V-tech LS1400 Manuel utilisateur
User’s manual
www.euphones.vtech.com
LS1400-B
1
1. IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of re, electric shock and injury, including the
following:
Read and understand all the instructions.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Do not use this product near water (for example, near a bath tub, kitchen
sink, swimming pool).
Do not expose the telephone to direct sunlight or extreme cold environment.
Do not put the telephone close to heating sources such as radiators,
cookers, etc.
Do not overload wall outlets and extension cords as this can result in the risk
of re or electric shock.
Unplug this product from the wall outlet and refer servicing to VTech/
distributor under the following conditions:
When the power supply cord or plug is damaged or frayed.
If the product does not operate normally by following the operating
instructions.
If the product has been dropped and the cabinet has been damaged.
If the product exhibits a distinct change in performance.
Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Use only the supplied NiMH (Nickel Metal Hydride) batteries! The operation
periods for the handsets are only applicable with the default battery
capacities.
The use of other battery types or non-rechargeable batteries/primary cells
can be dangerous. These may cause interference and/or unit damages. The
manufacturer will not be held liable for damage arising from such
non-compliance.
Do not use third party charging bays. The batteries may be damaged.
Please note the correct polarity while inserting the batteries.
Battery should not be exposed to excessive heat such as bright sunshine or
re and immersed in water.
1.
2.
3.
4.
5.
6.
7.
•
•
•
•
8.
9.
10.
11.
12.
13.
14.
2
DISPOSAL WARNING
When this crossed-out wheeled bin symbol is attached to a
product, it means the product is covered by the European
Directive 2002/96/EC.
All electrical and electronic products/battery should be disposed
of separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.
The correct disposal of your old appliance/battery will help prevent potential
negative consequences for the environment and human health.
For more detailed information about disposal of your old appliance/battery,
please contact your city ofce, waste disposal service or the shop where you
purchased the product.
If you have questions about this product, or having difculty with setup or
operation, contact our Customer Service Centre.
POWER ADAPTOR INFORMATION
Power
adaptor
VTech (Qingyuan) Plastics & Electronics Co. Ltd. -
Model: VT04EEU06045, Input: 100-240V AC 50/60Hz 150mA,
Output: 6VDC 450mA (EU plug).
Battery AAAx2, Ni-MH, 400mAh.
For pluggable equipment, the socket outlet shall be installed near the equipment
and shall be easily accessible.
1.
2.
3.
3
2.1 Package Contents
The package contains the following items:
1 Handset
1 Base station
1 Power adaptor for base station
1 Telephone line cord
2 AAA NiMH rechargeable batteries
1 User’s manual
2.2 Connect the Base
•
•
•
•
•
•
2. SET UP THE TELEPHONE
NOTE
Use only the supplied power adapter.•
To telephone
wall jack
To wall power
outlet
12
4
2.3 Install and Charge the Handset Battery
NOTES
Use only the supplied AAAx2, Ni-MH, 400mAh batteries.
If you do not use the handset for a long time, disconnect and remove the
battery to prevent possible leakage.
•
•
3
2
1
5
3.1 Overview of the Handset
EARPIECE
MENU / OK
MUTE / DELETE / INTERCOM
UP / CALL LIST / VOLUME UP
DOWN / REDIAL LIST / VOLUME DOWN
TALK ON / RECALL(FLASH)
TALK OFF / CANCEL / BACK
ALPHANUMERIC KEYPAD, (STAR), (HASH)
SPEAKERPHONE
MICROPHONE
RECALL
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
3. GET TO KNOW YOUR PHONE
6
3
1
2
4
5
7
8
9
10
6
3.2 Overview of the Base Station
PAGE
Press to page all registered handset(s). Handset(s) will ring for approximately
60 seconds.
Press and hold for 5 seconds to enter the registration mode.
2. CHARGING CRADLE
For charging the handset.
1.
1
2
7
3.3 Handset LCD display icons and symbols
The LCD display gives you information on the current status of the telephone.
Display icons Icons can be Steadily On (visible), Flashing or Off (not visible)
Scroll up / down the menu items / Phonebook list / Redial list / Call
List.
Steadily on when the handset is with reception range. Flashes
when out of range or not registered to the base.
Steadily on when a call is in progress.
Steadily on when the ringer is switched off.
Steadily on when an alarm is set. Flashes when the alarm time set
before reaches.
Steadily on when the keypad is locked.
Steadily on when a message is received at the telephone service
provider.
Steadily on when the battery is fully charged.
Whole icon ashes when the battery is charging.
Flashes when low battery power level is detected and the handset
needs charging.
Steadily on when when you have received missed calls.
Steadily on when the speakerphone is turned on.
8
3.4 Menu Navigation
In idle mode:
Press .
pqto scroll to a menu option.
Press to select.
-OR-
Press to return to previous screen.
-OR-
press and hold to return to idle mode.
1.
2.
3.
HS SETTINGS REGISTRATION DEFAULT
ALARM
RING SETUP
TONE SETUP
LANGUAGE
RENAME HS
AUTO ANSWER
DATE & TIME
PIN? PIN?
CALL LIST PHONEBOOK BS SETTINGS
Review Call List
Under a selected
Call List entry:
DETAILS
ADD TO PB
DELETE
DELETE ALL
CATEGORY
Under a selected
Phonebook entry:
ADD
VIEW
EDIT
DELETE
DELETE ALL
PB STATUS
DELETE HS
DIAL MODE
FLASH TIME
CHANGE PIN
9
4. USE YOUR PHONE
4.1 Switch On/Off the Handset
Press and hold .
4.2 Make a Call
Enter phone number. Press / .
4.3 Answer an Incoming Call
Press / .
-OR-
If AUTO ANSWER is ON:
Lift the handset.
4.4 Adjust Listening Volume During a Call
To adjust listening volume during a call:
Press pq.
4.5 Mute/unmute a Call (Microphone Off/On)
To mute or end mute the microphone during a call:
Press .
4.6 End a Call
Press .
-OR-
Place the handset on the base.
4.7 Turn the Handset Ringer On/Off
Press and hold .
4.8 Turn the Keypad Lock On/Off
Press and hold .
Table des matières
Autres manuels V-tech Téléphone sans fil
V-tech
V-tech CS2111 - 2.4 GHz Cordless Phone Manuel utilisateur
V-tech
V-tech VT 1911 Manuel utilisateur
V-tech
V-tech CS6124 Manuel utilisateur
V-tech
V-tech DS6621 Manuel utilisateur
V-tech
V-tech LS6195 Manuel utilisateur
V-tech
V-tech VC7151 Manuel utilisateur
V-tech
V-tech DECT CS6429-2 Manuel utilisateur
V-tech
V-tech VT 1711 Manuel utilisateur
V-tech
V-tech i 6773 Manuel utilisateur
V-tech
V-tech IA6765 - V-Tech Cordless Dual Handset Manuel utilisateur
V-tech
V-tech 918 ADX Manuel utilisateur
V-tech
V-tech ES2210-2A Manuel utilisateur
V-tech
V-tech T2340 - 2.4 GHz Dual Handset System Guide de l'utilisateur
V-tech
V-tech Cordless Phone with Digital Answering System and Caller... Manuel utilisateur
V-tech
V-tech VT2625 Manuel utilisateur
V-tech
V-tech VSP600 Manuel utilisateur
V-tech
V-tech VT1047 Manuel utilisateur
V-tech
V-tech CS6719 Manuel utilisateur
V-tech
V-tech CS6919 Manuel utilisateur
V-tech
V-tech 6032 Manuel utilisateur
