Viatek LIFE JUICER Manuel utilisateur
·2·
DO NOT use Life Juicer for more than
20 minutes continuously because the engine
could be damaged.
NO utilice Life Juicer durante más de
20 minutos seguidos pues el motor podría
sufrir daños.
NON usare Life Juicer per più di
20 minuti ininterrottamente
poiché il motore
potrebbe danneggiarsi.
NIE UŻYWAJ Life Juicer nieprzerwanie dłużej niż przez
20 minut, gdyż może to spowodować
uszkodzenie silnika.
·3·
Congratulations on your purchase of the revolutionary LIFE JUICER, a
breakthrough in fresh juice for your entire family. The LIFE JUICER uses the ‘Cold press
technology (CPT)’ to fi rmly squeeze and press fruits and vegetables and give you all the nutrients,
vitamins and enzymes for great tasting juice.
Most traditional juicers blend, shred and grind when juicing, thereby creating heat, which causes
the loss of most nutrients, vitamins and enzymes, leaving you with bland-tasting and
dull-looking juice.
With the ‘Cold press technology (CPT)’ you get rich-colored juice that is better tasting,
better looking and better for you.
See & taste the difference!
Carefully read this manual before using this appliance.
Ensure that you know how the appliance functions and how to operate it.
EN
·4·
TABLE OF CONTENTS
1. Package contents 5
2. General and electrical safety 5
3. Specifi cations 6
4. Before fi rst use 6
5. Assembling the juicer 6
6. Using your juicer 8
7. Tips 9
8. Cleaning 9
9. Troubleshooting 10
·5·
1. PACKAGE CONTENTS
1x Life Juicer (Model SD60) 1x Juice Bowl 1x Hopper
1x Instruction Manual 1x Strainer Holder 1x Food Pusher
1x Juice Tank 1x Strainer 1x Cleaning Brush
1x Pulp Tank 1x Auger 1x Recipe book
2. GENERAL AND ELECTRICAL SAFETY
Supply Cord and Plug
Always unplug from the outlet when not in use. Do not abuse or damage the power cord. If the
supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualifi ed person in order to avoid a hazard.
Injury Precaution
WARNING: Potential injury from misuse! Avoid contact with all moving parts. Switch off the
appliance and disconnect from the outlet before changing accessories or approaching parts that
move during use.
Damaged or Dropped
Always inspect your appliance before use. Ensure the parts are correctly attached. Do not use
this appliance if it has been damaged, dropped, left outdoors or dropped into water. Return it to an
authorized service dealer for examination and repair.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
SAVE THESE INSTRUCTIONS
EN
·6·
(5) Hopper (9) Cleaning Brush
(4) Juice Auger(3) Strainer
(2) Strainer Holder(1) Juice Bowl
(8) Food Pusher(6) Pulp Tank
(8)
Food Pusher
(6)
Pulp Tank
Cleaning Brush
(7) Juice Cup
4. BEFORE FIRST USE
Carefully wipe the exterior of the appliance to remove any dust that may have accumulated. Dry
with a dry towel. Do not use harsh abrasive cleaners. Remove any labels or stickers. Wash the
accessories in warm soapy water and dry with a dry towel. Do not immerse the supply cord or
motor part of this appliance in water or any other liquids. This appliance has a built-in safety lock;
this feature ensures that you can only switch on the appliance if you have correctly assembled the
juicer on the motor unit. When assembled correctly, the built-in safety lock will be unlocked.
5. ASSEMBLING THE JUICER
Before you assemble the juicer, ensure that the power cord is unplugged.
IMPORTANT: If the Juice Bowl and Hopper are not correctly assembled, the Juicer will not
operate. This is a safety feature.
3. SPECIFICATIONS
Rated Voltage: AC220-240V // 110V Rated Power: 150W
Rated Frequency: 50-60Hz Speed : 80 RPM
STANDARD USAGE TIME: LESS THAN 20 MINUTES CONTINUOUSLY.
·7·
1. Place the Juice Bowl (1) on top of the main body.
Make sure the juice bowl is in the correct posittion
locking it clockwise so it cannot be removed.
2. Put the Strainer Holder (2) into the Juice Bowl.
3. Put the Strainer (3) into the Strainer Holder. Align
red dot mark on the strainer holder with the red dot
mark on the juice bowl.
4. Put the Juice Auger (4) into the Strainer.
5. Fit the Hopper (5) over the Juice Bowl and turn in
position CLOSE so it locks into the main body.
6. Place the Pulp Tank (6) so it fi ts in position on the
left-hand side of the juicer’s main body.
7. Place the Juice Cup (7) under the Juicer spout.
8. Slide the Food Pusher (8) down the Food
Chute. The Pusher can only fi t one way.
(1)
(2)
(3)
(4)
(5)
·8·
6. USING YOUR JUICER
1. Ensure the Hopper is properly threaded on top of the Juice Bowl.
2. Turn the control switch to the ON position to juice fruits.
3. Press the Food Pusher slowly down until all fruits or vegetables have gone through the juicer.
Do not press the Food Pusher rapidly, as the juicer will not be as effective. (CAUTION: Do not
put your hand or any other object in the Food Chute during operation.)
4. The juice from the fruit and/or vegetables will fl ow directly into the Juice Tank and the pulp will
be collected in the Pulp Tank.
5. When juicing is complete, ensure that the juicer’s control switch is set to the OFF position and
the juicer is unplugged (the unit can now be safely be disassembled). DO NOT run the Juicer
without any food inside the unit, as this could overheat the motor.
6. If the Juice Bowl is stuck and does not detach from the base, press reverse button “R” for 3 to 5
seconds. Repeat this process 2 or 3 times. Then, push the Juice Bowl upward while turning.
7. Disassemble your juicer in the following order:
1. Remove the Food Pusher
2. Remove the Hopper
3. Remove the Juice Auger
4. Remove the Strainer Holder and Strainer
5. Remove the Juice Bowl
8. The Juicer has a unique cleaning process when switching between different types of juices. To
clean, simply place one of the collectors under the juice spout and pour water though the Food
Chute while the unit is on. This will rinse out most of the residue remaining from your last juicing.
When the water from the slow juicer begins to run clear, it indicates that the unit is clean and ready
to make a new juice recipe.
NOTE: This process is not an alternative to a complete cleaning of each disassembled part.
·9·
7. TIPS
Under the bowl, there is a silicon pad that prevents juice from exiting
through the pulp ejector. When using the Life Juicer, make sure the silicon
pad is fi rmly in place. When cleaning the bowl, make sure to slide the pad
out and run water through the pulp ejector to remove excess food debris.
JUICE CAP
Use the Juice Cap for drip-free pouring directly into your glass and to prevent spillage.
Between juices it is not required to separate and clean parts. Close the Juice Cap and run water
through for simple rinse cleaning.
TIPS FOR JUICING
• Cut food into smaller pieces for optimal extraction, especially fi brous foods to keep fi bers scraping
around the Auger. Insert food at a slower pace and allow the unit to eject all food pulp before
adding more.
• Do not put ice or frozen fruit into the Food Chute. Do not push down too hard. Use the Pusher if
food becomes stuck.
• Insert food at a regular speed to allow all the pulp to be extracted. For maximum effi ciency,
do not rush.
• The juicer is not suitable for juicing very hard, starchy fruits and vegetables such as sugar cane.
8. CLEANING
Wash removable parts in warm, soapy water and then rinse and dry all parts. Regularly clean the
outside of the appliance with a soft damp cloth and dry with a dry towel.
CAUTION: To prevent damage to the appliance, do not use harsh solvents, alkaline cleaning
agents, abrasive cleansers or scouring agents of any kind when cleaning. Do not immerse the
base or power cord in water.
STORE IN A SAFE PLACE
When not in use, store your appliance, all its accessories and the instruction manual in a safe,
dry place.
·10·
9. TROUBLESHOOTING
PROBLEM SOLUTION
Machine does not operate • Check the power cord and power source.
• Ensure that all parts have been assembled correctly.
Machine jams / clogs or stops
operating
• Ensure the food chute is clear and not blocked.
• Ensure that hard seeds have been removed before
juicing and are not stuck in the machine.
• Turn the machine off and switch to reverse for 3
seconds.
• Disassemble the upper section and clear any
remaining pulp.
Squeaking noise when juicing • The squeaking sound is perfectly normal. Do not run
the juicer without any food.
Leaking from underneath the
bowl
•
Be sure the silicone pad is tightly in place after
cleaning.
Strainer Damage
•
Refer to the operating instructions for proper usage
and juicing tips. Remember not to overstuff food or
force food into the juicer.
Too much pulp coming out
•
Cut food into smaller pieces, especially fi brous foods,
to avoid fi bers scraping around the Auger. Insert food
at a slower pace and allow all food pulp to eject the
unit before adding more.
Bowl is stuck and will not
detach from the base
• This is commonly caused by excess food in the bowl.
Press the reverse button for 3 to 5 seconds. Repeat
the process 2or 3 times. Then, push the bowl upward
while turning.
Food Chute / Lid is stuck •
Press the reverse button for 3 to 5 seconds. Repeat
the process 2 or 3
times. You can then press down on
top of the lid while turning.
Color stain on the bowl,
strainer, spinning brush
•
Natural dye from food when juicing is perfectly nor-
mal. To reduce staining, rinse and clean immediately
after each use. Diluted vinegar or bleach can also be
used.
Water mark or scratch on the
Auger
•
Molding marks during the manufacturing process.
These marks and lines on the squeezing screw are
perfectly normal.
Table des matières
Langues :
Autres manuels Viatek presse-agrumes
