1.1. Ensure that the brackets will fit and that they can slide together till there is a 10mmgap
between the two mounting holes for the splitter tie rods. Do this by using the (8) M6 x 1.0 x
16mm long BHCS, (8) M6 x 18mm, and the (8) M6 x 1.0 flanged nuts. You do not need to
tighten these down, just enough to know if the brackets will work once the bumper is put back
on. Once you ensure the holes were drilled properly, remove the brackets and reinstall the
bumper in reverse order
1.2. For the rear outside mounting locations, we need to lengthen the support rods, which are
what the extension units are for. Fully tighten (3) of these onto the support rod. The
support rod has a left hand and a right hand side thread, these go on the right hand thread
side. Note: When tightening these into one another, use lubricant and/or anti-sieze. If
you notice resistance, back out the unit, ensure the threads are clean, and try again.
2.17. Install this lengthened support rod with a clevis in the location shown below. Use a
25mm BHCS, 12mm washer, and a serrated nuts to fasten the support rod to the clevis. Use
a 16mm long bolt, 18mm washer, and the M6 flanged nut to tighten the clevis onto the car.
