3.0 Assembly Instructions
4.1 Installation Instructions:
Camera can be mounted using magnet and
attaching hardware. These are the steps
required to attach the magnet to the camera.
1. Position and align center hole of camera
and bracket assembly on top of magnet.
2. Install bolt from underside of magnet and
secure with flat washer and nut. Tighten
this connection.
Tip: Although magnet contains 65lb pull force, it
we recommend mounting your camera on a flat
surface, and a zip tie be used in addition to
fasten the camera as a preventative measure in
the event the camera is knocked off.
1. Remove monitor adjustment screws from
monitor and bracket assembly.
2. Carefully separate U type bracket from
monitor. Installer must ensure that
attaching hardware is suitable to support
the weight of monitor and base.
3. Install U type bracket to desired monitor
position. Once the U type bracket base
has been fastened into position the
monitor can be installed.
4. Re-Install adjustment screws in their
original locations. Monitor can be
adjusted to 30 deg. forward or 30 deg.
rearward angles by loosening adjustment
screws, positioning monitor angle, and
retightening monitor adjustment screws.
Do not over tighten. Ref. Fig.1
Connect MONITOR harness to the MAIN HARNESS MONITOR INPUT. Ensure arrows are aligned
on outer jacket of cable ends. Turn silver cable connector nut clockwise to secure connection of the
cables (IF YOU BEND THE PINS IT VOIDS THE WARRANTY). Ref. Picture Below & Fig.3
3
