Change selector switch to “ ” position. Turn the speed switch to “1” position or
“2”position you like, take hold of #7 handle located at the end of head lever and
press the button. The blade will now start turning, position the blade carefully on
the piece to be cut. Then increase the pressure in order to accelerate the cutting
operation without using excessive force.
C. Automatic operation: Clamp the material to be cut with #2 Handle bar after having
positioned the clamp near the piece to be cut. Press main switch to “ON”position,
Change selector switch to “ ” position. Turn the speed switch to “1” position or
“2”position you like, after having started the unit by pressing the START push
button, the blade starts to rotate. The down stroke of the bow can be adjusted by
means of the appropriate regulator. Position the blade carefully on the piece to be
cut. Then increase the pressure with the regulator in order to accelerate the cutting
operation without using excessive force.
D. To make a series of cuts, position the bar stop in correspondence of the size
required. Fix it into position by using #19 Baffle block.
We strongly discourage the use of blades with ruined or insufficiently sharp
cutting edges
6.3 Special safety checks
A. Before using the machine, check carefully that the safety devices are in good
working order, that the mobile parts are not blocked, that no parts are damaged
and that all the components are installed correctly and are functioning properly.
B. Before operating the machine, make sure that the screws of the guards and other
protective devices are adequately secured, especially the screws of bow guard.
C. Check that the safety micro switches and the emergency button are functioning
correctly.
D. Make sure that the mobile guard does not leave uncovered an angle of more than
5°in order to prevent fingers from entering.
E. Pay attention to environmental conditions. Don’t expose the machine to rain, don’t
use it in damp environments, position the machine on a clean dry floor that has no
oil or grease stains.
F. Before using the machine, the operator should make sure that all tools and service
spanners used for maintenance or adjustment have been removed.
6.4 Measures to prevent residual risks
A. The removal of guards and tampering with the safety devices is strictly forbidden.
B. Gloves should always be worn.
