Introduction Safety Warnings
3
Safety Warnings
ELECTRICITY
High voltage exists in, and is supplied to, the
device. A potential shock hazard exists.
TURN POWER OFF
Live power to a device creates a potential shock
hazard. Turn Off power to the device and associ-
ated accessories when servicing the unit.
NO OPEN FLAMES
Open flames from matches, lighters, welding
torches, etc. can ignite fuels and their vapors.
NO SMOKING
Sparks and embers from burning cigarettes or
pipes can ignite fuels and their vapors.
NO VEHICLES
Moving vehicles in the area during service can cre-
ate a potential for personal injury to you or others.
Sparks from starting vehicles can ignite fuels and
their vapors.
USE SAFETY BARRICADES
Unauthorized people or vehicles in the work area
are dangerous. Always use safety cones or barri-
cades, safety tape, and your vehicle to block the
work area.
CLEAN WORK AREA
Dispose of fuel soaked materials properly and
not into trash barrels that may be used by cus-
tomers.
INJURY TO EYES AND SKIN
Unauthorized people or vehicles in the work area
are dangerous. Always use safety cones or barri-
cades, safety tape, and your vehicle to block the
work area.
WARNING
Heed the adjacent instructions to avoid damage
to equipment, property, environment or personal
injury.
READ ALL RELATED MANUALS
Knowledge of all related procedures before you
begin work is important. Read and understand all
manuals thoroughly. If you do not understand a
procedure, ask someone who does
WARNING
This product is to be installed and operated in the highly combustible environment of
a gasoline dispenser where flammable liquids and explosive vapors may be present.
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY
PRECAUTIONS COULD CAUSE DAMAGE TO PROPERTY, ENVIRONMENT,
RESULTING IN SERIOUS INJURY OR DEATH.
The following hazards exist:
1. Electrical shock resulting in serious injury or death may result if power is on
during installation and the device is improperly installed.
2. Product leakage could cause severe environmental damage or explosion
resulting in death, serious personal injury, property loss and equipment damage.
Observe the following precautions:
1. Read and follow all instructions in this manual, including all safety warnings
before installing this equipment.
2. Before installing this device, turn Off, tag/lock out power to the affected
dispenser, including submersible pumps.
3. Evacuate of all unauthorized persons and vehicles from the work area.
4. To protect yourself and others from being struck by vehicles, block off your work
area with cones, safety tape or barricades during installation or service.
5. Do not operate this equipment in hazardous locations with any securing screws
or covers removed. Comply with all applicable codes including: the National
Electrical Code; federal, state, and local codes; and other applicable safety
codes.
