Symbols used
Warning!
A potenal risk of danger exists. Failure to comply can
cause i) a hazard to personnel; ii) instrument malfuncon
and damage. Please consult the operang instrucons
provided with the product.
Cauon hot surface!
Warning: surfaces (sub-stage lighng module) can become hot.
Do not touch. Allow to cool before removing/servicing.
Important informaon
This symbol indicates important informaon. Please
carefully follow the instrucons or guidelines.
Health & safety
Unauthorised alteraons to the instrument or
non-compliant use shall invalidate all rights to any
warranty claims.
ALWAYS READ THE MANUAL BEFORE USE.
Warning!
Do not posion or leave the product where direct
sunlight can fall on the viewing mirror.
When not in use always cover the product and viewing
mirror with the supplied dust cover and dust sheet.
Electrical safety
Disconnect your system from the electrical source
before undertaking any maintenance.
Avoid using any form of liquid near the system.
Do not operate your system with wet hands.
Illuminaon safety
Do not look directly at the illuminated LEDs. This may
cause damage to the eyesight.
Liing the equipment
Due to the weight and size of the display head and
system, we recommend a two person li.
Environmental consideraons
Avoid large temperature uctuaons, direct sunlight
and vibraons.
It is recommended to ensure electrical components are
at least 10cm from walls and combusble materials.
Posion the system on a rm, rigid and level table.
The equipment should be posioned so that access to
the electrical input connector is always available.
Avoid posioning your system where bright reecons
may aect the image.
Operator wellbeing
The advanced ergonomic design and construcon of
Vision Engineering products are intended to deliver
superior ergonomic performance, reducing the exeron
of the user to a minimum. Depending on the duraon
of uninterrupted work, appropriate measures should
be taken to sustain opmal operator performance.
This could include: Opmal arrangement of workplace;
Variaon in task acvity; Training of personnel on
workplace ergonomics and general health and safety
principles.
It is important to set-up and opmise your working
environment correctly in order to obtain maximum benet
from the advanced ergonomic design of your system. For
more informaon visit: www.visioneng.com/ergonomics
Cleaning
General
Disconnect your system from the electrical source
before cleaning.
Do not use any unsuitable cleaning agents, chemicals or
techniques for cleaning.
Wipe down exterior of product with dry cloth. A weak
soap soluon may be used if required.
Spherical mirror, front mirror & lenses
Keep the instrument clean using the supplied microbre
cloth. If required use supplied opcal spray cleaner. Do
not use any other solvents or cleaning soluons.
Only use a specialist lens cloth to clean opcal surfaces.
Compliance statements
Vision Engineering and its products conforms to the
requirements of the EC Direcves on Waste Electrical
and Electronic Equipment (WEEE) and Restricon of
Hazardous Substances (RoHS).
All Vision Engineering products carry the CE mark,
demonstrang that each product meets the requirements
of the applicable EC direcves. Where applicable, other
characteriscs of the CE direcve are implied such as
essenal health and safety requirements from all the
direcves that apply, including low voltage direcve and
the EMC direcve.
