NOTE: For security reasons, do not connect the videophone monitor to the power grid
before installation is complete. When
installation of an entrance station on site with insufficientprotection forthosewiththeleast to
extend the life ofthose devices
we recommend filling the space between the surface and the fixing bracket with silicone
sealant outside the bottom for drainage
Condensate.
Videophone wires should not be routed in the same cable as conductors of other
installations (bell, alarm, telecommunication
systems) and not more than 15 m in parallel with another el. Leadership.
WARNING: Failure to follow this procedure for installing the entry station may result in
permanent damage and
loss of warranty!
6.RFID Access Control Management
Warning:
Access and access chips are set up in the VERIA monitor menu.
In standby mode, attach the registered chip to the entrance station, the door will open after
1 beep. If the entry station reads an unregistered card, there will be a 2x beep to alert you to
the unregistered chip.
Press the settings icon on the main menu to enter the interface settings, then tap DEVICE
CONFIGURATION, and then click DOOR STATION LIST. Press the door station you want to
change, press edit, enter your password, and confirm with the # icon to enter the edit
interface. Press ACCESS CONTROL and make the settings below:
6.1 Access status
It is turned on by default. If users do not want to use the card access control feature,
deactivate this item.
6.2 Register 125kHz access chip or cards
Touch the screens tosee the message below:
Attach the chip to the door panel ...... the button at the entrance station starts flashing. In this state,
the user can register new chips for the input station. When a user inserts a new chip to the reading
area on the door panel, the chip will be registered after 1xpin. The same procedure for
