TTS Talk-Tracker Manuel utilisateur
™
User Guide
Version 6
Please Read All Instructions Carefully Before Using
Talk-Tracker User Guide
2
Please retain these instructions for future reference
Talk-Tracker contains a non-replaceable,
rechargeable battery
Do not attempt to remove the battery
Do not allow your Talk-Tracker to come into
contact with water or other liquids
In the event of an electro-static discharge, your
Talk-Tracker may malfunction. In this case, you may
need to connect to a computer to reset it
Warranty is void if the case is opened for any reason
The warranty does not cover any data loss from the
unit nor any consequential loss of information
FCC compliance
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR
ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID
THE USER AUTHORITY TO OPERATE THE
EQUIPMENT
Talk-Tracker User Guide
3
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help
Talk-Tracker User Guide
4
Know your Talk-Tracker
Red „Record‟
Button
LCD Screen
Built-in Speaker
4-way Rocker
Switch
Green „Play‟
Button
Microphones on
All four corners
Menu
Button
On-Off Switch
Talk-Tracker User Guide
5
Talk-Tracker controls
There are two sets of controls which are used to control
the Talk-Tracker, The Record and Play Buttons and the
4 way switch and menu button
Next
Status area
Menu key
Selection
area
LCD Screen
Vol +
Vol -
Prev
On/Off
Status
LED
Rec
Play
Talk-Tracker User Guide
6
Recording & Playing your First Track
Switch on the Talk-Tracker by sliding the On-Off
switch until the Status LED lights Orange (steady or
flashing), indicating it is waiting in standby
Press and release the Record button (Red ring). After a
second or so, the Status LED will change to Red
indicating it is recording
The recording can be paused at any time by pressing
the Record button briefly. The Status LED will flash
to show the recording has been paused. Simply press
the Record button again to continue recording
When you are finished Recording, press the Record
button, and hold for 2 seconds, to stop the recording
and save it as the last track. The Status LED will
change to Orange (steady or flashing)
Alternatively you can press and hold the Record
button during the whole of the recording and release it
when you have finished recording
Press the Play button (Green ring) to play your track.
The Status LED will light Green while the track is
playing
When the track is finished, Talk-Tracker will return to
standby and the Status LED will be Orange
Talk-Tracker User Guide
7
The Talk-Tracker will not store recordings of less than
2 seconds, so ensure you record for longer than this
Please note that the Talk-Tracker can only store a
maximum of sixty two tracks, regardless of the length
of track.
Recording & Playback Modes
Talk-Tracker can record and playback files in two
formats: MP3 or WAV files. Depending on your
application, you may want to use one of these formats
rather than another. For instance, much podcasting is
done using MP3 files so this would be the best format if
you wanted to make podcasts. For information on
recording lengths for both formats see page 15.
.
Status LED
The Status LED provides you with a clear indication of
what is happening with your Talk-Tracker. Please take
note of the following information so that you can get
the best results.
Flashing Orange: Ready to Play/Record MP3 file
Steady Orange: Ready to Play/Record WAV file
Steady Green: Playing (or fully charged)
Talk-Tracker User Guide
8
Flashing Green: Playing Paused
Steady Red: Recording
Flashing Red: Recording Paused
Flashing Red/Green: Charging
Flashing Orange/Green: Battery low
Pausing or Stopping a Track
Press the Play button (Green ring) to play a track. The
Status LED will shine steady Green
Press the Play button again to pause the track at the
current place. The status LED will flash Green
Press the Play button again to resume playback
To stop a playing track completely, press and hold the
Play button for 2 seconds
Fast Forward & Reverse
While a track is Playing or Paused…
Press and hold the Prev(ious) or Next track button on
the 4-way rocker switch
The Status LED will flash Green and will move within
the current track at a fast rate
Talk-Tracker User Guide
9
When the button is released, Play or Pause will
continue at the new position within the track
The Play position will not pass beyond the start or end
of the current track
Moving Between Tracks
While a track is Playing or Paused…
Press the Prev(ious) or Next track button on the
4-way rocker to move to the selected track
Charging the Battery
Talk-Tracker is supplied with a partially charged battery
and can be used immediately without charging first. The
battery can be charged by connecting to the USB port of
an active computer or the charger. No software is
required:
Connect Talk-Tracker to the USB port or charger
The Status LED will flash Red and Green (or Orange
if connected to the separate charger)
When Talk-Tracker is fully charged the Status LED
will change to steady Green
A complete charge of a fully discharged battery will
take about 4 hours
Talk-Tracker User Guide
10
Using the Menu System
The LCD on the Talk-Tracker provides a multi-level
menu system that allows you to select certain
configurations, manage the sound files and select
recording and playback functions.
The display comprises two separate parts: the status area
at the top in Yellow and the selection area at the bottom
in Blue.
Standby Screen
The Standby screen is the
first screen shown when
the Talk-Tracker is
switched on. The status
shown here is:
active track is number 1 out of 7 tracks
repeat mode setting is repeat
record/playback mode is MP3
volume is set to 17
battery is fully charged
Autres manuels pour Talk-Tracker
1
Table des matières
Autres manuels TTS Équipement d'enregistrement
Manuels Équipement d'enregistrement populaires d'autres marques
Strymon
Strymon NIGHTSKY Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manuel utilisateur
Tews Technologies
Tews Technologies TPMC465 Manuel utilisateur
Honeywell
Honeywell Excel 50 Manuel utilisateur
SeaLevel
SeaLevel COMM+8.LPCI Manuel utilisateur
Arturia
Arturia AUDIOFUSE STUDIO Manuel utilisateur
