V-tech LS1500-B Manuel utilisateur
User’s manual
www.euphones.vtech.com
LS1500-B
1
1. IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of re, electric shock and injury, including the
following:
Read and understand all the instructions.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Do not use this product near water (for example, near a bath tub, kitchen
sink, swimming pool).
Do not expose the telephone to direct sunlight or extreme cold environment.
Do not put the telephone close to heating sources such as radiators,
cookers, etc.
Do not overload wall outlets and extension cords as this can result in the risk
of re or electric shock.
Unplug this product from the wall outlet and refer servicing to VTech/
distributor under the following conditions:
When the power supply cord or plug is damaged or frayed.
If the product does not operate normally by following the operating
instructions.
If the product has been dropped and the cabinet has been damaged.
If the product exhibits a distinct change in performance.
Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Use only the supplied NiMH (Nickel Metal Hydride) batteries! The operation
periods for the handsets are only applicable with the default battery
capacities.
The use of other battery types or non-rechargeable batteries/primary cells
can be dangerous. These may cause interference and/or unit damages. The
manufacturer will not be held liable for damage arising from such
non-compliance.
Do not use third party charging bays. The batteries may be damaged.
Please note the correct polarity while inserting the batteries.
Battery should not be exposed to excessive heat such as bright sunshine or
re and immersed in water.
1.
2.
3.
4.
5.
6.
7.
•
•
•
•
8.
9.
10.
11.
12.
13.
14.
2
DISPOSAL WARNING
When this crossed-out wheeled bin symbol is attached to a
product, it means the product is covered by the European
Directive 2002/96/EC.
All electrical and electronic products/battery should be disposed
of separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.
The correct disposal of your old appliance/battery will help prevent potential
negative consequences for the environment and human health.
For more detailed information about disposal of your old appliance/battery,
please contact your city ofce, waste disposal service or the shop where you
purchased the product.
If you have questions about this product, or having difculty with setup or
operation, contact our Customer Service Centre.
POWER ADAPTOR INFORMATION
Power adaptor VTech (Qingyuan) Plastics & Electronics Co. Ltd. - Model:
VT04EEU06045,
Input: 100-240V AC 50/60Hz 150mA, Output: 6VDC 450mA
(EU plug).
Ten Pao International Ltd. - Model: S003IV0600045,
Input: 100-240V AC 50/60Hz 150mA, Output: 6VDC 450mA
(EU plug).
Battery AAAx2, Ni-MH, 400mAh.
For pluggable equipment, the socket outlet shall be installed near the equipment
and shall be easily accessible.
1.
2.
3.
3
2.1 Package Contents
The package contains the following items:
1 Handset
1 Base station
1 Power adaptor for base station
1 Charger with power adapter
1 Telephone line cord
2 AAA NiMH rechargeable batteries
1 User’s manual
2.2 Connect the Corded Base Station
•
•
•
•
•
•
•
2. SET UP THE TELEPHONE
NOTE
Use only the supplied power adapter.•
1
2To wall power
outlet
To telephone
wall jack
4
2.3 Install and Charge the Handset Battery
NOTES
Use only the supplied AAAx2, Ni-MH, 400mAh batteries.
If you do not use the handset for a long time, disconnect and remove the
battery to prevent possible leakage.
•
•
1
2
3
5
3. GET TO KNOW YOUR PHONE
3.1 Overview of the Handset
1
2
4
5
6
7
8
9
11
12
3
10
14
13
6
1. / – VOLUME UP/VOLUME DOWN
2. M1 / M2 – DIRECT MEMORY KEYS
Press and hold to dial the number stored in the memory key.
3. R – FLASH (RECALL)
In predial mode or during a call: Press to insert a Flash.
4. – CLEAR/BACK/MUTE/INTERCOM
5. – UP/CALL LOG
6. – TALK OFF
7. – DOWN/REDIAL LIST
8. ALPHANUMERIC KEYPAD, *, #
Press to insert a digit / character / */ #
1key in idle mode: Press and hold to access the voice mail.
*key in idle mode: Press and hold to enable or disable the keypad lock.
*key during a call (in Pulse mode): Press to switch to tone mode.
# key in idle mode: Press and hold to turn on / off the ringer.
0 key in predialing / number editing mode: Press and hold to insert a pause.
# key in Call Log mode: Press to review caller’s number if applicable.
9. MICROPHONE
10. – TALK/SPEAKERPHONE
11. – MENU/OK
12. – AMPLIFY
13. LED
Steadily on when the audio boost is turned on.
Flashes when there is an incoming call.
14. EARPIECE
7
3.2 Overview of the Base Station
PAGE
Press to page all registered handset(s). Handset(s) will ring for approximately
60 seconds.
Press and hold for 5 seconds to enter the registration mode.
2. CHARGING CRADLE
For charging the handset.
1.
2
1
8
3.3 Handset LCD Display Icons and Symbols
The LCD display gives you information on the current status of the telephone.
Display icons Icons can be Steadily on (visible), Flashing or Off (not visible)
Steadily on when there is a stronger reception signal.
Flashes when there is a weaker reception signal.
Off when there is no reception signal.
Steadily on when a call is in progress.
Flashes when there is an incoming call.
Steadily on when an intercom call is in progress.
Flashes when there is an incoming intercom call or the call is on
hold.
Steadily on when the speakerphone is turned on.
Steadily on when the answering machine (TAM) is turned on.
Flashes when new TAM message is received.
Steadily on when an alarm is set.
Flashes when the alarm time set before reaches.
Steadily on when there are new and unread voicemail messages.
Steadily on when the keypad is locked.
Steadily on when the ringer is switched off.
Steadily on when you have received missed calls.
9
Steadily on when there are more digits before the text currently
displayed.
Steadily on when there are more digits after the text currently
displayed.
Steadily on when the battery is two-third charged.
Steadily on when the battery is one-third charged.
Flashes when low battery is detected, indicating that it needs
charging.
Animates when battery is charging.
Autres manuels pour LS1500-B
1
Table des matières
Autres manuels V-tech Téléphone sans fil
