2
SPECIFICATION
NAME OF APPLIANCE SUPERTRON COMMERCIAL TWIN GRILL WITH SOLID GRILL
PLATE
MODEL NO. HC-T-600, HC-T-900, HC-T-1200
MANUFACTURED BY TU’S BROS PTY LTD
77 MAIN ROAD, CLAYTON SOUTH
VIC 3169 AUSTRALIA
CERTIFICATE NO. 6235
General Description
Heavy Duty Commercial Solid Grill Plate incorporating a toasting grill area, beneath the grill plate, Manufactured in
stainless steel outer panels and mild steel inner panels with enamel finish.
Heating of the Grill Plate and Toasting Grill area is by means of cast ported burners (every 300mm wide) running front
to back beneath the solid grill plate.
The unit incorporates flame failure protection to all burners, operating a combination gas cock and flame failure valve,
with pilot ignition to the burners.
Fluing from the burner grill/toasting area is directed to the rear of the appliance into the splashback. The splashback
deflects the products of combustion from the rear walls, the outer panels are attached to a square tubular sub frame
which is rust proofed.
Exterior Panels 304/No4/1.2mm stainless steel
Sub Frame 25x25x2 square tube
Rear Panel 304/No4/1.2mm stainless steel
Insulation Tombo Board
Heating of Unit Is by means of standard Bunsen burners, cast iron with ports on either
side of the burner located beneath the grill plate running front to rear of
the unit.
Burner details cast bar type x
2 2 rows of ports x 2.50mm x 7mm centers, 60 per side
Flame length 430mm x 100mm width
Cross Light Slot x 2.5mm with under slung venture
Overall length 231mm from primary air entry
Primary Air Opening Ø 43mm
Grill Plate Cast Iron 600mm(L) / 900mm(L) /1200mm(L) x 500mm(W) x 20mm
(Thick)
Burner Supports Venture end supported off injector holder attached to bracket off angle
iron frame. Support for burner at end by angle iron bar.
Grilling or Toasting Is by means of cast inverted grids which glow when heated and heat is
radiated to the products beneath the grid.
Grease Collection Box
Beneath Grill Plate
Drip Tray (Located in Base
of Grilling Compartment) As hot plate long x 105mm(W) x 30mm(Depth)
Secondary air to Grill
Burners Induced to burners through front opening of grill compartment
Primary air Control to Grill
Burners Is by means of a rotating air shutter x Ø20mm with a locating hole for
centering injector into burner
Heating of the Grill Plate Is by the burners (every 300mm) located beneath the grill plate serving
the grill compartment
Ignition to Pilot Burners Spark igniter adjacent to burner is by means of piezo press button
located on front panel or you can manual lighting at under cast plate
Gas cock knobs Indicate ‘Off’, ‘Hi’, ‘Lo’
Injectors 12.7mm hexagon 25.4mm(L) x Ø11mm Nozz 15mm long with 3mm
B.S.P. thread x 6mm long
Regulator Natural Gas Maxitrol RV48m-66. App. No. 3088
