Turbosound Milan M18 Manuel utilisateur

Quickstart Guide

Milan M18

Milan M18 Quickstart Guide v1.0 - Page - 1

Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information

about this or any other TURBOSOUND product, please contact us. A detailed user manual on this product is available from

our web site at www.turbosound.com.

Unpacking

After unpacking the unit, please check carefully for damage. If damage is found, please notify your supplier at once. You,

the consignee, must instigate any claim. Please retain all packaging in case of future re-shipment.

Getting Started

FILTER PHASE OUTPUT LINK LINE IN

RIGHT

LEFT

ON SIG

LIMIT

LEVEL

80Hz

125Hz

180O

010

1. Turn the LEVEL control fully anticlockwise (MIN).

2. Connect the left and right mixing console outputs to the LINE IN connectors either via 2-pole or 3-pole jacks or balanced

XLRs.

3. Connect the OUTPUT XLRs to the left and right powered mid/high speakers.

4. Connect any additional powered subwoofers to the LINK outputs

5. Switch on the mixer or other source and make sure the output faders or master output level controls are turned fully

down.

6. Connect the AC mains cable to the Milan loudspeaker and turn on the mains switch. The ON LED will illuminate to

indicate that mains power is connected.

7. Increase the output level of the signal source to a normal operating level.

8. Slowly turn up the Milan loudspeaker’s level control until a suitable volume level is reached. The SIG LIMIT LED will

illuminate green to indicate signal present, and flash red occasionally to indicate limiting, but excessive or prolonged

limiting illumination indicates that the input signal is too high or additional speakers are required.

9. The FILTER switch selects the subwoofer’s low pass frequency and allows you to choose the crossover frequency at

which the high-pass signal is sent to the mid/high cabinets. Experiment to obtain the best results for your loudspeakers.

You can also reverse the phase of the sub signal relative to the mid/high signal using the PHASE switch. The ground lift

switch allows you to reduce hum if a ground loop is present. Note that all equipment MUST be grounded.

10. When shutting down the Milan system, first turn down the input level controls, then switch off the mains power before

turning off the mixer or signal source.

Quick Start Guide

Milan M18

Milan M18 Quickstart Guide v1.0 - Page - 2

Technical Specifications

Dimensions (h x w x d) 600mm x 700mm x 600mm (23.6” x 27.6” x 23.6”)

Net weight 45 kg (99lbs)

Components 1 x 18”(457mm) LF driver

Frequency response 36Hz – 80Hz/125Hz ±3dB, 28Hz

–

80Hz/125Hz ±10dB

Maximum SPL 125dB continuous, 131dB peak

Construction 18mm plywood enclosure finished in dark blue textured paint

Connectors Input: (2) Jack/XLR female, wired pin 2 hot; Link: (2) XLR male, wired pin 2 hot;

Output: (2) XLR male, wired pin 2 hot; IEC mains connector

Controls Level, switchable high-pass filter at 80Hz or 125Hz, phase invert, ground lift

Indicators Signal

Limit bi-colour LED (signal: green, limit: red), power LED

Amplifier TYPE: Class D

POWER OUTPUT: 1000 watts continuous @ 8 ohms (1kHz, 0.01% THD)

MAX INPUT: +20dBu

USER EQUALISATION: switchable low-pass filter at 80Hz or 125Hz

LIMITING: Thermal limiter, current overload

POWER REQUIREMENTS: 110V AC @ 50Hz or 230V AC @60Hz

Spares and Accessories

LS-1816 18” low frequency loudspeaker

RC-1816 Recone kit

M18AMP Amplifier module

Turbosound Ltd., Star Road, West Sussex RH13 8RY, UK

tel: +44(0)1403 711447 fax: +44(0)1403 710155 www.turbosound.com

version 1.0 05/10

Table des matières

Autres manuels Turbosound Intervenants

Turbosound

Turbosound NuQ102-AN Manuel utilisateur

Turbosound

Turbosound Aspect TA-500 Manuel utilisateur

Turbosound

Turbosound iQ Series Manuel utilisateur

Turbosound

Turbosound KT-HP Series Manuel utilisateur

Turbosound

Turbosound Milan Mi0 Manuel utilisateur

Turbosound

Turbosound Flex Array TFA-600H Manuel utilisateur

Turbosound

Turbosound TCI32-T-WH Manuel utilisateur

Turbosound

Turbosound TCS SERIES USER Manuel utilisateur

Turbosound

Turbosound iQ8 Manuel utilisateur

Turbosound

Turbosound QLight TQ-425 Manuel utilisateur

Turbosound

Turbosound iX Series Manuel utilisateur

Turbosound

Turbosound TCS-AN Series Manuel utilisateur

Turbosound

Turbosound QLight TQ-310 Manuel utilisateur

Turbosound

Turbosound QLight TQ-115 Manuel utilisateur

Turbosound

Turbosound TCS-C50T Manuel utilisateur

Turbosound

Turbosound TCS-1061 Quickstart and rigging Manuel utilisateur

Turbosound

Turbosound iNSPIRE iP300 Manuel utilisateur

Turbosound

Turbosound TFM122M Manuel utilisateur

Turbosound

Turbosound TSTAND-01 Manuel utilisateur

Turbosound

Turbosound TCS-1061 Quickstart and rigging Manuel utilisateur

Turbosound

Turbosound IMPACT 35T Manuel utilisateur

Turbosound

Turbosound TXD-081 Manuel utilisateur

Turbosound

Turbosound iNSPIRE iP300 Manuel utilisateur

Turbosound

Turbosound QFLEX WP Series Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur