Viking Electronics E-35-IP Manuel utilisateur

QUICK START GUIDE

VIKING

Electronics, Inc.

KSee Product Manual for complete installation and programming instructions.

1.0 Out-of-Box

1.1 Verify that you have received all of the parts listed

1.2 Download the product manual

1. Go to www.vikingelectronics.com and

enter E-35-IP in the search box

2. Click E-35-IP in the search results

3. Click Product Manual to open and

download the PDF

1.3 Download and install the programming software

1. Go to www.vikingelectronics.com and enter E-35-IP in the search box

2. Click E-35-IP in the search results

3. Scroll down the page to Downloads, click IP Programming Software

4. Install the programming software by saving or opening the file and then clicking on

setup Viking IP Programming.exe

5. Follow the prompts on your screen to complete software installation

2.0 Power Source

Select PoE Switch or PoE Injector that meets the following requirements:

1. IEEE 802.3af / 802.3at / 802.3bt compliant

2. Capable of providing at least 4 Watts (class 1)

Note: CAT5e (or higher) cable recommended

X 1 E-35-IP or E-35-IP-EWP

Entry Phone

X 1 Torx T-10 Security Bit

X 8 Gel-Filled Butt Connectors

X 1 Wire Nut

X 1 Faceplate Gasket

X 4 6-32 x 3/4” Flat Head Torx

Drive Screws

X 1 Flush Mount Back Box

X 1 Transformer 12VDC

Scan the QR code to

open and download

the product manual - OR -

E-35-IP or

E-35-IP-EWP

VoIP Entry Phone

September 17, 2019

4.0 Features Overview

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries

assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

See the Product Manual for complete installation and programming instructions.

Questions? Call Viking Product Support: 715-386-8666

E-35-IP Quick Start Guide ZF303705 REV B

• Make sure the port is not in trunk mode

• Make sure port is capable of 100mbps full duplex

• Disable Spanning Tree Protocol (STP) or enable Portfast

3.0 Network Port Settings

MAC:

18E80FXXXXXX

asdesaxtff

N.C. (Gray)

N.O. (Yellow)

COM. (Blue)

* On-Board 2 Amp

Relay Output Contacts

(2A@30VDC/ 250VAC max)

3 Gel-Filled Butt

Connectors (included)

- Black

+ Red

Black

- Black

+ Red

LED

Help Switch

Request for Exit (REX Input)

Speaker

Microphone

MAC Address Label: The MAC

address is a unique 12 digit

number used by routers to send

network traffic to the correct IP

address.

PoE LAN Port 10/100, PoE

Class 1 (<4 Watts): Connect to

your LAN via RJ45 plug and CAT5

or greater twisted pair wire.

Yellow Network Status LED:

Lights steady to indicate power

and data link. Blinks to indicate

network activity.

Green Unit Status LED

Rear (PCB) View

of E-35-IP

Green

Yellow

(Power typically not

required for gate controllers)

Doorstrike /

Magnetic Lock

120V AC

Connect to Optional

Doorstrike, Mag Lock,

Gate Controller, etc.

(not

connected)

Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a

maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.

* Note: The front panel of the E-35-IP is mounted using security Torx screws to help prevent intruders from removing the

panel and accessing the on board door strike/gate control relays. For applications requiring additional security, a Viking

model RC-4A remote relay controller can be used. The relay controller is mounted securely inside the building and connected

to the same LAN as the E-35-IP. For more information on the RC-4A Secure Relay Controller, see DOD 582.

Ce manuel convient aux modèles suivants

Autres manuels Viking Electronics Système d'interphone

Viking Electronics

Viking Electronics K-1700-BN-IP Manuel utilisateur

Viking Electronics

Viking Electronics E-10-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1770-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1205-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1775-BN-IP Manuel utilisateur

Viking Electronics

Viking Electronics E-30-IP Manuel utilisateur

Viking Electronics

Viking Electronics E-10-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1270-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1770-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1770-BN-IP Manuel utilisateur

Viking Electronics

Viking Electronics E-10-IP-EWP Manuel utilisateur

Viking Electronics

Viking Electronics K-1705-BN-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1775-IP Series Manuel utilisateur

Viking Electronics

Viking Electronics K-1900-8-IP Manuel utilisateur

Viking Electronics

Viking Electronics K-1200-IP Manuel utilisateur

Manuels Système d'interphone populaires d'autres marques

Bticino

Bticino LINEA 3000 Manuel utilisateur

MSI

MSI MSI-140 Manuel utilisateur

golmar

golmar Stadio Plus Manuel utilisateur

CyberData

CyberData 011211 series Manuel

Vidos

Vidos duo M1021 Manuel utilisateur

Vimar

Vimar ELVOX 7539/E Manuel utilisateur

SSS Siedle

SSS Siedle BTSV 850-03 Manuel utilisateur

Dahua

Dahua VTO Series Manuel utilisateur

Elvox

Elvox 5651 Manuel utilisateur

Videx

Videx VIDEOKIT Series Manuel utilisateur

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuel utilisateur

Viking

Viking E-35-EWP Manuel utilisateur

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuel utilisateur

SSS Siedle

SSS Siedle BFCV 850 Series Manuel utilisateur

GRD

GRD MAX V2 Manuel utilisateur

Alecto

Alecto ADI-250 Manuel utilisateur

Aiphone

Aiphone IE-8MD Manuel utilisateur

Perel

Perel EDB4 Manuel utilisateur