17205 Eucalyptus Street #A3
Hesperia, CA 92345
www.vikingairmovers.com
GFCI receptacles shall be warranted for 90 days from
original purchase date.
Year One – 100% labor and parts (all components other
than that noted above).
Year Two – Labor only.
Year(s) Three through Seven – Only materials and
workmanship of the housing are covered
Warranty service shall only be performed by a service
provider authorized by the Company.
Freight to the Company is the responsibility of the end-
user. The end-user is responsible for normal care and
proper return packaging.
Equipment or Parts thereof, manufactured by others are
warranted hereunder only to the extent of such
manufacturer’s warranty to the Company.
Since after purchase, the Equipment and Parts thereof are
under the sole control of the Purchaser, this Warranty is
subject to, and shall be applicable only if, the following
conditions are met:
a. The Company’s instructions as to usage,
operation and maintenance have been followed;
b. The Equipment and Parts thereof, have been used
under normal indoor operating conditions.
c. The Equipment and Parts thereof have been
correctly operated and maintained and have not
been damaged by misuse, neglect, or accident.
d. The purchaser has not attempted or performed
corrective work or change on the Equipment and/or
Parts thereof.
e. The Company shall have received notice (RMA
Request) of any defect no later than thirty (30)
days after the Purchaser first had knowledge of
the same.
This warranty is in lieu of any and all other
warranties, express, implied or statutory including,
without limitation, warranties of merchantability
and fitness for a particular purpose or use.
LIMITATION OF LIABILITY
THE COMPANY SHALL HAVE NO LIABILITY WHATSOEVER IN
ANY EVENT FOR PAYMENT OF ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING, WITHOUT
LIMITATION, WATER DAMAGE (THE END-USER SHOULD
TAKE PRECAUTIONS AGAINST SAME), LOST PROFITS,
DELAY, OR LOSS OF USE, OR DAMAGES FOR INJURY TO ANY
PERSON OR PROPERTY. BY ACCEPTING THE EQUIPMENT
AND/OR PARTS THEREOF, THE FIRST END-USER
PURCHASER OR SUBSEQUENT USER AGREES THAT THE
COMPANY SHALL NOT BE LIABLE FOR INDEMNIFICATION OR
CONTRIBUTION (IN WHOLE OR IN PART) EITHER
EXPRESSLY OR BY IMPLICATION.
IF FOR ANY REASON ANY OF THE FOREGOING PROVISIONS
SHALL BE INEFFECTIVE, THE COMPANY’S LIABILITY FOR
DAMAGES ARISING OUT OF ITS MANUFACTURE OR SALE OF
ITS EQUIPMENT OR PARTS, OR USE THEREOF, WHETHER
SUCH LIABILITY IS BASED ON WARRANTY, CONTRACT,
NEGLIGENCE, STRICT LIABILITY IN TORT OR OTHERWISE,
SHALL NOT IN ANY EVENT EXCEED THE FULL PURCHASE
PRICE OF SUCH EQUIPMENT AND PARTS THEREOF.
Any action against the Company based upon any liability or
obligation arising from or under any law applicable to the sale
of its Equipment or Parts, or the use thereof, must be
commenced within six months after the cause of such action
arises.
OPERATING INSTRUCTIONS
1. Check the machine for any obstructions in the fan or airflow
areas before plugging in the unit or operation of the unit.
2. Set the machine in the desired orientation for operation.
3. Plug the power cord into a grounded outlet.
Do not use an extension cord.
4. Check GFCI protection by pushing ‘TEST” button. If operating
properly, “RESET” button will pop out.
5. Do not plug more than 11 amps total into the GFCI outlet.
6. Ensure the switch is in the center OFF Oposition.
7. The machine has two power settings, Low |and High ||.
ALWAYS start in the HIGH position, then to LOW if desired.
8. When daisy-chaining, turn one unit on at a time to prevent
excessive current inrush from starting multiple units at one time
9. Every month, press the “TEST” button to verify that it cuts-off
power to the GFCI. To restore power, press “RESET”. If the red
LED begins to flash, the receptacle has lost GFCI protection and
should be replaced immediately.
TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTION
Unit will not turn on Not plugged in Plug unit into proper outlet
Switch is worn Replace Switch
Tripped circuit
breaker Reset Breaker
Short in power cord Replace power cord
Capacitor on motor is
damaged Replace motor or capacitor
No power from GFCI Tripped GFCI breaker Correct cause & reset GFCI
Red LED on GFCI
flashing The receptacle has lost its
GFCI protection and must
be replaced immediately
Air mover will not
operate on all speeds Switch is worn or
loose terminal Replace switch
Air Mover runs/starts
slowly Capacitor terminal
may be shorting Reposition or insulate
terminal
The fan is rubbing Fan is out of round Replace fan
Air mover is making
strange noises There is a foreign
object stuck Turn off motor and remove
object
Motor bearing is worn Replace motor
Fan is rubbing Replace Fan
WARRANTOR:
VIKING EQUIPMENT COMPANY, INC.
17205 Eucalyptus Street #A3
Hesperia, CA 92345
Toll Free: (800) 252-5201
WARRANTY AND LIMITATION OF LIABILITY
Viking Equipment Co., Inc. (the "Company") warrants to the first end-user
purchaser that the equipment and parts thereof, when shipped, will be free
from defects in materials and the Company’s workmanship. If any such
defects exist or later appear, the Company shall provide prompt remedial
action, as stated herein, to correct the defect. The Company shall have no
obligation or liability under this Warranty unless the customer has obtained
a Return Material Authorization (RMA). To get an RMA you must present
proof of purchase, by the use of the original sales receipt, Internet Product
Registration, or other reasonable and reliable means. To obtain an RMA, call
Viking Equipment Company at (800) 252-5201 and ask for the Customer
Service Department, which will then issue an RMA number and will arrange
for repair or replacement, at our option, according to the following schedule:
This warranty covers Viking Centrifugal Air Movers. Phone: (800) 252-5201
FAX: (760) 244-1880
carol@vikin
airmovers.com
Revision 2
November 01, 2007
