USKEYVISION UVGL-2 Manuel utilisateur
UVGL-2
User Manual • Uživatelský manuál •
Užívateľský manuál • Használati utasítás •
Benutzerhandbuch
2
English
3 –9
Čeština
10-16
Slovenčina
17-23
Magyar
24-30
Deutsch
31-37
3
The product user guide contains product features, how to use, and the operating
procedure. Read the user manual carefully to get the best experience and avoid
unnecessary damage. Keep this manual for future reference. If you have any questions
or comments about the device, please contact the customer line.
✉www.alza.co.uk/kontakt
✆+44 (0)203 514 4411
Importer
Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz
4
Introduction
•Combination of 204 LED lights has low calorific value and long-standby battery
life.
•3200K brightness adjustment from 0% to 100%.
•5600K brightness adjustment from 0% to 100%.
•Using professional LED driver chip, the light is stable, and the efficiency is as high
as 93%.
•High brightness, maximum of 1000 lumens. Suitable for supplementary
photography lighting scene simulations.
•Intelligent display of residual power.
•Tie a hand rope through the lanyard hole. You can hang the light wand by the
lanyard.
•Applications: photographic lighting scene simulations, emergency light in a car,
supplementary photography lighting and so on.
Package List
•LED light wand ×1
•Lanyards ×1
•USB cable ×1
•Carrying bag ×1
•Remote control ×1
5
Product Description
A. Lampshade
B. Brightness –
C. Brightness +
D. ON/OFF/Colour Temperature
E. Battery indicator light
F. Charging interface
G. ¼” screw bolt
Installation
Screw in the ¼” screw and the nut at the bottom of the light and tighten it properly.
Rotate the angle adjustment knob to change the angle of the supplementary light wand,
so that the lamp can be adjusted to the appropriate position.
6
Use for Professional Photography Lighting
Press the function button for a short time to start up and press the function key for two
seconds to shut down.
Click the function button in the power-on state to switch colours. The initial lighting
colours are as follows: white light, neutral light, warm light, red light, green light, blue
light, red and green lights, red and blue lights, green and blue lights, special effect
modes, white light and so on.
•To brighten the light up, click the Brightness + button.
•To dim the light down, click the Brightness –button.
When the light is off, the indicator light is yellow when charging and green when fully
charged. If the yellow light indicator light flashes slowly, it indicates that the power level
is at less than 30%. If the yellow light indicator flashes at a regular speed, it indicates
that the power level is between 30% to 70%. If the yellow indicator flashes quickly, it
indicates that the power level is above 70%.
When in use, the power indicator displays the power. The indicator shows a green light
when the power level is at more than 70%. The indicator shows yellow light when the
power level is between 40% and 70%. The indicator shows a red light when the power
level is between 10% and 40%. The indicator flashes red light when the power level is
less than 10%, which requires immediate charging.
Please do not turn on the light during recharging in order to protect the battery life.
Because of the charging, the internal temperature is increased, and if combined with the
light being turned on, the result might be shorter product life.
The natural discharge rate of lithium batteries releases 1% or less of their charge per
day when they are not in use. It is recommended that when it is not used for a long time,
the device is fully charged. Normally, it should be charged once in about three months.
Standard battery life varies between 2 to 32 hours (based on brightness used). Charging
takes between 3 to 4 hours when charged with 5V/2A adapter (not included).
To switch between the special effect modes, just press the “+” or “–“ button in the special
effect modes to switch between the following effect modes:
Police car
Ambulance
car
Fire engine
Party 1
Party 2
HSI Fast
Gradient
Strobe
7
Specifications
Power
10W
Battery voltage
7.4V DC
Light angle
120°
Colour temperature
3200/4500/5600K
Chromogenic index
RA>95
Illuminance
1000 lumens
Dimension
550×33×23 mm
Weight
226g
Operating temperature
0~40 °C
Note: The light source of this lamp is not replaceable. When the light source reaches the
end of its life, the entire lamp shall be replaced.
Notes
•Do not place or use this product in high temperature or extreme environment,
and do not expose it to the sun.
•Avoid placing or using photographic light wand near alcohol, gasoline, flammable
or volatile solvents, which can cause fire or damage the photographic light wand.
•Do not expose the non-waterproof light wand to water or other liquids, causing it
to short circuit or cause any damage.
•Please do not disassemble the product without authorization, and do not shake,
knock or impact the light wand vigorously.
•Children should use the product with the help of guardians to avoid direct
exposure and eye harm.
•Please fully charge the product before the first use and recharge it every month
while not using.
•Please do not stare at the light bead when the photography light wand is on, to
avoid direct light and consequent eye harm.
•In the normal operation, the temperature may rise. Please take it carefully during
use or after use to avoid scalding.
•Before using this product, please check its voltage demand to avoid damage
caused by using the wrong voltage or power.
•The light wand produces a high luminous light when it is turned on. Please do not
cover the luminous surface to avoid damage.
8
Warranty Conditions
A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you
need repair or other services during the warranty period, contact the product seller
directly, you must provide the original proof of purchase with the date of purchase.
The following are considered to be a conflict with the warranty conditions, for which the
claimed claim may not be recognized:
•Using the product for any purpose other than that for which the product is intended
or failing to follow the instructions for maintenance, operation and service of the
product.
•Damage to the product by a natural disaster, the intervention of an unauthorized
person or mechanically through the fault of the buyer (e.g. during transport, cleaning
by inappropriate means, etc.).
•Natural wear and aging of consumables or components during use (such as
batteries, etc.).
•Exposure to adverse external influences, such as sunlight and other radiation or
electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage,
electrostatic discharge voltage (including lightning), faulty supply or input voltage and
inappropriate polarity of this voltage, chemical processes such as used power
supplies, etc.
•If anyone has made modifications, modifications, alterations to the design or
adaptation to change or extend the functions of the product compared to the
purchased design or use of non-original components.
9
EU Declaration of Conformity
The product complies with the essential requirements of Directives 2014/30/EU and
2011/65/EU including amendments 2015/863/EU.
WEEE
This product must not be disposed of as normal household waste in accordance with
the EU Directive on Waste Electrical and Electronic Equipment (WEEE - 2012/19 / EU).
Instead, it shall be returned to the place of purchase or handed over to a public
collection point for the recyclable waste. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of
this product. Contact your local authority or the nearest collection point for further
details. Improper disposal of this type of waste may result in fines in accordance with
national regulations.
10
Uživatelská příručka k produktu obsahuje funkce produktu, návod k použití a postup
obsluhy. Přečtěte si pozorně uživatelskou příručku, abyste získali co nejlepší zkušenosti a
předešli zbytečným škodám. Tento návod si uschovejte pro budoucí použití. Máte-li
jakékoli dotazy nebo připomínky k zařízení, obraťte se na zákaznickou linku.
✉www.alza.cz/kontakt
✆+420 255 340 111
Dovozce
Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz
Table des matières
Langues :
Manuels Équipement d'éclairage populaires d'autres marques
Qazqa
Qazqa Suplux SL 3 Black 103062 Manuel utilisateur
Commercial Electric
Commercial Electric 54568141 Manuel utilisateur
CREE LIGHTING
CREE LIGHTING 304 Series Manuel utilisateur
Goobay
Goobay 49867 Manuel utilisateur
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Manuel utilisateur
Alkalite
Alkalite Krypton KT-81 Manuel utilisateur
