M6 SERIES
ACOUSTIC SPECIFICATIONS
Tweeter uses Air Motion Transformer
6.5-inch woofer
Frequency response + / - 3 dB: 55Hz-25kHz
l60/320W Power Handling
SPL 89dB + /-1.5dB
lmpedance 4 Ohms
Finish: Satin black
Dimensions (H x D x W): 327 x 93 x 276 mm
WWW.UANDKSOUND.COM
MODELS AND FEATURES
PEQ
The EQ adjustment knobs
enable the user to
custom-tailor one band of
parametric equalization for
their subwoofer, which can
be used to add boost to the
low end of the response, or can be used to cut out an excessively
loud room resonance. The frequency knob selects the frequency for
the filter, the bandwidth knob selects how wide or narrow the fiIter is
(the higher the bandwidth, the broader the effect) , and the level
knob can be used to add up to 6dB of boost or 14.5 dB of cut.
POWER MODE
Selects the turn on stimuli that will put the
amplifer in ready mode .“AUTO” setting senses
a signaI on the inputs and automaticaIly puts
the amp in ready mode. “ON” setting puts the
amplifier constantly in ready mode so that it
can be controlled by the master power switch
on the front panel. In “AUTO” mode, the
amplifer will take approximately 15 minutes to
turn off from ready to standby mode.
LOW LEVEL UNBALANCE INPUT
RCA style jacks receive the audio signaI from standard line level audio
sources. When used in a two channel stereo system, both the left and
right audio inputs should be connected and are internally summed to
a mono output. The adjustable crossover is in effect when using the
left or right inputs. When using an amplifer with an audio source that is
mono and prefiltered, the LFE input should be used; this bypasses the
onboard low pass crossover for more accurate reproduction of the
incoming signal.
M1200N amplifier panel layout
