4215-128 Rev 1 TyloHelo Inc. Page 9
Step 5:
Making the electrical connections
The 12vdc input cable on your control should be
connected to either our APV-8-12 or APV-60-12
low voltage transformer, included with your
specific light kit.
8-port splitter kit included with optional light kits.
Your optional LED light kit includes one 8-port
splitter with RJ45 connections. You can connect
up to 8 LED light fixtures to your system using
this splitter.
DO NOT CONNECT A HOME AUTOMATION OR
HOME NETWORK SYSTEM TO THIS SPLITTER!!
DO NOT EXCEED THE RATED WATTAGE OF THE
TRANSFORMER YOU ARE USING!!
If the CAT5 cables provided in your kit are not
long enough, you may source any CAT5 cable
with RJ45 ends (Ethernet) as a substitute.
This splitter can be located in any convenient
location such as on top of your sauna or in an
adjacent utility room. Never locate the splitter
inside sauna cabin UNLESS you are enclosing it
inside a water-tight junction box!
Connect the 12vdc “IN” cable from the touch control
to the 12vdc transformer using an RJ45 in-line
connector. (if additional length is needed, use any
standard CAT5 Ethernet cable) The brown and blue
wires from the transformer will need to be connected
to a constant 120vac/15amp power source.
Note: Your 12vdc transformer may differ from that shown in
photos.
Connect the 12vdc “OUT” cable from the touch
control to the male plug on the 8-port splitter via the
RJ45 in-line connectors. Once this is done, any of the
8 open ports on the splitter are “live” and can be
connected to the LED light bulbs, strips or mini-spot
using the shorter (1 & 2 meter cables) provided in
your kit. Any extra cable can be simply rolled up and
secured with a twist-tie.
If only installing one light fixture, you can connect
directly to the fixture with your CAT5 cable and will
not need the 8-port splitter.
