TSI Instruments DUSTTRAK 854060 Manuel utilisateur
DUSTTRAK™AEROSOL MONITOR
SOLAR POWER KIT
MODEL 854060
(USED FOR POWERING ENVIRONMENTAL ENCLOSURE MODELS
MODELS 854030, 8535 AND 8537)
OPERATION AND MAINTENANCE MANUAL
P/N 6008416, REVISION C
JUNE 2017
i
Copyright©
TSI Incorporated / 2015–2017 / All rights reserved.
Part Number
6008416A / Revision C / June 2017
Address
TSI Incorporated / 500 Cardigan Road / Shoreview, MN 55126 / USA
Fax No.
(651) 490-3824
LIMITATION OF WARRANTY AND LIABILITY (effective February 2015)
(For country-specific terms and conditions outside of the USA, please visit www.tsi.com.)
Seller warrants the goods, excluding software sold hereunder, under normal use and
service as described in the operator's manual, shall be free from defects in workmanship
and material for twenty-four (24) months, or if less, the length of time specified in the
operator's manual, from the date of shipment to the customer. This warranty period is
inclusive of any statutory warranty. This limited warranty is subject to the following
exclusions and exceptions:
a. Hot-wire or hot-film sensors used with research anemometers, and certain other
components when indicated in specifications, are warranted for 90 days from the
date of shipment;
b. DustTrak internal pump for Models 8530 and 8533 is warranted for two (2) years or
4000 hours, whichever comes first;
c. DustTrak External pump for Models 8530EP and 8533EP is warranted for two (2)
years or 8760 hours, whichever comes first;
d. Environmental DustTrak pump for Models 8540 and 8543 is warranted for two (2)
years or 8760 hours, whichever comes first;
e. Parts repaired or replaced as a result of repair services are warranted to be free from
defects in workmanship and material, under normal use, for 90 days from the date of
shipment;
f. Seller does not provide any warranty on finished goods manufactured by others or on
any fuses, batteries or other consumable materials. Only the original manufacturer's
warranty applies;
g. This warranty does not cover calibration requirements, and seller warrants only that
the instrument or product is properly calibrated at the time of its manufacture.
Instruments returned for calibration are not covered by this warranty;
h. This warranty is VOID if the instrument is opened by anyone other than a factory
authorized service center with the one exception where requirements set forth in the
manual allow an operator to replace consumables or perform recommended
cleaning;
i. This warranty is VOID if the product has been misused, neglected, subjected to
accidental or intentional damage, or is not properly installed, maintained, or cleaned
according to the requirements of the manual. Unless specifically authorized in a
separate writing by Seller, Seller makes no warranty with respect to, and shall have
no liability in connection with, goods which are incorporated into other products or
equipment, or which are modified by any person other than Seller.
The foregoing is IN LIEU OF all other warranties and is subject to the LIMITATIONS
stated herein. NO OTHER EXPRESS OR IMPLIED WARRANTY OF FITNESS FOR
PARTICULAR PURPOSE OR MERCHANTABILITY IS MADE. WITH RESPECT TO
SELLER’S BREACH OF THE IMPLIED WARRANTY AGAINST INFRINGEMENT, SAID
WARRANTY IS LIMITED TO CLAIMS OF DIRECT INFRINGEMENT AND EXCLUDES
CLAIMS OF CONTRIBUTORY OR INDUCED INFRINGEMENTS. BUYER’S
EXCLUSIVE REMEDY SHALL BE THE RETURN OF THE PURCHASE PRICE
DISCOUNTED FOR REASONABLE WEAR AND TEAR OR AT SELLER’S OPTION
REPLACEMENT OF THE GOODS WITH NON-INFRINGING GOODS.
ii
TO THE EXTENT PERMITTED BY LAW, THE EXCLUSIVE REMEDY OF THE USER OR
BUYER, AND THE LIMIT OF SELLER'S LIABILITY FOR ANY AND ALL LOSSES,
INJURIES, OR DAMAGES CONCERNING THE GOODS (INCLUDING CLAIMS BASED
ON CONTRACT, NEGLIGENCE, TORT, STRICT LIABILITY OR OTHERWISE) SHALL
BE THE RETURN OF GOODS TO SELLER AND THE REFUND OF THE PURCHASE
PRICE, OR, AT THE OPTION OF SELLER, THE REPAIR OR REPLACEMENT OF THE
GOODS. IN THE CASE OF SOFTWARE, SELLER WILL REPAIR OR REPLACE
DEFECTIVE SOFTWARE OR IF UNABLE TO DO SO, WILL REFUND THE PURCHASE
PRICE OF THE SOFTWARE. IN NO EVENT SHALL SELLER BE LIABLE FOR LOST
PROFITS, BUSINESS INTERRUPTION, OR ANY SPECIAL, INDIRECT,
CONSEQUENTIAL OR INCIDENTAL DAMAGES. SELLER SHALL NOT BE
RESPONSIBLE FOR INSTALLATION, DISMANTLING OR REINSTALLATION COSTS
OR CHARGES. No Action, regardless of form, may be brought against Seller more than
12 months after a cause of action has accrued. The goods returned under warranty to
Seller's factory shall be at Buyer's risk of loss, and will be returned, if at all, at Seller's risk
of loss.
Buyer and all users are deemed to have accepted this LIMITATION OF WARRANTY AND
LIABILITY, which contains the complete and exclusive limited warranty of Seller. This
LIMITATION OF WARRANTY AND LIABILITY may not be amended, modified or its terms
waived, except by writing signed by an Officer of Seller.
Service Policy
Knowing that inoperative or defective instruments are as detrimental to TSI as they are
to our customers, our service policy is designed to give prompt attention to any
problems. If any malfunction is discovered, please contact your nearest sales office or
representative, or call TSI's Customer Service department at (800) 874-2811 (USA) or
(001 651) 490-2811 (International) or visit www.tsi.com.
Trademarks
DustTrak™ is a trademark of TSI Incorporated.
1
Contents
Contents.............................................................................................. 1
Safety Information ............................................................................. 2
Description of Caution/Warning Symbols ................................................ 3
Caution and Warning Symbols................................................................ 3
Reusing and Recycling............................................................................ 4
Product Overview .............................................................................. 4
Setting Up ........................................................................................... 4
Operation ..........................................................................................21
Overview ............................................................................................... 21
Specifications................................................................................... 22
2 DustTrak Aerosol Monitor Solar Power Kit Model 854060
Safety Information
W A R N I N G S
Use of components other than those specified by
TSI may impair the safety features provided by
the equipment.
The instrument has been design to be used with
batteries supplied by TSI. Do not use a substitute
Old batteries must be properly recycled in
accordance with the local environmental
regulations.
Do not use non-rechargeable batteries in this
instrument. Fire, explosions, or other hazards
may result.
If the solar power kit is used in a manner not
specified by the manufacturer, the protection
provided by the equipment may be impaired.
Do not connect the Solar Panels directly to the
854030 Environmental Enclosure as this may
result in damage. The Solar Panels must be
connected to the Solar Battery Enclosure Box so
they can be regulated by the Solar Charge
Controller.
C a u t i o n
The enclosure is designed to be water resistant to
rain or spray. It has a NEMA rating of 3R. It is not
designed to be waterproof when immersed. Setting
it in a pool of water will result in flooding the inner
compartment with water. This will severely damage
the battery pack. Do NOT set the Battery Enclosure
in water!
Operation and Maintenance Manual 3
Description of Caution/Warning Symbols
Appropriate caution/warning statements are used throughout the
manual and on the instrument that require you to take cautionary
measures when working with the instrument.
Caution
C a u t i o n
Failure to follow the procedures prescribed in this
manual might result in irreparable equipment
damage. Important information about the operation
and maintenance of this instrument is included in
this manual.
Warning
W A R N I N G
Warning means that unsafe use of the instrument
could result in serious injury to you or cause
damage to the instrument. Follow the procedures
prescribed.
Caution and Warning Symbols
The following symbols may accompany cautions and warnings to
indicate the nature and consequences of hazards:
Warns that the instrument contains a laser and that
important information about its safe operation and
maintenance is included in the manual.
Warns that the instrument is susceptible to electro-
static discharge (ESD) and ESD protection should
be followed to avoid damage.
Indicates the connector is connected to earth
ground and cabinet ground.
4 DustTrak Aerosol Monitor Solar Power Kit Model 854060
Reusing and Recycling
As part of TSI Incorporated’s effort to have a minimal
negative impact on the communities in which its
products are manufactured and used:
Do not dispose of used batteries in the trash.
Follow local environmental requirements for
battery recycling.
If instrument becomes obsolete, return to TSI for
disassembly and recycling.
Product Overview
The solar power kit provides power to allow continuous monitoring of
Model 854030 Environmental Enclosure.
Setting Up
W A R N I N G
Refer to Solar charger manual for further installation
and operation instructions.
The setup of the Environmental Enclosure is an important part in
allowing reliable and accurate sampling of aerosols in a wide range of
conditions. TSI cannot ensure accurate measurements if any of the
components are set up incorrectly. Failure to follow these procedures
could result in damage to the enclosure or its components.
NOTE
Prior to using the Battery Pack for the first time, a full
recharge is recommended. Recharging Battery Pack(s)
immediately after use (within one hour maximum) is
critical to obtaining optimal recharge time, battery
health, and battery life.
Operation and Maintenance Manual 5
The full Solar Power System is shown in Figure 1. The following
section details the setup of this system.
I m p o r t a n t
Make all Solar Panel Power System electrical connections
in the order outlined below. Damage to the system can
occur if connections are not made in this order.
Figure 1: Solar Panel Power System
1. Remove the Solar Battery from its packaging and place it in the
Solar Battery Enclosure. Make sure that the battery positive (+)
terminal is on the right (the positive terminal is noted on the
battery with a RED marking).
2. Remove the battery terminals using an adjustable wrench and
connect the ring terminal ended wires from the solar charge
controller to the battery terminals (see Figure 2).
Note
There are two wires coming from the charge controller:
one is BLACK and is labeled (+); the other is WHITE and
is labeled (–).
The BLACK (+) wire should be connected to the battery
positive (+) terminal, which has a red marking on the top
of the battery.
The WHITE (–)wire should be connected to the battery
negative (–)terminal.
6 DustTrak Aerosol Monitor Solar Power Kit Model 854060
Figure 2: Install the Solar Battery and Connect to Controller
3. The next step is to attach the two power cables (see Figure 3) to
each Solar Panel.
Figure 3: Attach Power Cables
Autres manuels pour DUSTTRAK 854060
1
Table des matières
