output(s) to the loudspeaker(s)
3. The Power LED should be green
4. The Fault LED should be dark
5. Launch the Dante™ Controller Software
6. Locate the PNA-D4 in the Dante™ receivers column
7. Select a Dante™ channel(s) audio and assign it to a speaker(s)
8. If the selected Dante™ channel has signal, you should hear sound coming from the speaker
9. Enjoy
Important Information
The amplifier has a nominal gain of 25.2dB, 6dB of digital gain and 19.2dB of analog gain. If the digital input
signal exceeds -6dBFS the signal path will clip before the output stage, resulting in a distorted signal.
The total impedance connected to the amplifier must be 2Ω or greater. Typically it would be up to 4 each 8Ω
speakers or 2 each 4Ω speakers. Loads of less than 2Ω can result in the unit consuming excess power, causing it
to be shut off by the network switch. This will result in an approximate 30 second restart time.
The units have a soft clip function which limits the instantaneous power to a safe level for POE+ switches (that
can deliver full power to the port used by the unit), as long as the total load is greater than 2Ω.
Table des matières
Autres manuels Visionary Solutions Amplificateur
