VADA VFB-S35 Manuel utilisateur
SUBMERSIBLE
PUMP
INSTALLATION
MANUAL
VFB-S35
A smooth day is a good day.
That’s why Vada is dedicated
to creating pump solutions
that you can count on. With
a focus on easy selection, simple
installation and high quality, you
can hold your head high knowing
your reputation is protected.
It’s Vada. Performance simplified.
3
Thank you for purchasing the Vada Flow Boss Submersible Pump
VFB-S35! Record the product details here and leave with the owner.
Date purchased:
Purchased from:
Purchase invoice number:
Product serial number:
Product model number:
THANK YOU
Scan for
set up
support
4VADA FLOW BOSS SUBMERSIBLE PUMP VFB-S35 INSTALLATION MANUAL
KNOW YOUR PRODUCT VFB-S35
The Vada Flow Boss Submersible Pump VFB-S35 is built to transfer water from a water tank, to a
garden or house to suit the desired application. This space friendly quiet operator can be submerged
up to 7 metres to get the job done.
10m Power cable
Stainless steel motor
shaft and pump casing
32mm to 25mm
Reducing elbow MI
Suction port
32mm MI outlet
• Built to handle clean water with no suspended solids or abrasive material
• Optimal operating range: 20–14 metres head, 44–66 litres per minute
• Max water temp: 40°C
• Max submersion depth: 7m
• IP68 (Motor)
• Use a pipe size with a minimum 32mm internal diameter to reduce friction loss.
• Install a check valve within the vertical pipework to stop any water running back into
the tank therefore protecting the pump internals.
• If you’re installing the VFB-S35 with the VFB-DSU, you will require a wall mount kit.
HELPFUL HINTS
5
SPECIFICATIONS VFB-S35
COMPATIBLE VADA PRODUCTS:
If using tank water only, you will also require a Vada Flow Boss Auto Pressure Control.
If you are using tank and mains water source switching, you will require either the Vada Flow Boss
Digital Water Switching Unit or the Vada Flow Boss Mechanical Water Switching Unit.
Vada Flow Boss
Automatic Pressure
Control VFB-APC
Vada Flow Boss
Digital Water
Switching Unit
VFB-DSU
6VADA FLOW BOSS SUBMERSIBLE PUMP VFB-S35 INSTALLATION MANUAL
KNOW YOUR PRODUCT VFB-APC
The Vada Flow Boss Auto Pressure Control VFB-APC gives you perfect control of household
pressure pumps, guaranteed. Designed with an LED light panel to signal the state of operation,
a built in pressure gauge to allow for adjustable cut-in pressure and a 24 hour reset function
for hassle free operation.
Power On indicator
Pump On indicator
Error indicator
Restart button
Three-wire cable
25mm MI Inlet
Cut-in pressure
adjustment point
25mm MI Outlet
• Inlet: 25mm MI
• Outlet: 25mm MI
• Max operating pressure: 1000kPa / 10 bar
• Minimum pump pressure: 250kPa / 2.5 bar
• Min – max water temperature: 1°C – 65°C
• Min – max ambient temperature: 1°C – 40°C
• Supply voltage: 1~240V 50Hz
• Cut-in pressure: 150– 300kPA / 1.5 – 3 bar
• Max power: 1.5kW
• Max current: 10A
• IP rating: IP65
• Ensure your pump is equipped with two isolation valves. This allows for fuss free troubleshooting
on the suction and discharge lines, should you need it.
• When paired with the VFB-S35, the VFB-APC must be left at the default 1.5 bar cut in.
SPECIFICATIONS VFB-APC
HELPFUL HINTS
INTERPRETING THE APC VFB-APC
Error
Pump on
Power on
Restart
1~240V 50 Hz
Max 1.5kW 10A
Max 65°C
IP65
Max 1MPa (10 bar)
AUTO PRESSURE CONTROL
VFB-APC
Error
Pump on
Power on
Restart
1~240V 50 Hz
Max 1.5kW 10A
Max 65°C
IP65
Max 1MPa (10 bar)
AUTO PRESSURE CONTROL
VFB-APC
Error
Pump on
Power on
Restart
1~240V 50 Hz
Max 1.5kW 10A
Max 65°C
IP65
Max 1MPa (10 bar)
AUTO PRESSURE CONTROL
VFB-APC
7
Green light
The VFB-APC is connected to the power
supply successfully.
Yellow light
The connected pump is operating.
Note: On initial start up the pump will run until
the supply line is primed to remove all air.
Red light
Flashing red: Loss of flow detected. While the
red light is flashing, the pump will remain on for
20 seconds, then turn off as it tries to re-prime
itself. It will attempt this several times.
Solid red: The pump has not been able to
detect water and cannot re-prime itself. The
pump will turn off for 24 hours, or until reset.
To reset, turn the power off, then on or
press the restart button.
8VADA FLOW BOSS SUBMERSIBLE PUMP VFB-S35 INSTALLATION MANUAL
KNOW YOUR PRODUCT VFB-DSU
The Vada Flow Boss Digital Water Switching Unit VFB-DSU allows for water source switching between
tank and mains water. With a large interactive panel, the VFB-DSU provides system information including
a log of rain water used, real time flow rate, water pressure, current and error conditions.
Pump inlet
Water outlet
Mains inlet
LCD display
Power ON/error status
Pump ON LED indicator
Time set
Mode selection
Up/down toggle button
Error reset
9
SPECIFICATIONS VFB-DSU
APPLICATIONS
The Vada Flow Boss Submersible Pump VFB-S35 is suitable for the following applications:
Water source
switching
(tank/main)
Domestic
pressure
systems
Domestic
water transfer
(clean water
only)
Hose watering Irrigation
systems
The Vada Flow Boss Submersible Pump VFB-S35 is not suitable for the following applications:
Borehole
applications
Pumping
liquid
containing
abrasive
solids (stones,
ceramics etc.)
Note: This is not intended as a dirty drainage water sump pump.
• Mains water supply inlet: 25mm FI
• Pump connection: 25mm FI
• Water outlet connection: 25mm FI
• Minimum mains pressure: 100kPA / 1 bar
• Max operating pressure: 1000kPA / 10 bar
• Minimum flow rate: 1 lpm
• Voltage: 1~230 – 240V 50Hz
• Maximum electrical load: 10A / 2400W
• IP Rating: IP44
• View the complete Digital Water Switch Manual for further details on set up, operation and
troubleshooting.
HELPFUL HINT
10 VADA FLOW BOSS SUBMERSIBLE PUMP VFB-S35 INSTALLATION MANUAL
INSTALLATION
PREPARING FOR INSTALLATION
For successful installation, ensure you have all pieces required for your product combination.
Vada Flow Boss Submersible Pump VFB-S35
What we’ve supplied:
What you’ll need to supply:
Vada Flow Boss
Submersible Pump
VFB-S35
Thread tape
Power cable
Hose clamps (for
flexible discharge
pipe installs)
x1 Isolation valve 25mm Y strainer
(aka inline strainer)
Check valve Cable ties Access to a
10A outdoor
power point
Nylon rope or
stainless steel
cable (to lower
the pump)
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels VADA Pompe à eau
VADA
VADA V-150VF Manuel utilisateur
VADA
VADA VFB-S75 Manuel utilisateur
VADA
VADA reece V150 Manuel utilisateur
VADA
VADA V30-RC Manuel utilisateur
VADA
VADA VFB-J90 Manuel utilisateur
VADA
VADA VFB-HM110 Manuel utilisateur
VADA
VADA VFB-J40 Manuel utilisateur
VADA
VADA V110-H Manuel utilisateur
VADA
VADA VFB-HM80 Manuel utilisateur
VADA
VADA VFB-J60 Manuel utilisateur
Manuels Pompe à eau populaires d'autres marques
Sykes AmeriPumps
Sykes AmeriPumps GP100M Guide de dépannage
DUROMAX
DUROMAX XP WX Series Manuel utilisateur
BRINKMANN PUMPS
BRINKMANN PUMPS SBF550 Manuel utilisateur
Franklin Electric
Franklin Electric IPS Manuel utilisateur
Xylem
Xylem e-1532 Series Manuel utilisateur
Milton Roy
Milton Roy PRIMEROYAL Manuel utilisateur